SECTION VII FIRST AID
MATERIAL SAFETY DATA SHEET BREATHING (INHALATION):................ If victim shows signs of discomfort or irritation, remove
REVISION DATE: ................ 08/17/00
Simoniz USA Inc. to fresh air. If symptoms persist, get immediate medical attention.
DATE PRINTED: ................. 12/14/06 SWALLOWING (INGESTION): .............. DO NOT INDUCE VOMITING! Drink a large quantity
201 Boston Turnpike of water or milk. Do not attempt to give liquids to an unconscious person. Get immediate medical
Bolton, Connecticut 06043 PRODUCT NUMBER: ......... S3378XXX attention!
(860) 646-0172 CONTROL NUMBER: ......... S3378XXX EYES:............................................................ Flush eyes with a large quantity of fresh water for at least
15 minutes. If irritation persists, consult a physician.
For chemical emergency information regarding this product, call Chem-Tel at 1-800-255- SKIN (DERMAL):....................................... Flush from skin and clothing with large amounts of fresh
3924 anytime. water. If irritation persists, consult physician. Wash contaminated clothing before wearing.
SECTION VIII EMPLOYEE PROTECTION
SECTION I - IDENTIFICATION RESPIRATORY PROTECTION:............. Not usually needed in well ventilated areas. If needed, use
an OSHA approved respirator.
Aerosol Silicone Spray
PRODUCT NAME: PROTECTIVE CLOTHING: .................... Nitrile or PVC gloves, and chemical splash goggles.
ADDITIONAL MEASURES: .................... Keep away from children. Do not remove or deface label.
PRODUCT TYPE: ...................................... Aerosol Lubricant
SECTION IX - SPILL AND DISPOSAL DATA
SECTION II - HAZARDOUS INGREDIENTS
SPILL: .......................................................... Avoid breathing vapors. Evacuate area until vapor is
HAZARDOUS INGREDIENT CAS NUMBER PEL PERCENT
dispersed. Remove all ignition sources. Place leaking containers in a well ventilated area. Stop or
reduce discharge if this can be done safely.
WASTE DISPOSAL: .................................. As recommended by local, state and federal authorities.
68476-85-7 1000 ppm
Liquefied Petroleum Gas Not
HANDLING & STORAGE PRECAUTIONS...................................... Store in a cool, well ventilated
Listed
area. Avoid overheating or freezing.
109-66-0 600 ppm
Pentane
SECTION X 鈥揙THER REGULATORY INFORMATION
78-78-4 600 ppm
Isopentane
64742-47-8 300 ppm
Isoparaffinic Solvent PROPER SHIPPING NAME: Consumer Commodity NFPA HEALTH: 1
ORM-D
SECTION III - PHYSICAL DATA CONSTITUENT: N/A NFPA FLAMMABILITY: 4
HAZARD CLASS AND LABEL: None NFPA REACTIVITY: 0
APPEARANCE: Aerosol liquid, mild odor.
ID NUMBER: N/A NFPA OTHER: None
BOILING POINT: NA VAPOR PRESSURE: 70-75@130 degrees F.
PACKING GROUP: N/A
VAPOR DENSITY: Greater than 1. SPECIFIC GRAVITY: Less than 1.
PH: NA SOLUBILITY IN WATER: Insoluble.
SECTION XI - PRECAUTIONARY STATEMENTS
SECTION IV - FIRE AND EXPLOSION DATA WARNING:.................................................. The information contained in this MSDS is based on the
data available to us from sources we believe to be reliable. No warranty or guaranty expressed or
FLASHPOINT:............................................ Less than 73 degrees F.
implied is made regarding the accuracy of this data or the results obtained from the reliance on this
EXTINGUISHING MEDIA:...................... Carbon dioxide, foam and/or dry chemical may be used.
data. The manufacturer assumes no responsibility for injury from the use of this product. Be safe-
SPECIAL FIRE FIGHTING PROCEDURES:.................................... Firefighters working in areas
read this product safety information and pass it on to all persons who may be exposed to this
where this product is present should be equipped with an approved, fully enclosed SCBA .
product. Federal law requires it.
UNUSUAL FIRE AND EXPLOSION HAZARDS:............................. At temperatures greater than
130 degrees F., containers exposed to direct flame or heat
contact should be cooled with water to prevent weakening
of container structure.
SECTION V - REACTIVITY DATA
STABILITY: ................................................ Stable under normal conditions.
HAZARDOUS POLYMERIZATION: ..... This product not known to polymerize.
INCOMPATIBILITY:................................ Avoid strong oxidizers. Avoid heat, sparks or open
flames.
HAZARDOUS BYPRODUCTS:................ Carbon monoxide, carbon dioxide.
SECTION VI - HEALTH DATA
ROUTE(S) OF ENTRY: ............................. Inhalation, skin absorption, or ingestion.
LISTED CARCINOGEN: .......................... Not listed by IARC, NTP or OSHA.
MEDICAL CONDITION AGGRAVATED:........................................ May aggravate pre-existing
dermatitis.
INHALATION:............................................ Inhalation of large amounts of this product may cause
dizziness and/or nausea. Maintain adequate ventilation in the work area.
INGESTION: ............................................... This material can cause irritation or damage to stomach
and esophagus.
EYES: ........................................................... May cause eye irritation.
SKIN (DERMAL):....................................... This product may cause irritation if not removed from the
skin. Prolonged exposure may cause central nervous system depression.
ALL Chemical Property And Toxicity Analysis PAGES IN THIS GROUP