MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: CR-5B
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
1. General Notes
This formulation is a trade secret and considered confidential and proprietary information of Team, Inc.
UND = Undetermined
NA = Not Applicable
2. Product Information
Product Part Number / Name: 800-0064 / CR-5B
Chemical Family: Polyurethane Resin
Product Use: Industrial Leak Sealant
Product Description: Catalyst
3. Hazardous Ingredients OSHA ACGIH OSHA ACGIH
PEL TLV PEL TLV Possible
Compound CAS Number Percent (mg/m3) (mg/m3) (ppm) (ppm) Carcinogen
dibutyl phthalate 84-74-2 25 - 50 5 5
Notes
4. Physical Data
Boiling Point (F): UND. Specific Gravity (H20 = 1): 1.02
Vapor Pressure (mm Hg): UND. Melting Point (F): UND.
Solubility in H20: UND. Evaporation Rate (Butyl Acetate = 1): <1
Appearance and Odor: Clear liquid
5. Fire and Explosion Hazard Information
Flash Point (Closed Cup) (F): 338
Flammability Limits in Air (%): Low: UND. High: UND.
Extinguishing Media: CO2, foam, dry powder, or halon.
Special Fire Fighting Procedures: None known.
Unusual Fire and Explosion None known.
6. Reactivity Data
Page 1 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: CR-5B
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
Stability: Stable.
Conditions to Avoid: None known.
Materials to Avoid: Strong oxidizing agents.
Hazardous Decomposition Products: None known.
Hazardous Polymerization: Will not occur.
7. Health Hazards
Routes of Entry:
Inhalation: Yes
Skin: Yes
Eyes: Yes
Ingestion: Yes
Acute Symtoms:
Inhalation: May cause headache and nausea.
Skin: May cause burns.
Eyes: May cause burns.
Ingestion: May cause stomach pain, nausea, and vomiting.
Carcinogenicity:
National Toxicology None.
IARC Monographs: None.
OSHA Regulated: None.
Chronic Symptoms: Skin and lung allergic reaction
Medical Conditions Aggravated: None known.
Page 2 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: CR-5B
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
1st Aid Procedures:
Inhalation: Immediately remove from contaminated area to fresh air. Let victim rest.
Obtain medical attention.
Skin: Thoroughly wash affected area with soap and water. Flush area with
water for 15 minutes. If irritation develops, obtain medical attention.
Eyes: Flush with water for at least 15 minutes. Obtain medical attention.
Ingestion: Rinse mouth vigorously and supply victim with 16 - 24 oz of water to drink.
Consult a physician.
8. Safe Handling / Disposal / Use
Releases or Spills: Cover spill with absorbent material. Remove from surface and place in
open container. Add equal parts of water to spill; mix until foaming begins,
allow material to cure for 48 hours in open area.
Disposal: After waste is fully cured, may be buried in landfill or incinerate in
accordance with federal, state, and local regulations. Uncured resin
should be disposed of by chemical incineration at an appropriate facility.
Ventilation: Use adequate ventilation.
Other Storage Precautions: Keep away from open flames. Avoid prolonged contact with skin. Store
containers upright in cool, dry location.
9. Control Measures
Respiratory Protection: If ventilation is poor, an NIOSH / MSHA supplied air in confined space is
recommended.
Ventilation: Local exhaust is usually adequate. If necessary use mechanical exhaust.
Hand Protection: Butyl rubber gloves are recommened.
Eye Protection: Safety goggles or glasses.
Other: Full cover clothing and rubber boots.
Hygienic Practices: Wash hands with soap and water.
10. Hazard Ratings
Page 3 of 4
MATERIAL SAFETY DATA SHEET (MSDS)
PRODUCT NAME: CR-5B
Team, Inc. Prepared By: James H. Varner
Team Industrial Services, Inc. Revision Date: July 1, 2006
TECO Manufacturing, Inc. Team Main: 281-331-6154
200 Hermann Drive 8 - 5 CDT: 281-388-5618
Alvin, Texas 77511 Answering Service: 281-482-3530
CHEMTREC: 800-424-9300
NFPA
Health: 3
Flammability: 1
Reactivity: 1
11. Additional Information
This data is offered in good faith as typical values and not as a product specification. No warranty, is
either expressed or implied. The recommended handling procedures are believed to be generally
applicable. However, each user should review these recommendations in the specific context of the
intended use.
End of Document
Page 4 of 4
|