MATERIAL SAFETY DATA SHEET
Combustion Modified Dyed Excelsior Page 1 of 6
Section 1 - CHEMICAL, PRODUCT AND COMPANY IDENTIFICATION
Manufacturer Information Corporate Office
Fiberex, Inc. American Excelsior Company
P.O. Box 3003 850 Avenue H East
Florence, AL 35630 Arlington, TX 76011
Office Phone #: (205) 764-4613 Office Phone #: (817) 385-3500
Chemical Name: Mixture Origination Date: 08/22/96
Synonyms: None Last Revision Date: 02/16/04
Internal Product Codes: N/A
Product Use: Packaging, Hobby Craft
Section 2 - COMPOSITION / INFORMATION ON INGREDIENTS
Components CAS Number % Weight
Aspen Wood Excelsior N/A 55 - 79
Pigment(s) N/A 1 - 25
鈮? 20
Flame Retardant N/A
Component Information
The pigment(s) contained in the final product will vary upon the desired color. Not all pigments will be
found in each color variation. Dependant on the specific products pigment combination, it may be
regulated or have exposure limits identified as the following: Ammonia, Wood Dust- All Soft and Hard
Woods, carbon black, aromatic petroleum distillates and/or ethylene glycol.
Section 3 鈥? HAZARDS IDENTIFICATION
Product Overview
Product is baled wood excelsior blended with a flame retardant as well as pigment or a combination of
pigments. This product contains chemicals and wood dust which may cause irritation and/or dryness of
the respiratory tract. Repeated skin and inhalation exposure to these components may produce allergic
contact dermatitis and respiratory sensitization. Accumulation of wood dusts may pose an explosion
hazard.
Potential Health Effects
Eyes Exposure to may cause mechanical eye irritation.
Skin Handling of product may cause mechanical skin irritation or produce skin rashes.
Repeated skin contact may cause an allergic skin sensitization reaction.
Ingestion Ingestion of this product is unlikely. If ingestion does occur, it may produce gastric
irritation and discomfort.
Inhalation Inhalation of dusts from this product may cause irritation and dryness of the
respiratory system. Repeated inhalation exposure may cause an allergic respiratory
sensitization reaction. Prolonged exposure to certain species of wood dusts has been
associated with an increased risk of nasal cancers; however, no specific data
concerning the type of wood used in this product could be located.
Combustion Modified Dyed Excelsior Page 2 of 6
Section 4 - FIRST AID MEASURES
Eyes In case of contact, flush eyes with water for 15 minutes. Seek medical attention if
irritation persists.
Skin In case of contact, wash thoroughly with soap and large amounts of water. If irritation
develops, seek medical attention.
Ingestion Due to the physical nature of this material, ingestion is unlikely to occur. If ingestion
does occur, seek medical attention.
Inhalation If respiratory irritation or other symptoms develop, seek medical attention.
Notes to Physician None.
Section 5 鈥? FIRE FIGHTING MEASURES
Flash Point : N/A Auto Ignition : N/A
Method Used : N/A Flammability Classification : N/A
Upper Flammable Limit (UFL) : N/A
Rate of Burning : Will not sustain ignition when removed from ignition source.
Lower Flammable Limit (LFL) : N/A
General Fire Hazards If fire retardant compounds are not removed from fiber surfaces by use of water or
other means, this product will not sustain ignition when removed from the ignition source.
Hazardous Combustion Products May produce carbon monoxide, carbon dioxide, aldehydes, various
hydrocarbon fragments, ammonia and/or sulfur oxide gases.
Extinguishing Media Water fog, dry chemical, or sand.
Fire Fighting Equipment/Instructions
Fire fighters should wear full-face, self contained breathing apparatus and impervious
protective clothing. Fire fighters should avoid inhaling any combustion products.
NFPA Ratings: Health: 1, Fire: 1, Reactivity: 0, Other: 0
HMIS Ratings: Health: 1, Fire: 1, Reactivity: 0, Personal Protection: N/A
Section 6 鈥? ACCIDENTAL RELEASE MEASURES
Containment Procedures Contain by any means necessary.
Clean-Up Procedures Vacuum or sweep up material as necessary.
Evacuation Procedures Keep unnecessary people out of area.
Special Instructions Remove sources of ignition during cleanup.
Combustion Modified Dyed Excelsior Page 3 of 6
Section 7 - HANDLING AND STORAGE
Procedures for Handling Keep dust generation and buildup to a minimum. Avoid inhaling dusts from this
product. Remove all sources of ignition when handling this product.
Storage Methods Store in a cool, dry area away from moisture, excessive heat and ignition sources.
Section 8 - EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure Guidelines
A. General Product Information Keep production/collection of airborne material to a
minimum.
B. Component Exposure Limits
mg/m3; STEL: 10 mg/m3
Wood Dust, All Soft And Hard Woods OSHA PEL: 5
Ammonia OSHA PEL: 50 ppm
mg/m3
Carbon Black OSHA PEL: 3.5
mg/m3 totat dust, 5 mg/m3 respirable
Nuisance dust OSHA PEL: 15
dust
Aromatic Petroleum Distillates ACGIH TLV: 100 ppm
Ethylene Glycol ACGIH TLV: 50 ppm (TLV)
Engineering Controls:
Ventilation should be sufficient to effectively remove and prevent buildup of airborne material
while handling and applying this product. Utilize local exhaust or mechanical ventilation, as
necessary.
