MATERIAL SAFETY DATA SHEET







                                                                                         Page 1 of 2

                             INLAND COATINGS CORPORATION

                                           P.O. BOX 247

                                         2619 HIGHWAY 6

                                       ADEL, IOWA 50003-0247



                                          MSDS NO. LMRPM



                                  1. PRODUCT IDENTIFICATION





PRODUCT IDENTIFIER:                              RPM SERIES POLYESTER MESH

MANUFACTURED FOR:                                INLAND COATINGS CORPORATION

ADDRESS:                                         P.O. BOX 247

                                                 2619 HIGHWAY 6

                                                 ADEL, IOWA 50003-0247

EMERGENCY PHONE:                                 (800) 424-9300(CHEMTREC)

BUSINESS PHONE:                                  (515) 993-4524

REVIEWED:                                        4/02/07



                     2. COMPOSITION/INFORMATION ON INGREDIENTS



Polyester (polyethylene terephthalate polymer) stitchbonded fabric.



                                  3. HAZARDS IDENTIFICATION



There are no hazardous ingredients as defined in the code of federal regulation, Title 29, Part 1910.1200.



                                      4. PHYSICAL HAZARDS



Polyester fabrics will melt at approximately 500 degrees F. and will burn if exposed to flame.

Decomposition products from molten polymer may be subject to auto ignition. Combustion products will be

comprised of Carbon, Hydrogen, oxygen and nitrogen. The exact composition will depend on the conditions

of combustion.



                               5. HEALTH HAZARD INFORMATION



Exposure to RPM Series Polyester Mesh would pose no significant health problems under normal condition

of handling and use.

                                                                                           Page 2 of 2







                              6. EXPOSURE CONTROL MEASURES



General ventilation is suggested. Re-circulation systems should, whenever practical, be operated in the

bypass mode to avoid concentrating air contaminates in the work place.



Fire fighters should protect themselves from decomposition and combustion products that may include

Carbon Monoxide and other toxic gases.



                                7. SAFE HANDLING PROCEDURES



Customary personal hygiene measures such as washing hands after working with such fabrics is

recommended.





                                        DISCLAIMER OF LIABILITY



THE INFORMATION IN THIS MSDS WAS OBTAINED FROM SOURCES WHICH WE BELIEVE ARE RELIABLE.

HOWEVER, THE INFORMATION IS OFFERED IN GOOD FAITH AS TYPICAL VALUES AND NOT AS A

PRODUCT SPECIFICATION. SOME INFORMATION PRESENTED AND CONCLUSIONS DRAWN HEREIN ARE

FROM SOURCES OTHER THAN DIRECT TEST DATA ON THE SUBSTANCE ITSELF. NO WARRANTY, EITHER

EXPRESSED OR IMPLIED, IS MADE.



THE CONDITIONS OR METHODS OF HANDLING, STORAGE, USE, AND DISPOSAL OF THE PRODUCT ARE

BEYOND OUR CONTROL AND MAY BE BEYOND OUR KNOWLEDGE. FOR THIS REASON, WE DO NOT

ASSUME RESPONSIBILITY AND EXPRESSLY DISCLAIM LIABILITY FOR LOSS, DAMAGE OR EXPENSE

ARISING OUT OF OR IN ANY WAY CONNECTED WITH HANDLING, STORAGE, USE OR DISPOSAL OF THE

PRODUCT.



                                  ************ END OF MSDS ************