**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 111-86-4 |N-Octylamine | >99 | 203-916-0 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: C
Risk Phrases: 35
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Causes severe burns.Corrosive.
Potential Health Effects
Eye:
Contact with eyes may cause severe irritation, and possible eye
burns.
Skin:
Causes skin burns.
Ingestion:
May cause severe and permanent damage to the digestive tract. Causes
gastrointestinal tract burns.
Inhalation:
May cause severe irritation of the respiratory tract with sore
throat, coughing, shortness of breath and delayed lung edema. Causes
chemical burns to the respiratory tract.
Chronic:
None
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Get medical aid immediately. Do NOT allow victim to rub eyes or keep
eyes closed. Extensive irrigation with water is required (at least 30
minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of
water for at least 15 minutes while removing contaminated clothing
and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4
cupfuls of milk or water. Never give anything by mouth to an
unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh
air immediately. If not breathing, give artificial respiration. If
breathing is difficult, give oxygen. Do NOT use mouth-to-mouth
resuscitation.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Vapors may
be heavier than air. They can spread along the ground and collect
in low or confined areas.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam. Use agent most appropriate to extinguish
fire.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Clean up spills immediately,
observing precautions in the Protective Equipment section. Provide
ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Keep container tightly closed. Do not get on skin or in eyes. Do not
ingest or inhale. Use with adequate ventilation. Discard contaminated
shoes.
Storage:
Keep container closed when not in use. Store in a cool, dry,
well-ventilated area away from incompatible substances. Corrosives
area.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 111-86-4:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to minimize
contact with skin.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: clear, colorless
Odor: none reported
pH: Not available.
Vapor Pressure: 1 mbar @ 20 C
Viscosity: 1.4mPa @ 20C
Boiling Point: 175-177C
Freezing/Melting Point: -5-1C
Autoignition Temperature: 265 deg C ( 509.00 deg F)
Flash Point: 62 deg C ( 143.60 deg F)
Explosion Limits, lower: 1.6
Explosion Limits, upper: 8.2
Decomposition Temperature: 300 deg C
Solubility in water: Slightly soluble.
Specific Gravity/Density: .7800g/cm3
Molecular Formula: C8H19N
Molecular Weight: 129.25
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents, acid chlorides, acid anhydrides, strong
acids.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, irritating and toxic fumes and
gases, carbon dioxide, nitrogen.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 111-86-4: RG8050000
LD50/LC50:
CAS# 111-86-4: Draize test, rabbit, eye: 100 mg/24H Severe.
Carcinogenicity:
N-Octylamine -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 35 Causes severe burns.
Safety Phrases:
S 23 Do not inhale gas/fumes/vapour/spray.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 28A After contact with skin, wash immediately with
plenty of water.
WGK (Water Danger/Protection)
CAS# 111-86-4: 2
Canada
CAS# 111-86-4 is listed on Canada's DSL List.
CAS# 111-86-4 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 111-86-4 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 11/05/1998 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
2-Anilinoethanol, 98%
| 122-98-5 |
|
2,4-Dimethylstyrene
| 2234-20-0 |
|
5-Sulfoisophthalic acid,monosodium salt 98%
| 6362-79-4 |
|
1,3-Dichloro-2-Butene, 96%, Mixture of Cis and Trans Isomers
| 926-57-8 |
|
3,4-Difluorobenzonitrile, 97%
| 64248-62-0 |
|
3-Aminopyrazole-4-Carboxylic Acid, 95%
| 24447-68-5 |
|
N-Methyl-p-phenylenediamine dihydrochloride, 98% (titr.)
| 5395-70-0 |
|
9,10-Bis(Phenylethynyl)Anthracene
| 10075-85-1 |
|
2-(2-Benzoxazolyl)malondialdehyde
| 40071-07-6 |
|
Bicyclohexyl
| 92-51-3 |
|
9-Octyl-9-heptadecanol, tech.
| 17687-72-8 |
|
1-Naphthyl isocyanate, 99%
| 86-84-0 |
|
3-Cyanophenol, 97%
| 873-62-1 |
|
Trimethylacetamide, 98%
| 754-10-9 |
|
4-Acetoxybiphenyl, 99+%
| 148-86-7 |
|
Allyl Acetate, 99%
| 591-87-7 |
|
Ethyl Thiocyanate, 99% (GC)
| 542-90-5 |
|
3,5-Dichlorobenzoic Acid, 99%
| 51-36-5 |
|
Ethyl 2-aminocyclopenta[b]thiophene-3-carboxylate, 99+%
| 4815-29-6 |
|
4-Carboxybenzaldehyde 97%
| 619-66-9 |
|
N-Methylacetamide, 99+%
| 79-16-3 |
|
5-Nitro-2-furanacrolein, tech, 92%
| 1874-22-2 |
|
(2R,3R)-3-Phenyl Glycidol, 96% (GC)
| 98819-68-2 |
|
2-Bromopyridine, 99%
| 109-04-6 |
|
Citronellyl Acetate, 97%
| 150-84-5 |
|
4-Penten-1-ol, 99%
| 821-09-0 |
|
Alpha, Alpha-Dicyclopropylbenzene-Methanol
| 5689-19-0 |
|
Osmium(III) chloride, 63.2% to 65.2% Os
| 13444-93-4 |
|
Tetramethylammonium Fluoride Trihydrate, 99% (Titr.)
| 373-68-2 |
|
Cytochrome c, horse heart muscle 90% warburg activity
| 9007-43-6 |
|
Octylamine, 99+% (GC)
| 111-86-4 |
|
2,3-Diaminonaphthalene, 97%
| 771-97-1 |
|
1-(4-Bromophenyl)-2-Pyrrolidinone 99+%(GC)
| 7661-32-7 |
|
4-Aminobutyric acid, 99+%
| 56-12-2 |
|
2'-Methylacetoacetanilide, 99% (HPLC)
| 93-68-5 |
|
4-Cyclohexyl-1-Butanol, 99%
| 4441-57-0 |
|
Pipes (1,4-Piperazinebis(Ethanesulfonic Acid)) 98.5+%
| 5625-37-6 |
|
5-Norbornene-2-acrylic acid, 99%
| 15222-64-7 |
|
4-Amino-2,6-Dimethylpyrimidine, 99%
| 461-98-3 |
|
N-Methyloctylamine, 95% (GC)
| 2439-54-5 |
|
Poly(2-ethylhexyl acrylate), 32% solids solution in Toluene, average
| 108-88-3 |
|
N-Ethylethylenediamine, 98+%
| 110-72-5 |
|
4,6-Dihydroxy-2-Mercaptopyrimidine, 98%
| 504-17-6 |
|
Poly T(R)-128
| 68550-83-4 |
|
Cyclopropylphenylmethane, 99%
| 1667-00-1 |
|
2-Methylindoline, 99+%
| 6872-06-6 |
|
4-Biphenylmethanol 98%
| 3597-91-9 |
|
2-Bromofluorene, 95%
| 1133-80-8 |
|
2-Norbornaneacetic Acid, 96%
| 1007-01-8 |
|
Poly(vinyl chloride), high molecular weight
| 9002-86-2 |
|
|