Product # (s)_7133____________________
MATERIAL SAFETY DATA SHEET
Section I 鈥? Product Information
Product Name or Identity: Bile Esculin Azide Agar
Acumedia Manufacturers, Inc. 517/372-9200
Manufacturer鈥檚 Name: Emergency Phone No.:
740 East Shiawassee 517/372-2006
Fax No.:
Lansing, Michigan 48912 foodsafety@neogen.com
e-mail:
Date Prepared or Revised: 10/10/04
Section II 鈥? Hazardous Ingredients / Identity Information
Hazardous Components: OSHA PEL ACGIH TLV Toxicity Data LD50
(Specific Chemical Identity: Common Names) (Permissible (Threshold Limit
Exposure Limits) Value)
STEL/C
Oxbile (Oxgall) N/A N/A N/A
3
Sodium Azide N/A C 0.29 mg/m ORL-MSE, 27 mg/kg
Section III 鈥? Physical Characteristics
Boiling Point: N/A Specific Gravity (H2O = 1): 1.84 (Sodium Azide)
Vapor Pressure (mm Hg.): N/A Melting Point: 275掳C (Sodium Azide)
Vapor Density (AIR = 1): 2.2 (Sodium Azide) Evaporation Rate (Butyl Acetate = 1): N/A
Solubility in Water: 42 g/100 g water @17掳C (Sodium Azide)
Appearance and Odor: Light beige solid/powder. Characteristic odor. (Sodium Azide)
Section IV 鈥? Fire and Explosion Hazard Data
Flash Point: (Method Used) Not applicable Flammable Limits: LEL (Lower Explosive Limits) - N/A
UEL (Upper Explosive Limits) - N/A
Extinguishing Media: Suitable extinguishing agents. CO2, extinguishing powder, or water spray.
Special Fire Fighting Procedures: Fight larger fires with water or alcohol resistant foam. Firefighters should wear
protective equipment and self-contained breathing apparatus.
Unusual Fire and Explosion Hazards: During heating or in case of fire, poisonous gases are produced. Closed
containers exposed to heat may explode.
Section V 鈥? Reactivity Data
Unstable X Conditions to Avoid: Danger of explosion. Avoid heat, sources of ignition, moisture,
Stability:
shock, and friction.
Stable
Incompatibility: (Materials to Avoid) Incompatible with strong oxidizing agents, mineral acids, water, halogen acids and
halogen compounds, barium carbonate, bromine, carbon disulphide, mercury, dimethyl sulphate, common metals, brass,
copper, lead, silver and strong acids. Sodium azide is a problem with these compounds when accumulated as in sink
drains, but not at the concentration used in Bile Esculin Azide Agar.
Hazardous Decomposition or Byproducts: Carbon dioxide (CO2), Ammonia (NH4), Nitrogen oxides (NOx) and
Sulfur oxides (SOx).
May Occur Conditions to Avoid: Contact with acidic solutions and metal compounds over
Hazardous
time may form potentially explosive metal azides. Should any of this material be
Polymerization:
introduced into sanitary sewer system, flush with copious amounts of water.
Will Not Occur X
Page 1 of 2
Product # (s)_7133__________________
Section VI 鈥? Health Hazard Data
Inhalation? Yes Skin? Yes Ingestion? Yes
Route(s) of Entry:
Toxic. Toxic by inhalation and if swallowed. Sodium azide may be fatal if swallowed or absorbed
Health Hazards:
through the skin. Irritating to eyes, respiratory system, and skin.
(Acute and Chronic)
Carcinogenicity: NTP? No IARC Monographs? No OSHA Regulated? No
(National Toxicology Program) (International Agency for Research in Cancer)
Signs and Symptoms of Exposure: Symptoms of poisoning may occur after several hours of exposure, provide
medical observation for at least 48 hours. Ingestion or inhalation of Sodium azide may be fatal, this compound is readily
absorbed through skin. If Sodium azide is ingested, may cause pulmonary edema and rapid heart beat.
Medical Conditions Generally Aggravated by Exposure: Sodium azide may cause irritation to the respiratory tract and
mucous membranes, sore throat, coughing, dizziness, and fainting. Sodium azide may affect central nervous system,
kidneys, and cardiovascular system.
Ingestion: If swallowed, seek medical attention immediately. Show physician product label.
Emergency /
First Aid
Procedures: Inhalation: In case of unconsciousness, place patient on side position for transportation. Supply fresh
air or oxygen; seek medical attention. If required, provide artificial respiration. Keep patient warm.
Eye Contact: Rinse opened eye for at least 15 minutes under running water. Seek medical attention.
Skin Contact: Immediately wash with plenty of soap and water for at least 15 minutes. Seek medical
attention.
Section VII 鈥? Precautions for Safe Handling and Use
Accidental Release Measures: Remove all sources of ignition. Ventilate area of leak or spill. Wear suitable protective
clothing including rubber boots and gloves. Discard clothing after use. Clean up spill that will not disperse dust. Wipe up
with damp sponge or mop, and dispose into a properly labeled container.
Waste Disposal Method: Dispose in accordance with all applicable federal, state, and local environmental regulations.
Handling and Storing: Keep container tightly closed. Store at < 30掳C. Do not store together with oxidizing and acidic
materials. Store away from metal, and away from sources of heat and ignition. Protect from moisture. Containers of this
material may be hazardous when empty since they retain product residues.
Other Precautions: Ensure good ventilation / exhaustion at the workplace. Avoid prolonged or repeated exposure.
Section VIII 鈥? Control Measures
Respiratory Protection: (Specify Type) None required where adequate ventilation conditions exist. If airborne
concentration is high, use an appropriate respirator or dust mask.
Local Exhaust: 50 鈥? 100 CFM Special: N/A
Ventilation:
Mechanical (General): N/A Other: N/A
Protective Gloves: Proper disposable gloves Eye Protection: Chemical resistant safety goggles
Other Protective Clothing or Equipment: Uniform, lab coat, or disposable lab wear.
Work / Hygienic Practices: Follow the usual precautionary measures for handling chemicals / powder. Keep away from
food and beverages. Immediately remove all soiled and contaminated clothing. Avoid contact with eyes, skin, and
clothing.
This document is believed to be correct, but does not purport to be all inclusive and shall be used only as a guide.
Acumedia shall not be held liable for any damage resulting from handling or from contact with the above product. These
suggestions should not be confused with state, municipal or insurance requirements, and constitute NO WARRANTY.
Page 2 of 2
Rev 03, 10/04
|