MATERIAL SAFETY DATA SHEET
Aspen Bed I,II,III Page 1 of 5
Section 1 - CHEMICAL, PRODUCT AND COMPANY IDENTIFICATION
Manufacturer Information Corporate Office
American Excelsior Company American Excelsior Company
P.O. Box 391 850 Avenue H East
Rice Lake, WI 54868 Arlington, TX 76011
Office Phone #: (715) 234-6861 Office Phone #: (817) 385-3500
Chemical Name: Mixture MSDS Origination Date: 03/26/96
Synonyms: None Last Revision Date: 02/25/04
Internal Product Codes: 32
Product Use: Animal Bedding
Section 2 - COMPOSITION / INFORMATION ON INGREDIENTS
Components CAS Number % Weight
Wood Fibers N/A 100
Component Information/Information on Non-Hazardous Components
This product may be regulated, have exposure limits or other information identified as:
Wood Dust, All Soft and Hard Woods.
Section 3 - HAZARDS IDENTIFICATION
Product Overview
Product is made up of wood fibers and is utilized in animal bedding applications. This product may
contain wood dust. Inhalation of wood dusts may cause irritation and dryness of the respiratory tract.
Repeated skin and inhalation exposure to wood dusts may produce allergic contact dermatitis and
respiratory sensitization.
Potential Health Effects
Eyes Exposure to dusts may cause mechanical eye irritation.
Skin Handling of product may cause mechanical skin irritation. Repeated skin contact may
cause an allergic skin sensitization reaction.
Ingestion Ingestion of this product is unlikely. If ingestion does occur, it may produce gastric
irritation and discomfort.
Inhalation Inhalation of wood dusts may cause irritation and dryness of the respiratory system.
Repeated inhalation exposure may cause an allergic respiratory sensitization reaction.
Prolonged exposure to certain species of wood dusts has been associated with an
increased risk of nasal cancers; however, no specific data concerning the type of wood
used in this product could be located.
Aspen Bed I,II,III Page 2 of 5
Section 4 - FIRST AID MEASURES
Eyes In case of contact, flush eyes with water for 15 minutes. Obtain medical attention if
irritation persists.
Skin In case of contact, wash thoroughly with soap and large amounts of water. If irritation
develops, get medical attention.
Ingestion Due to the physical nature of this material, ingestion is unlikely to occur. If ingestion
does occur, seek medical attention.
Inhalation If dusts from this product are inhaled, remove affected person to fresh air. If
respiratory irritation or other symptoms develop, seek medical attention.
Notes to Physician None.
Section 5 - FIRE FIGHTING MEASURES
Flash Point : N/A
Method Used : N/A
Upper Flammable Limit (UFL) : N/A
Lower Flammable Limit (LFL) : N/A
Auto Ignition : N/A
Flammability Classification : N/A
Rate of Burning : Moderate to rapid
General Fire Hazards
Product will ignite upon exposure to ignition source.
Hazardous Combustion Products
Carbon monoxide, carbon dioxide, aldehydes, and various hydrocarbon fragments.
Extinguishing Media
Water, dry chemical, or sand.
Fire Fighting Equipment/Instructions
Fire fighters should wear full-face, self contained breathing apparatus and impervious
protective clothing. Fire fighters should avoid inhaling any combustion products.
NFPA Ratings: Health: 1, Fire: 1, Reactivity: 0, Other: 0
HMIS Ratings: Health: 1, Fire: 1, Reactivity: 0, Personal Protection: N/A
Section 6 - ACCIDENTAL RELEASE MEASURES
Containment Procedures Contain by any means necessary.
Clean-Up Procedures Wet area with water mist or spray to reduce dust generation and buildup. Vacuum or
sweep up material as necessary.
Evacuation Procedures Keep unnecessary people out of area.
Special Instructions Wear appropriate protective clothing during cleanup. Remove sources of ignition
during cleanup.
Aspen Bed I,II,III Page 3 of 5
Section 7 - HANDLING AND STORAGE
Procedures for Handling Keep dust generation and buildup to a minimum. Avoid inhaling dusts from
this product. Remove all sources of ignition when handling this product.
Recommended Storage Methods Store in a cool, dry area away from moisture, excessive heat and sources of
ignition.
Section 8 - EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure Guidelines
A. General Product Information
Keep formation of dusts to a minimum.
B. Component Exposure Limits
OSHA PEL: 5 mg/m3 ; OSHA STEL: 10 mg/m3
Wood Dust, All Soft and Hard Woods
Engineering Controls: Ventilation should be sufficient to effectively remove and prevent buildup of dusts
while handling and applying this product. Use mechanical ventilation, as necessary.
