Thank you for requesting an MSDS for this product.
We have reviewed our products, conducted a hazard determination, and prepared MSDSs in
compliance with the requirements of the Occupational Safety and Health Administration (OSHA)
Hazard Communication Standard, 29 CFR 1910.1200 and Canada's Workplace Hazardous Materials
Information System (WHMIS). Our MSDSs also provide information on any toxic chemical subject to
the reporting requirements of section 313 of Title III of the Superfund Amendments and
Reauthorization Act of 1986 (SARA).
If this product, or any component of it, is considered to be hazardous or carcinogenic under the
OSHA Hazard Communication Standard or the WHMIS regulations, information is provided in Section
2: COMPOSITION/INFORMATION ON INGREDIENTS or in Section 3: HAZARDS IDENTIFICATION.
801791PM Page 1 of 6
01-21-2004
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
REVISION DATE: 01-21-2004 01-21-2004
SUPERSEDES:
SECTION 1: CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
COMPANY INFORMATION
Specialty Construction Brands, Inc.
(formerly Foster Products Corporation
an H.B. Fuller Company Subsidiary)
315 South Hicks Road
Palatine, IL 60067
Phone: 847-358-9500
Medical Emergency Phone Number (24 Hours): 1-888-853-1758
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
PRODUCT INFORMATION
PRODUCT IDENTIFIER: 801791PM
PRODUCT NUMBER: CP0090
PRODUCT NAME: CHILDERS CP-09
PRODUCT DESCRIPTION: Coating
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
Unlisted ingredients are not 'hazardous' per the Occupational Safety and Health Administration Hazard
Communication Standard (29 CFR 1910.1200) and/or are not found on the Canadian Workplace Hazardous
Materials Information System ingredient disclosure list. See Section 8 for any additional exposure limit guidelines.
Chemical Name CAS # PERCENT OSHA PEL
Crystalline silica 14808-60-7 10 - 30 TWA (Respirable dust) 0.1 MG/M3
Aluminum hydroxide 21645-51-2 10 - 30 TWA (as Al) Soluble 2 MG/M3
Titanium dioxide 13463-67-7 1-5 TWA (Total dust) 10 MG/M3
Cellulose 9004-34-6 1-5 TWA (Respirable dust) 5 MG/M3
TWA (Total dust) 15 MG/M3
Vinyl acetate 108-05-4 0.1 - 1 TWA 10 ppm
STEL 20 ppm
SECTION 3: HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
801791PM Page 2 of 6
01-21-2004
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
Cancer hazard.
HMIS RATING: HEALTH -- 0 FLAMMABILITY -- 0 REACTIVITY -- 0
See SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION for personal protective equipment
recommendations.
POTENTIAL HEALTH EFFECTS BY ROUTE OF ENTRY
EYE: Can cause minor irritation, tearing and reddening.
SKIN: Can cause minor skin irritation, defatting, and dermatitis.
INHALATION: Can cause minor respiratory irritation. Inhalation of dusts produced during cutting, grinding or
sanding of this product may cause irritation of the respiratory tract.
Overexposure to crystalline silica may cause silicosis.
INGESTION: Ingestion is not an anticipated route of exposure. No hazard in normal industrial use.
LONG-TERM (CHRONIC) HEALTH EFFECTS
TARGET ORGAN(S): Lungs
REGULATED CARCINOGEN STATUS:
Unless noted below, this product does not contain regulated levels of NTP, IARC, ACGIH, or OSHA listed
carcinogens.
Crystalline silica
Vinyl acetate
EXISTING HEALTH CONDITIONS AFFECTED BY EXPOSURE: Lung disease
SECTION 4: FIRST AID MEASURES
IF IN EYES: Use an eye wash to remove a chemical from your eye regardless of the level of hazard. Flush the
affected eye for at least twenty minutes. Tilt the head to prevent chemical from transferring to the uncontaminated
eye. Seek medical advice after flushing.
IF ON SKIN: Wash with soap and water. Get medical attention if irritation develops or persists.
IF VAPORS INHALED: Remove to fresh air. Call a physician if symptoms persist.
IF SWALLOWED: Do not induce vomiting. Seek medical attention if symptoms develop. Provide medical care
provider with this MSDS. Induced vomiting may lead to aspiration of the material into the lungs potentially causing
chemical pneumonitis that may be fatal.
SECTION 5: FIRE FIGHTING MEASURES
FLASH POINT: Non flammable
AUTOIGNITION TEMPERATURE: Not established
LOWER EXPLOSIVE LIMIT (% in air): Not established
UPPER EXPLOSIVE LIMIT (% in air): Not established
EXTINGUISHING MEDIA: Use water spray, foam, dry chemical or carbon dioxide.
UNUSUAL FIRE AND EXPLOSION HAZARDS: There is a possibility of pressure buildup in closed containers
when heated. Water spray may be used to cool the containers.
SPECIAL FIRE FIGHTING INSTRUCTIONS: Persons exposed to products of combustion should wear self-
contained breathing apparatus and full protective equipment.
HAZARDOUS COMBUSTION PRODUCTS: Carbon dioxide, Carbon monoxide
801791PM Page 3 of 6
01-21-2004
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
SECTION 6: ACCIDENTAL RELEASE MEASURES
SPECIAL PROTECTION: No adverse health effects expected from the clean-up of spilled material.
Follow personal protective equipment recommendations found in Section 8
of this MSDS.
CLEAN-UP: Dike if necessary, contain spill with inert absorbent and transfer to containers
for disposal. Keep spilled product out of sewers, watersheds, or water
systems.
