Monday, May 22, 2006
Page 1 of 4
MSDS - Material Safety Data Sheet
Product Name: NinhydrinHT Pump Spray for Heat-Transfer Papers
MSDS No.: NHT609
I. Basic Information:
Manufacturer: Sirchie Finger Print Laboratories
0
Address: 100 Hunter Place
City, ST Zip: Youngsville, NC 27596
1 0
Emergency Contact: CHEMTREC
Emergency Telephone Number: 800-424-9300
Contact: Tech Support
Information Telephone Number: 919-554-2244
1
0
Last Update: 2-21-2008 Expiration Date:
0
X Liquid Gas Solid
Chemical State:
B
Pure Mixture
Chemical Type: X
II. Ingredients:
Trade Secret
EHS IARC SARA
313 OSHA ACGIH Other
% Range NTP SUB Z PEL TLV Limits
CAS No. Chemical Name
67630 Isopropanol 4-6 400ppm 400ppm
163702076 Methyl nonafluorobutyl ether 30-50
163702087 Methyl nonafluoroisobutyl Ether 50-70
485472 Ninhydrin Trace NE NE 255 C
III. Hazardous Identification:
Hazard Category:
Acute Chronic Fire Pressure Reactive
Hazardous Identification Information:
May be harmful if inhaled. Respiratory and digestive tract irritant. Skin and eye irritant.
IV. First Aid Measures:
Route(s) of Entry:
Inhalation, ingestion, skin, eyes
Health Hazards (Acute and Chronic):
Eye, skin, gastrointestinal and respiratory irritant
Signs and Symptoms:
Eye, skin, gastrointestinal and respiratory irritant
Medical Conditions Generally Aggravated by Exposure:
Skin, eye, liver, kidney, heart, respiratory, central nervous system, cardiovascular system diseases
Monday, May 22, 2006
Page 2 of 4
MSDS - Material Safety Data Sheet
Product Name: NinhydrinHT Pump Spray for Heat-Transfer Papers
MSDS No.: NHT609
Emergency and First Aid Procedures:
Inhalation: Remove to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen (To be
administered by qualified medical personnel only!) Get medical attention.
Ingestion: DO NOT induce vomiting. If victim is conscious and alert, give 2-4 cups of water. (Never give anything by mouth to an
unconscious person!) Aspiration hazard. If vomiting does occur, have victim lean forward to reduce the risk of aspiration. Get
medical attention.
Skin: Flush skin with plenty of soap and water for at least 15 minutes. Remove contaminated clothing. Seek medical attention.
Eyes: Flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower lids. Do not allow victim to
rub or keep eyes closed. Get medical aid.
Other Health Warnings:
V. Fire Fighting Measures:
Flash Point: NE Lower Explosive Limit: NE Upper Explosive Limit: NE
F.P. Method:
Fire Extinguishing Media: Fight fire based on surrounding materials.
Special Fire Fighting Procedures:
Wear self-contained breathing apparatus and protective clothing. Water may be used to cool fire-exposed containers. DO NOT
use straight streams of water. Cool containers with flooding amounts of water until well after fire is out.
Unusual Fire and Explosion:
Containers may rupture under fire conditions.
VI. Accidental Release Measures:
Steps to be Taken in Case Material is Released or Spilled:
Wear vapor respirator, safety goggles, and rubber gloves. Remove sources of ignition (i.e. open flames, sparks). Stop leak at
source. Dike area. Soak up with inert absorbent material (sand, oil dry, earth, vermiculite, or floor absorbent recommended.
VII. Handling and Storage:
Precautions to be Taken:
Keep in tightly closed container. Do not store above 125 F. Keep cool and dry. Avoid ingestion and inhalation. Wash thoroughly
after handling.
Other Precautions:
"Empty" containers may contain product residue and may be dangerous. Empty containers should be completely drained and
bunged and then disposed of according to local, state, and federal regulations.
VIII. Exposure Controls/Personal Protection:
Ventilation Requirements:
Use only in well-ventilated areas.
Personal Protective Equipment:
Safety goggles and gloves.
Monday, May 22, 2006
Page 3 of 4
MSDS - Material Safety Data Sheet
Product Name: NinhydrinHT Pump Spray for Heat-Transfer Papers
MSDS No.: NHT609
IX. Physical and Chemical Properties:
Boiling Point: 54 C Melting Point: NE
Evaporation Rate (Butyl Acetate = 1): NE Vapor Pressure (mm Hg.): 207mmHg
Specific Gravity (H20 = 1): Vapor Density (AIR = 1): 7.1
Solubility In Water: To be determined Appearance and Odor:
Other Information:
X. Stability and Reactivity:
Stability:
Normally stable.
Incompatibility (Materials to Avoid):
Strong acids, strong bases, strong oxidizing agents.
Decomposition/By Products:
Hydrogen fluoride, Perfluorinated Acid Fluorides, oxides of carbon
Hazardous Polymerization:
Has not been reported.
XI. Toxicological Information:
May be harmful if inhaled. May cause central nervous system depression. May suffocate if air is displaced by vapors.
XII. Ecological Information:
Ecological effects have not been fully investigated.
XIII. Disposal Considerations:
Dispose according to local, state, and federal regulations.
XIV. Transport Information:
Keep in tightly closed container.
XV. Regulatory Information:
Not regulated.
XVI. Other Information:
This product contains HFE-7100 3M Novec Engineered Fluid (methyly nonafluorisobutyl ether and methyl nonafluorobutyl ether).
The components of this material are in compliance with the chemical notification requirements of TSCA.
Using this product under normal, properly instructed procedures should not be hazardous.
Monday, May 22, 2006
Page 4 of 4
MSDS - Material Safety Data Sheet
Product Name: NinhydrinHT Pump Spray for Heat-Transfer Papers
MSDS No.: NHT609
The information above is believed to be accurate and represents the best information currently available to us. However, we make
no warranty of merchantability or any other warranty, expressed or implied, with respect to such information, and we assume no
liability resulting from its use. Users should make their own investigation to determine the suitability of the information for their
particular purposes.
|