Personal Protective Equipment
Eye/Face: Wear safety glasses, goggles, or other appropriate eye/face protection as needed.
Skin: Normal work clothing and appropriate gloves are recommended.
Respiratory: When ventilation is not sufficient to maintain dust levels below the PEL, appropriate
NIOSH/MSHA approved respiratory protection must be provided.
General: None.
Section 9 - PHYSICAL & CHEMICAL PROPERTIES
Appearance: Wood fibers Odor: Mild
Physical State: Solid pH: N/A
Vapor Pressure: N/A Vapor Density: N/A
Boiling Point: N/A Freezing Point: N/A
Section 10 - CHEMICAL STABILITY & REACTIVITY INFORMATION
Chemical Stability: Stable.
Conditions to Avoid: Avoid excessive heat and ignition sources.
Incompatibility: Avoid contact with oxidizing agents and drying oils.
Hazardous Decomposition Products: Carbon monoxide, carbon dioxide, aldehydes, and various
hydrocarbon fragments.
Hazardous Polymerization: Hazardous polymerization will not occur.
Aspen Bed I,II,III Page 4 of 5
Section 11 - TOXICOLOGICAL INFORMATION
Acute Toxicity/Target Organ Information
A. General Product/Component Information
Wood dusts are generally considered respiratory irritants and sensitizers. However, the ability of the
dusts to cause sensitization reactions varies greatly with the species of wood.
Epidemiology No data available for this product.
Carcinogenicity
A. General Product/Component Information
There is some evidence that exposure to certain wood dusts may be associated with an increased risk of
certain nasal cancers. However, that risk appears to vary greatly with the species of wood and the
duration and extent of exposure.
B. Component Carcinogenicity Listings
Not listed by ACGIH, IARC, NIOSH, NTP or OSHA.
Reproductive Toxicity No data available for this product.
Neurotoxicity No data available for this product.
Mutagenicity No data available for this product.
Other Information No data available for this product.
Section 12 - ECOLOGICAL INFORMATION
Ecotoxicity No data available for this product.
Environmental Fate 100% of product is composed of natural and biodegradable components.
Section 13 - DISPOSAL CONSIDERATIONS
US EPA Waste Number & Descriptions
A. General Product Information As shipped, not regulated as a hazardous waste.
B. Component Waste Numbers No EPA Waste Numbers are applicable for this product's
components.
Disposal Instructions Dispose of waste material in accordance with all applicable Federal,
State or provincial and local environmental regulations.
Section 14 - TRANSPORTATION INFORMATION
DOT Information
Shipping Name: Not regulated as a hazardous material
Hazard Class: Not regulated
UN/NA #: Not regulated
Packing Group: Not regulated
Label(s) Required None
Additional Shipping Information None
International Transportation Regulations Not regulated as dangerous goods.
Aspen Bed I,II,III Page 5 of 5
Section 15 - REGULATORY INFORMATION
US Federal Regulations
A. General Product Information N/A
B. Component Information None of this product's components are listed under SARA Section
302 (40 CFR 355 Appendix A), SARA Section 313 (40 CFR
372.65) or CERCLA (40 CFR 302.4).
State Regulations
A. General Product Information N/A
B. Component Information None of this product's components are listed on the state lists from
CA, FL, MA, MN, NJ, or PA.
Other Regulations
A. General Product Information N/A
B. Component Information None of the components are listed on the Canadian Controlled
Product Ingredient Disclosure List.
Section 16 - OTHER INFORMATION
As the conditions of methods of use are beyond our control, American Excelsior Company does not assume any
responsibility and expressly disclaims any liability for use of this material. Information contained herein is
believed to be true and accurate, but all statements or suggestions are made without warranty, expressed or
implied, regarding accuracy of the information, the hazards connected with the use of this material, or the results
to be obtained thereof. Compliance with all federal, state, provincial, and local laws and regulations remains the
responsibility of the user.
Key/Legend
ACGIH American Conference of Governmental Industrial Hygienists
CERCLA Comprehensive Environment Response, Compensation, and Liability Act
CFR Code of Federal Regulations
DOT Department of Transportation
EPA Environmental Protection Agency
HMIS Hazard Materials Information System
IARC International Agency for Research Cancer
mg/m3 milligrams per cubic meter
MSHA Mine Safety and Health Administration
N/A Not applicable or Not available
NFPA National Fire Protection Association
NIOSH National Institute of Occupational Safety and Health
NTP National Toxicology Program
OSHA Occupational Safety and Health Administration
PEL Permissible Exposure Limit
SARA Superfund Amendments and Reauthorization Act
STEL Short Term Exposure Limit
MSDS Contact: American Excelsior Company Phone: (817) 385-3500
|