Avoid creating dusts. Cover material with absorbent and moisten and collect
for disposal.
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
SECTION 7: HANDLING AND STORAGE
Handling: No special handling instructions due to toxicity. Avoid breathing material.
Storage: Store in a cool, dry place.
Consult the Technical Data Sheet for specific storage instructions.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
EYE PROTECTION: Wear safety glasses when handling this product.
SKIN PROTECTION: Avoid skin contact by wearing chemically resistant gloves.
GLOVES: Not normally required. Use nitrile gloves if conditions warrant.
RESPIRATORY PROTECTION: Respiratory protection may be required to avoid overexposure when
handling this product. Use a respirator if general room ventilation is
not available or sufficient to eliminate symptoms. NIOSH approved
air purifying respirator with dust/mist filter.
Respirators should be selected by and used following requirements
found in OSHA's respirator standard (29 CFR 1910.134).
VENTILATION: Use local exhaust ventilation or other engineering controls to
minimize exposures.
EXPOSURE LIMITS:
Chemical Name ACGIH EXPOSURE LIMITS AIHA WEEL
Crystalline silica TWA (Respirable dust) 0.05 MG/M3 Not established
Aluminum hydroxide TWA (as Al) Soluble 2 MG/M3 Not established
Titanium dioxide TWA (Total dust) 10 MG/M3 Not established
Cellulose TWA (Total dust) 10 MG/M3 Not established
Vinyl acetate TWA 10 ppm Not established
STEL 15 ppm
801791PM Page 4 of 6
01-21-2004
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE: Liquid
COLOR: White
ODOR: Sweet
ODOR THRESHOLD: Not established
WEIGHT PER GALLON (lbs.): 11.00
SPECIFIC GRAVITY: 1.32
SOLIDS (% by weight): 66.0
pH: Not established
BOILING POINT (deg. C): Not established
FREEZING/MELTING POINT (deg. C): Not established
VAPOR PRESSURE (mm Hg): Not established
VAPOR DENSITY: Not established
EVAPORATION RATE: Not established
OCTANOL/WATER COEFFICIENT: Not established
SECTION 10: STABILITY AND REACTIVITY
STABILITY: Stable under normal conditions.
CHEMICAL INCOMPATIBILITY: Not established
HAZARDOUS POLYMERIZATION: Will not occur.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide
SECTION 11: TOXICOLOGICAL INFORMATION
CHEMICAL NAME LD50/LC50
Crystalline silica Not established
Aluminum hydroxide Not established
Titanium dioxide Not established
Cellulose Oral LD50 Rat > 5 g/kg
Inhalation LC50 Rat > 5800 mg/cu m/4H
Dermal LD50 Rabbit > 2 g/kg
Vinyl acetate Oral LD50 Rat = 2920 mg/kg
Inhalation LC50 Rat =11400 ml/cu m
Dermal LD50 Rabbit = 2335 mg/kg
TOXICOLOGY SUMMARY: No additional health information available.
SECTION 12: ECOLOGICAL INFORMATION
OVERVIEW: No ecological information available
801791PM Page 5 of 6
01-21-2004
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
SECTION 13: DISPOSAL CONSIDERATIONS
To the best of our knowledge, this product does not meet the definition of hazardous waste under the U.S. EPA
Hazardous Waste Regulations 40 CFR 261. Solidify and dispose of in an approved landfill. Consult state, local or
provincial authorities for more restrictive requirements.
SECTION 14: TRANSPORTATION INFORMATION
Consult Bill of Lading for transportation information.
DOT: NOT REGULATED
IATA: NOT REGULATED
SECTION 15: REGULATORY INFORMATION
INVENTORY STATUS
U.S. EPA TSCA: This product is in compliance with the Toxic Substances Control Act's
Inventory requirements.
CANADIAN CEPA DSL: This product is in compliance with the Canadian Domestic Substance List
requirements.
If you need more information about the inventory status of this product call 651-236-5858.
FEDERAL REPORTING
EPA SARA Title III Section 313
Unless listed below, this product does not contain toxic chemical(s) subject to the reporting requirements of section
313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA) and 40 CFR part 72. EPA
has advised that when a percentage range is listed the midpoint may be used to fulfill reporting obligations.
Chemical Name CAS# %
Vinyl acetate 108-05-4 0.1 - 1
WHMIS STATUS: Unless listed below, this product is not controlled under the Canadian Workplace Hazardous
Materials Information System.
D2A
STATE REPORTING
This MSDS is not prepared for distribution in California.
SECTION 16: ADDITIONAL INFORMATION
This Material Safety Data Sheet is prepared to comply with the United States Occupational Safety and Health
Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the Canadian Workplace
Hazardous Materials Information System (WHMIS).
Prepared by: The Global Regulatory Department
Phone: 651-236-5842
The information and recommendations set forth herein are believed to be accurate. Because some of the information
is derived from information provided to Specialty Construction Brands, Inc. from its suppliers, and because
801791PM Page 6 of 6
01-21-2004
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
Specialty Construction Brands, Inc. has no control over the conditions of handling and use, Specialty Construction
Brands, Inc. makes no warranty, expressed or implied, regarding the accuracy of the data or the results to be
obtained from the use thereof. The information is supplied solely for your information and consideration, and
Specialty Construction Brands, Inc. assumes no responsibility for use or reliance thereon. It is the responsibility of
the user of Specialty Construction Brands, Inc. products to comply with all applicable federal, state and local laws
and regulations.
|