Supplier:
Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106
Telephone: 1-87-Permatex
(877) 376-2839
Material Safety Data Sheet
1. PRODUCT IDENTIFICATION
Product Name: SUPER GLUE 2G
Item No: 82190
Product Type: Cyanoacrylate ester
2. COMPOSITION/INFORMATION ON INGREDIENTS
Ingredients Percent ACGIH 8 Hr. TWA: OSHA 8 Hr. TWA:
ETHYL CYANOACRYLATE 90-100 0.2 ppm TWA
7085-85-0
POLY (METHYL METHACRYLATE) 1-10
9011-14-7
1,4-DIHYDROXYBENZENE 0.1-0.5 2 mg/m3 TWA 2 mg/m3 TWA
123-31-9
3. HAZARDS IDENTIFICATION
Skin contact may cause burns. Bonds skin rapidly and strongly. Causes eye irritation. Irritates
Toxicity:
mucous membranes.
Eye and skin contact, ingestion, inhalation.
Primary Routes of Entry:
Vapor is irritating to eyes and mucous membranes above TLV. Prolonged and repeated overexposure
Signs and Symptoms of Exposure:
to vapors may produce symptoms of non-allergic asthma in sensitive individuals.
ACGIH Carcinogens IARC:
Ingredients Percent NTP:
POLY (METHYL METHACRYLATE) 1-10 Group 3 Vol. 19, pg 187;
9011-14-7 1979
1,4-DIHYDROXYBENZENE 0.1-0.5 male rat-some evidence; A3 - Animal Carcinogen Group 3 Vol. 71, pg 691; 1999
123-31-9 female rat-some evidence;
male mice-no evidence;
female mice-some evidence
Medical Conditions Recognized as Being None known
Aggravated by Exposure:
4. FIRST AID MEASURES
Ingestion is not likely. The adhesive solidifies and adheres in the mouth. If lips are accidentally stuck
Ingestion:
together, apply lots of warm water to the lips and encourage maximum wetting and pressure from
saliva inside the mouth. Peel or roll lips apart. Do not try to pull the lips with direct opposing action.
Saliva will lift the adhesive in one half to two days.
If inhaled, remove to fresh air. If not breathing give artificial respiration, preferably mouth-to-mouth. If
Inhalation:
breathing is difficult give oxygen. Get medical attention.
Remove excess adhesive. Soak in warm, soapy water. The adhesive will come loose from the skin in
Skin Contact:
several hours. Cured adhesive does not present a health hazard even when bonded to the skin. For
skin adhesion, first immerse the bonded surfaces in warm, soapy water. Peel or roll the surfaces
apart with the aid of a blunt edge, e.g., spatula or teaspoon handle; then remove adhesive from the
skin with soap and water. Do not try to pull surfaces apart with a direct opposing action.
Cyanoacrylates give off heat on solidification. In rare cases, a large drop will increase in temperature
enough to cause a burn. Burns should be treated normally after the lump of cyanoacrylate is released
from the tissue as described above.
Page 1 of 3
Product Name: SUPER GLUE 2G
Item No: 82190
In the event that eyelids are stuck together or bonded to the eyeball, wash thoroughly with warm
Eye Contact:
water and apply a gauze patch. The eye will open without further action, typically in 1-4 days. There
will be no residual damage. Do not try to open the eyes by manipulation. If cyanoacrylate is
introduced into the eyes, it will attach to the eye protein and will disassociate from it over intermittent
periods, generally several hours. This will cause periods of weeping until clearance is achieved.
During this period, double vision may be experienced together with a lachrymatory effect, and it is
important to understand the cause and realize that disassociation will normally occur within a matter
of hours, even with gross contamination.
5. FIRE FIGHTING MEASURES
185 degrees F. Method: Tag Closed Cup
Flash Point (掳F/C):
Carbon Dioxide, Dry Chemicals, Foam.
Recommended Extinguishing Media:
Firefighters should wear self-contained breathing apparatus.
Special Fire-Fighting Procedures:
Irritating vapors.
Hazardous Products Formed by Fire or
Thermal Decomposition:
May polymerize exothermically.
Unusual Fire/Explosion Hazards:
Not determined.
Lower Explosive Limit:
Not determined.
Upper Explosive Limit:
6. ACCIDENTAL RELEASE MEASURES
Flood with water to polymerize. Maintain good ventilation. Take up with an inert absorbent. Store in a
Spill Procedures:
closed waste container until disposal.
7. HANDLING AND STORAGE
Store below 75 degrees F.
Storage:
Avoid contact with skin and eyes. Do not inhale vapors. Keep container closed when not in use.
Handling:
Wash hands before eating and smoking.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Safety glasses or goggles.
Eyes:
Nitrile coated apron or clothing. Do not use cotton. Polyethylene or rubber gloves
Skin:
Positive down-draft exhaust ventilation should be provided to maintain vapor concentrations below
Ventilation:
TLV.
An approved respirator (i.e. NIOSH, etc.) should be worn when exposures are expected to exceed the
Respiratory Protection:
applicable limits.
9. PHYSICAL AND CHEMICAL PROPERTIES
Clear liquid
Appearance:
SHARP/IRRITATING
Odor:
More than 300 degrees F.
Boiling Point (掳F):
Does not apply
pH:
Polymerized
Solubility in Water:
1.06
Specific Gravity:
81.0% by weight
VOC Content(Wt.%):
Less than 0.2 mm Hg
Vapor Pressure:
Approximately 3
Vapor Density (Air=1):
Not Determined
Evaporation Rate:
10. STABILITY AND REACTIVITY
Stable at normal conditions
Chemical Stability:
MAY OCCUR Hazardous polymerization may occur if over-catalyzed or insufficiently aerated after
Hazardous Polymerization:
catalyzation. This polymerization is exothermic.
Polymerized by contact with water, alcohols, amines or alkalies.
Incompatabilities:
Avoid contact with clothes, fabrics, rags or tissue. Contact with these material may cause
Conditions to Avoid:
polymerization.
Irritating vapors.
Hazardous Products Formed by Fire or
Thermal Decomposition:
11. TOXICOLOGICAL INFORMATION
Page 2 of 3
Product Name: SUPER GLUE 2G
Item No: 82190
See Section 3
12. ECOLOGICAL INFORMATION
No data available
13. DISPOSAL CONSIDERATIONS
Disposal should be made in accordance with federal, state and local regulations.
Recommended Method of Disposal:
NH - Not a RCRA Hazardous Waste Material
US EPA Waste Number:
14. TRANSPORT INFORMATION
DOT (49CFR 172)
Domestic Ground Transport
DOT Shipping Name: Unrestricted
Hazard Class: NONE
UN/ID Number: None
Marine Pollutant: None
IATA
Proper Shipping Name: Unrestricted
Class or Division: None
UN/NA Number: NONE
IMDG
Proper Shipping: Unrestricted
Hazard Class: None
UN Number: None
15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA Section 313 Toxic Chemical.
NONE
CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present.
TSCA Inventory Status:
All components of this product are listed (or exempt) on the EPA TSCA inventory.
16. OTHER INFORMATION
HEALTH 2, FLAMMABILITY 2 , REACTIVITY 1
Estimated NFPA Rating:
HEALTH 2, FLAMMABILITY 2, PHYSICAL HAZARD 0
Estimated HMIS Classification:
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.
Prepared By: Denise Boyd Health and Safety Manager
Company: Permatex. Inc. 10 Columbus Blvd. Hartford, CT 06106
Telephone Number: 1-87-Permatex (877) 376-2839
06/06/2002
Revision Date:
0
Revision Number:
Page 3 of 3
|