MSDS
Product: DA-2611
Page 1 of 3
MATERIAL SAFETY DATA SHEET
1. CHEMICAL PRODUCT AND COMPANY INFORMATION
Product Name: DA-2611 (Antipolymerant)
2. COMPOSITION / INFORMATION ON INGREDIENTS
Component Name %Range
Proprietary blend of Caprolactum Derivative 98-100%
3. HAZARDS IDENTIFICATION
Emergency Overview
Spills of this product are very slippery.
Direct contact with this material may cause minimal eye and skin irritation.
Form: Liquid
Primary Routes of Exposure:
Skin Contact: May cause mild to moderate skin irritation and dermatitis on prolonged contact.
Eye Contact: Contact with eyes may cause moderate irritation and mild but reversible eye injury.
Ingestion: May cause gastrointestinal distress with nausea, vomiting and diarrhoea.
Inhalation: Not expected to be a problem under normal conditions of use.
Carcinogenicity Classification:
International Agency for Research on Cancer (IARC): Not classified
U.S. National Toxicology Program (NTP): Not classified
U.S. Occupational Safety and Health Administration (OSHA): Not classified
American Conference of Governmental Industrial Hygenists (ACGIH): Not classified
4. FIRST AID MEASURES
Eye Contact: In case of eye contact, immediately irrigate with plenty of water for 15 minutes.
Skin Contact: In case of skin contact, wash affected areas of the skin with soap and water.
After inhalation: Material is not expected to be a problem under normal conditions of use.
After ingestion:
Notes to physician: Symptomatic treatment is advised.
5. FIRE FIGHTING MEASURES
Flash Point: > 65 0C
Suitable extinguishing media: Not Applicable
Unsuitable extinguishing media: Not Applicable
Fire and explosion hazards: Not Applicable
Special protective equipment: Use a self-contained breathing apparatus with full-face piece operated in pressure demand or
other positive pressure mode.
6. ACCIDENTAL RELEASE MEASURES
Personal protection: Avoid contact with skin. After contact with skin, wash immediately with plenty of soap and water.
Environmental precautions: Prevent contamination of soil, drains and surface waters.
Clean-up: Spilled material should be absorbed onto an inert material and scooped up. Wear impermeable boots. Flush spill area
with water.
7. HANDLING AND STORAGE
Handling: When handling the material good hygiene practices should be observed. Avoid prolonged and repeated exposure.
Storage: The drums should be stored, with their seals intact, in conditions that avoid extremes of temperatures. Under the above
conditions the shelf life of the product would be approx. 2 years.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering measures: No special safety measures required.
Personal protection equipment: Chemical resistant gloves and chemical goggles should be used to prevent skin and eye
contact.
Eye protection: Wear suitable goggles or face mask.
MSDS
Product: DA-2611
Page 2 of 3
Hand protection: Wear suitable gloves.
Skin and body protection: Wear impermeable gloves.
Respiratory protection: Respirator use is not expected to be necessary under normal conditions of handling. In emergency
situations, use of an approved respirator may be required.
9. TYPICAL PHYSICAL AND CHEMICAL PROPERTIES
These data do not represent technical or sales specification
Form : Liquid
Odor : Not Distinct
pH : 12 - 14
Bulk density : NA
0
Flash Point : > 65 C
Vapour pressure : Similar to water
: 1.0 鈥? 1.3 @ 15.6 掳C
Relative density/Sp. Gr.
Vapour density : NA
Viscosity : 30- 45 cSt at 15.6掳C
Water solubility : Complete
Solubility : ND
Abbreviations: N.D. 鈥? Not Determined
N.A. - Not Applicable
10. STABILITY
Stability: Stable under normal conditions of storage and use.
Hazardous decomposition products: Carbon Monoxide, Carbon dioxide, oxides of nitrogen.
Conditions/Materials to avoid: None known.
11. TOXICOLOGICAL INFORMATION
Acute Toxicity: LD50/oral/rat : NA
LD50/dermal/rabbit : NA LC50/inhalation/rat : NA
Chronic toxicity:
EC Carcinogenic: Not listed EC Mutagenic: Not listed
EC Toxic for Reproduction: Not listed Carcinogenicity (ACGIH): Not listed
IARC classification: Not listed
Routes of exposure: skin, eyes and inhalation
Irritation:
Skin(rabbit): minimal Eye (rabbit): minimal
Additional product information: None
Additional component information: None
12. ECOLOGICAL INFORMATION
Environmental data has not been generated on this product, but experience with products of similar composition would indicate
that it would be toxic to aquatic organisms.