Personal Protective Equipment
Eye/Face: Wear safety glasses, goggles, or other appropriate eye/face protection.
Skin: Normal work clothing (long sleeved shirts and long pants) and chemical protective gloves are
recommended when handling this product.
Respiratory: Appropriate NIOSH/MSHA approved respiratory protection should be used if airborne
concentrations of components exceed the allowable limits, or as otherwise necessary.
General: None.
Section 9 - PHYSICAL & CHEMICAL PROPERTIES
Appearance: Dyed, baled wood excelsior Odor: Mild
Physical State: Solid pH: N/A
Vapor Pressure: N/A Vapor Density: N/A
Boiling Point: N/A Freezing Point: N/A
Combustion Modified Dyed Excelsior Page 4 of 6
Section 10 - CHEMICAL STABILITY & REACTIVITY INFORMATION
Chemical Stability: Stable
Conditions to Avoid: Avoid excessive heat and ignition sources.
Incompatibility: Avoid contact with oxidizing agents and drying oils. Flame
retardant component is incompatible with nitrate, nitrite and chlorate
Hazardous Decomposition Products: May produce carbon monoxide, carbon dioxide, aldehydes, various
hydrocarbon fragments, ammonia and/or sulfur oxide gases.
Hazardous Polymerization: Hazardous polymerization will not occur.
Section 11 - TOXICOLOGICAL INFORMATION
Acute Toxicity/Target Organ Information
A. Product/Component Information
Wood dusts are generally considered respiratory irritants and sensitizers. However,
the ability of the dusts to cause sensitization reactions varies greatly with the wood
species.
Epidemiology No data available for this product.
Carcinogenicity
A. Product/Component Information
There is some evidence that exposure to certain wood dusts may be associated with an
increased risk of certain nasal cancers. However, that risk appears to vary greatly with
the species of wood and the duration and extent of exposure. Under normal use
conditions, overexposure to wood dust from this product is not anticipated.
B. Component Carcinogenicity Listings
Not listed by ACGIH, IARC, NIOSH, NTP, or OSHA as a carcinogen.
Reproductive Toxicity No data available for this product.
Neurotoxicity No data available for this product.
Mutagenicity No data available for this product.
Other Information No data available for this product.
Section 12 鈥? ECOLOGICAL INFORMATION
Ecotoxicity No data available for this product.
Environmental Fate No data available for this product.
Combustion Modified Dyed Excelsior Page 5 of 6
Section 13 - DISPOSAL CONSIDERATIONS
US EPA Waste Number & Descriptions
A. Product Information As shipped, not regulated as a hazardous waste.
B. Waste Numbers No EPA Waste Numbers are applicable for this product's components.
Disposal Instructions Dispose of waste material in accordance with all applicable Federal, State or
provincial and local environmental regulations. If buried, use area away from
desirable plants and not close to water supply.
Section 14 - TRANSPORTATION INFORMATION
DOT Information
Shipping Name: Not regulated as a hazardous material
Hazard Class: Not regulated
UN/NA #: Not regulated
Packing Group: Not regulated
Label(s) Required None
Shipping Information None
International Transportation Regulations Not regulated as dangerous goods.
Section 15 - REGULATORY INFORMATION
US Federal Regulations
A. General Product Information N/A
B. Component Information None of this product's components are listed under SARA Section
302 (40 CFR 355 Appendix A), SARA Section 313 (40 CFR
372.65) or CERCLA (40 CFR 302.4).
State Regulations
A. General Product Information N/A
B. Component Information None of this product's components are listed on the state lists from
CA, FL, MA, MN, NJ, or PA.
Other Regulations
A. General Product Information N/A
B. Component Information None of the components are listed on the Canadian Controlled
Product Ingredient Disclosure List.
Combustion Modified Dyed Excelsior Page 6 of 6
Section 16 - OTHER INFORMATION
As the conditions of methods of use are beyond our control, American Excelsior Company does not assume any
responsibility and expressly disclaims any liability for use of this material. Information contained herein is
believed to be true and accurate, but all statements or suggestions are made without warranty, expressed or
implied, regarding accuracy of the information, the hazards connected with the use of this material, or the results
to be obtained thereof. Compliance with all federal, state, provincial, and local laws and regulations remains the
responsibility of the user.
Key/Legend
ACGIH American Conference of Governmental Industrial Hygienists
CERCLA Comprehensive Environment Response, Compensation, and Liability Act
CFR Code of Federal Regulations
DOT Department of Transportation
EPA Environmental Protection Agency
HMIS Hazard Materials Information System
IARC International Agency for Research Cancer
MSHA Mine Safety and Health Administration
N/A Not Applicable or Not Available
NIOSH National Institute of Occupational Safety and Health
NFPA National Fire Protection Association
NTP National Toxicology Program
OSHA Occupational Safety and Health Administration
PEL Permissible Exposure Limit
ppm Part per Million
SARA Superfund Amendments and Reauthorization Act
STEL Short Term Exposure Limit
TLV Threshold Limit Value
MSDS Contact: American Excelsior Company Phone: (817) 385-3500
|