SKIN (DERMAL):....................................... This product may cause irritation if not removed from the
MATERIAL SAFETY DATA SHEET skin. Chronic overexposure may cause injury to blood, liver & kidneys.
REVISION DATE: ................ 08/15/00
Simoniz USA Inc. SECTION VII FIRST AID
DATE PRINTED: ................. 12/14/06
201 Boston Turnpike BREATHING (INHALATION):................ If victim shows signs of discomfort or irritation, remove
Bolton, Connecticut 06043 PRODUCT NUMBER: ......... S3322XXX to fresh air. If symptoms persist, get immediate medical attention.
(860) 646-0172 CONTROL NUMBER: ......... S3322XXX SWALLOWING (INGESTION): .............. DO NOT INDUCE VOMITING! Drink a large quantity
of water or milk. Do not attempt to give liquids to an unconscious person. Get immediate medical
For chemical emergency information regarding this product, call Chem-Tel at 1-800-255- attention!
3924 anytime. EYES:............................................................ Flush eyes with a large quantity of fresh water for at least
15 minutes. If irritation persists, consult a physician.
SKIN (DERMAL):....................................... Flush from skin and clothing with large amounts of fresh
SECTION I - IDENTIFICATION
water. If irritation persists, consult physician. Wash contaminated clothing before wearing.
Aerosol Foam Disinfectant SECTION VIII EMPLOYEE PROTECTION
PRODUCT NAME:
RESPIRATORY PROTECTION:............. Not usually needed in well ventilated areas. If needed, use
PRODUCT TYPE: ...................................... Aerosol Disinfectant
an OSHA approved respirator.
PROTECTIVE CLOTHING: .................... Nitrile or PVC gloves, and chemical splash goggles.
SECTION II - HAZARDOUS INGREDIENTS
ADDITIONAL MEASURES: .................... Keep away from children. Do not remove or deface label.
HAZARDOUS INGREDIENT CAS NUMBER PEL PERCENT
SECTION IX - SPILL AND DISPOSAL DATA
SPILL: .......................................................... Product should be picked up and reused or recycled.
111-76-2 20 ppm TLV, 25 ppm
2-Butoxy Ethanol Not
WASTE DISPOSAL: .................................. As recommended by local, state and federal authorities.
PEL Listed
HANDLING & STORAGE PRECAUTIONS...................................... Store in a cool, well ventilated
7128-91-8 No limits established
Dimethyl Amine Oxide
area. Avoid overheating or freezing.
5197-80-8 No limits established
Quaternary Ammonium Chloride
SECTION X 鈥揙THER REGULATORY INFORMATION
64-02-8 No limits established
Tetrasodium EDTA
68476-85-7 1000 ppm
Liquefied Petroleum Gas PROPER SHIPPING NAME: Consumer Commodity NFPA HEALTH: 2
ORM-D
SECTION III - PHYSICAL DATA CONSTITUENT: N/A NFPA FLAMMABILITY: 1
HAZARD CLASS AND LABEL: None NFPA REACTIVITY: 0
APPEARANCE: Aerosol foam, pleasantly scented.
ID NUMBER: N/A NFPA OTHER: None
BOILING POINT: NA VAPOR PRESSURE: 115 @ 130 degrees F.
PACKING GROUP: N/A
VAPOR DENSITY: Greater than 1. SPECIFIC GRAVITY: Less than 1.
PH: NA SOLUBILITY IN WATER: Moderately soluble.
SECTION XI - PRECAUTIONARY STATEMENTS
SECTION IV - FIRE AND EXPLOSION DATA WARNING:.................................................. The information contained in this MSDS is based on the
data available to us from sources we believe to be reliable. No warranty or guaranty expressed or
FLASHPOINT:............................................ Greater than 200 degrees F.
implied is made regarding the accuracy of this data or the results obtained from the reliance on this
EXTINGUISHING MEDIA:...................... Water fog or fine spray. Carbon dioxide, Dry chemical, or
data. The manufacturer assumes no responsibility for injury from the use of this product. Be safe-
Alcohol resistant foam.
read this product safety information and pass it on to all persons who may be exposed to this
SPECIAL FIRE FIGHTING PROCEDURES:.................................... Firefighters working in areas
product. Federal law requires it.
where this product is present should be equipped with an approved, fully enclosed SCBA .
UNUSUAL FIRE AND EXPLOSION HAZARDS:............................. At temperatures greater than
130 degrees F., containers exposed to direct flame or heat
contact should be cooled with water to prevent weakening
of container structure.
SECTION V - REACTIVITY DATA
STABILITY: ................................................ Stable under normal conditions.
HAZARDOUS POLYMERIZATION: ..... This product not known to polymerize.
INCOMPATIBILITY:................................ Avoid strong oxidizers. Avoid heat, sparks or open
flames.
HAZARDOUS BYPRODUCTS:................ Carbon monoxide, carbon dioxide.
SECTION VI - HEALTH DATA
ROUTE(S) OF ENTRY: ............................. Inhalation, skin absorption, or ingestion.
LISTED CARCINOGEN: .......................... Not listed by IARC, NTP or OSHA.
MEDICAL CONDITION AGGRAVATED:........................................ May aggravate pre-existing
dermatitis.
INHALATION:............................................ Inhalation of large amounts of this product may cause
dizziness and/or nausea. Maintain adequate ventilation in the work area.
INGESTION: ............................................... This material can cause irritation or damage to stomach
and esophagus.
EYES: ........................................................... May cause severe eye irritation.
|