Liability is expressly disclaimed for any loss or injury arising out of the use of this information or the use of any materials
designated.
13. DISPOSAL CONSIDERATIONS
Provisions relating to waste: The information on RCRA waste classification and disposal methodology provided below applies
only to the Dorf Ketal product, as supplied. If the material has been altered or contaminated, or it has exceeded its recommended
shelf life, the guidance may be inapplicable. Hazardous waste classification under federal regulations (40 CFR Part 261 et seq) is
dependent upon whether a material is a RCRA 鈥渓isted hazardous waste鈥? or has any of the four RCRA 鈥? hazardous waste
characteristics鈥?. Refer to 40 CFR Part 261.33 to determine if a given material to be disposed of is a RCRA 鈥? listed hazardous
waste鈥?; information contained in Section 15 of this MSDS is not intended to indicate if the product is a 鈥? listed hazardous waste.
鈥漅CRA鈥? Hazardous Waste Characteristic. There are four characteristics defined in 40 CFR Section 261. 21-61. 24: Ignitability,
Corrosivity, Reactivity and Toxicity. To determine Ignitability, see Section 9 of this MSDS (flash point). For Corrosivity, see
Sections 9 and 14 (pH and DOT corrosivity). For reactivity, see Section 10 (incompatible materials). For toxicity, see Section
1(composition). Federal regulations are subject to change. State and local requirements, which may differ from or be more
stringent than the federal regulations, may also apply to the classification of the material if it is to be disposed. Dorf Ketal
encourages the recycle, recovery and reuse of materials, where permitted, as an alternate to disposal as a waste. Dorf Ketal
recommends that organic materials classified as RCRA hazardous wastes be disposed of by thermal treatment or incineration at
MSDS
Product: DA-2611
Page 3 of 3
EPA approved facilities. Dorf Ketal has provided foregoing information only; the person generating waste is responsible for
determining the waste classification and disposal method.
Disposal information: Place chemical residues and contaminated adsorbent materials into suitable waste container and take to
an approved waste disposal site. Dispose of all residues in accordance with applicable waste management regulations.
14. TRANSPORT INFORMATION
Proper shipping name: Not Applicable/Not regulated
UN-No.: Not Applicable/Not regulated
U.S.DOT: Not Applicable/Not regulated
IMO: Not Applicable/Not regulated
ICAO-IATA: Not Applicable/Not regulated
Further Information: Not Applicable/Not regulated
15. REGULATORY INFORMATION
US TSCA: This product is manufactured in compliance with all provisions of the Toxic Control Act, 15 U.S.C. 2601 et. Seq.
16. OTHER INFORMATION
HEALTH: 0 FLAMMABILITY: 0 REACTIVITY: 0
For additional information concerning this product, contact the following:
PRODUCT EMERGENCIES
Dorf Ketal Chemicals (I) Pvt. Ltd. Dorf Ketal LLC
#1 DORF KETAL TOWERS. 3727 Greenbriar
D鈥橫onte Street, Marve Road. Suite 114,
Malad (W).Bombay 64. Stafford, TX 77477
Tel: +91-22-28813654 / +91-22-28828374. Tel : 281 491 3700
Fax: +91-22-28882366 Fax : 281 491 3700
The data and recommendations presented in this data sheet concerning the use of our product and the materials contain there in are believed to be
accurate and are based on information which is considered reliable as of the date hereof. However, the customer should determine the suitability of
such material for his purpose before adopting them on a commercial scale. Since the use our products by others is beyond our control, no
guarantee, express or implied, is made and no responsibility assumed for the use of this material or the results to be obtained there from.
Information on this form is furnished for the purpose of compliance with Government Health and Safety Regulations and shall not be used for any
other purposes. Moreover, the recommendations contained in this data sheet are not to be constructed as a license to operate under, or a
recommendation to infringe, any existing patents, nor should they be confused with state, municipal or insurance requirements, or with national
safety codes.
END OF MSDS
|