Consumer Information Sheet #19
Date Prepared: 11/01/94
Last Revision Date: 02/21/92
Office Products North America
Markers and Adhesives
20955 Pathfinder Road
Diamond Bar, CA 91765
Phone: 615-456-8219 (8 am-5 pm CDT M-F)
_________________________________________________________________________________________________________________________
SECTION I PRODUCT IDENTIFICATION
Avery Dennison Product: Dry Erase Marker
_________________________________________________________________________________________________________________________
SECTION II HAZARDOUS INGREDIENT/IDENTITY INFORMATION
Material Name: CAS #: OSHA PEL (ppm): ACGIH TLV (ppm):
Ethanol 64-17-5 1000 1000
Isopropanol 63-63-0 400 400
All of the chemicals listed above are in compliance with OSHA,CFR,1910.1200. A finished marker contains a substantially lower percentage by weight of
each chemical and has the ink held within an absorbent material so it will be released from the marker only through the writing nib.
_________________________________________________________________________________________________________________________
SECTION III PHYSICAL DATA
o
Boiling Point: 148-242 F Appearance: Colored liquids
Specific Gravity: .793 Odor: Alcoholic odor
o
Vapor Pressure (mmHg): 48 @ 20 C Water Solubility: N/AP
Vapor Density (Air=1): 1.6 Evaporation Rate (Butyl Acetate=1): 1.9
Melting Point: N/AP
_________________________________________________________________________________________________________________________
SECTION IV FIRE AND EXPLOSION HAZARD DATA
o
Flash Point: 55 F (method used - TCC) Flammable Limits: 3-19%
Extinguishing Media: Dry chemical, foam, carbon dioxide
Fire Fighting Procedure: Water spray may be useful in minimizing vapors and cooling containers exposed to heat and flame, avoid spreading fire
Unusual Hazards: Material is flammable and may be ignited by heat, sparks or flame
_________________________________________________________________________________________________________________________
SECTION V REACTIVITY DATA
Stability: Yes
Conditions to Avoid: Strong acids or bases, oxidizing agents
Incompatibility: N/AP
Hazardous Decomposition: Carbon dioxide or carbon monoxide
Hazardous Polymerization: Will not occur
_________________________________________________________________________________________________________________________
SECTION VI HEALTH HAZARD DATA
Symptoms of Overexposure for each Potential Route of Exposure -
Inhaled - Breathing high concentrations of vapors may cause irritation of nose and throat, and may cause drowsiness, dizziness or fatigue
Eye Contact - Eye irritant, may cause burning, tearing, redness, and swelling
Absorbed through Skin - May cause drying and cracking of the skin Ingestion - N/AP
Health Effects or Risks from Exposure -
Medical Conditions Aggravated by Exposure: Chronic - No Carcinogenic: No
This product contains materials that are listed on the following lists: NTP: No IARC: No OSHA: No
S.A.R.A. Information: This product is not reportable under SARA Title III, Section 313
Toxic Information: Non-toxic per ASTM D-4236
Emergency First Aid Procedures -
Eye Contact: Flush with large amounts of water, if irritation or redness develops, get medical attention
Skin Contact: Wash with soap and water, if irritation develops, get medical attention
Inhaled: Remove to fresh air, if symptoms persist, seek medical attention Ingestion: N/AP
_________________________________________________________________________________________________________________________
SECTION VII PRECAUTIONS FOR SAFE HANDLING AND USE
Spill or Leak Procedures: Soak up spill with clay or other absorbent material and dispose
Waste Disposal: Incinerate in a furnace where permitted under appropriate federal, state, and local regulations
Storage: Keep away from heat and sources of ignition
_________________________________________________________________________________________________________________________
SECTION VIII CONTROL MEASURES
Work Practices: Observe ordinary measures of personal hygiene
_________________________________________________________________________________________________________________________
To the best of our knowledge this information is accurate; however, we do not, and cannot, warrant or guarantee its accuracy and cannot be liable for any
damages, consequential or actual which might result from any reliance therein. This MSDS was prepared to comply with the OSHA Hazard Communication
Standard (29 CFR 1910.1200).
N/AP: Not applicable N/E: Not established
|