Search   
MSDS 
:
 2-(2-Ethoxyethoxy)ethyl Acetate, 99%
CAS 
:
 112-15-2
SYNONYMS 
:
 Ethyldiglycolacetate.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 112-15-2 |2-(2-Ethoxyethoxy)ethyl Acetate | 99 | 203-940-1 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Not available.

Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract. Low hazard for usual
industrial handling.
Inhalation:
May cause respiratory tract irritation. Low hazard for usual
industrial handling.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. If irritation
develops, get medical aid.
Skin:
Flush skin with plenty of water for at least 15 minutes while
removing contaminated clothing and shoes. Get medical aid if
irritation develops or persists. Wash clothing before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Do NOT induce
vomiting. If conscious and alert, rinse mouth and drink 2-4 cupfuls
of milk or water. Wash mouth out with water. Get medical aid if
irritation or symptoms occur.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid if cough or other symptoms appear.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Will burn
if involved in a fire. Use water spray to keep fire-exposed
containers cool. Vapors may be heavier than air. They can spread
along the ground and collect in low or confined areas. Containers may
explode when heated.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Cool containers with
flooding quantities of water until well after fire is out. Use water
spray, dry chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Clean up spills immediately,
observing precautions in the Protective Equipment section. Remove all
sources of ignition. Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Wash hands before eating. Remove
contaminated clothing and wash before reuse. Avoid contact with eyes,
skin, and clothing. Keep container tightly closed. Keep away from
heat, sparks and flame. Avoid ingestion and inhalation. Use with
adequate ventilation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. No special
precautions indicated.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 112-15-2:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Liquid
Color: clear, colorless
Odor: acetic odor
pH: Not available.
Vapor Pressure: 0.3 hPa @ 20 C
Viscosity: 2.8 MPA 20.00 deg C
Boiling Point: 210-220 deg C @ 760.00mm Hg
Freezing/Melting Point: -25 deg C
Autoignition Temperature: 310 deg C ( 590.00 deg F)
Flash Point: 100 deg C ( 212.00 deg F)
Explosion Limits, lower: 1.50 vol %
Explosion Limits, upper: .00 vol %
Decomposition Temperature:
Solubility in water: miscible
Specific Gravity/Density: 1.0100g/cm3
Molecular Formula: C8H16O4
Molecular Weight: 176.20

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 112-15-2: KK8925000
LD50/LC50:
CAS# 112-15-2: Draize test, rabbit, eye: 500 mg Moderate; Oral,
rabbit: LD50 = 4400 mg/kg; Oral, rat: LD50 = 11 gm/kg; Skin, rabbit:
LD50 = 15100 uL/kg.
Carcinogenicity:
2-(2-Ethoxyethoxy)ethyl Acetate -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 112-15-2: 1
Canada
CAS# 112-15-2 is listed on Canada's DSL List.
CAS# 112-15-2 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 112-15-2 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 9/02/1997 Revision #6 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Alpha, Alpha, Alpha-Trifluoro-P-Tolunitrile, 99% 455-18-5
Ethyl 4-methoxybenzoate, 98% 94-30-4
Ethanesulfonic Acid, 95% (Titr.) 594-45-6
3,6-Dihydroxybenzonorbornane, 96% (uv-vis) 15155-91-5
Ethyl 3-Aminobenzoate, 99+% 582-33-2
Chromium(III)acetylacetonate, 97% 21679-31-2
2-(2-(Methylamino)ethyl)pyridine dihydrochloride 5579-84-0
2-Amino-4-chlorobenzoic acid, 98% 89-77-0
N-(2-Hydroxyethyl)Pyrrolidine, 95% 2955-88-6
2,2,2-Trifluoroethyl P-Toluenesulfonate 98% 433-06-7
3,4-Diethoxybenzoic Acid, 99% 5409-31-4
1-Octadecanol 95% 112-92-5
DL-2,3-Diaminopropionic Acid Monohydrochloride, 99% 54897-59-5
5-Methyl-3-heptanone, 96% (gc) 541-85-5
1-Bromo-2,2-dimethoxypropane, 97% 126-38-5
Phenyl 4-Aminosalicylate, 99% 133-11-9
Tetraethyltin, 97% 597-64-8
1-Piperazinepropanol, 98% 5317-32-8
Diethyl Methylmalonate, 99% 609-08-5
2,2,6,6-Tetramethylcyclohexanone, 98% 1195-93-3
2-Nitroresorcinol 601-89-8
o-Methoxycinnamic acid, predominantly trans 6099-03-2
4-Aminobenzyl cyanide, 99% 3544-25-0
2,3-Dichloropyridine, 99% 2402-77-9
2-Amino-1-Phenylethanol, 98% 7568-93-6
Dipropylene Glycol, Tech., 99% (GC) Mixture of Isomeric Propylene 25265-71-8
Dibenzylamine, 98% 103-49-1
6-Chloro-2-picoline, 98% 18368-63-3
Diethyl Oxalacetate Sodium Salt (PRACT) 40876-98-0
Cyclobutanecarboxylic Acid, 98% 3721-95-7
2-(2-Ethoxyethoxy)ethyl Acetate, 99% 112-15-2
2-Mercapto-6-Nitrobenzothiazole, 96% (Titr.) 4845-58-3
Dihydrocytochalasin B 39156-67-7
3-Chloropropylamine Hydrochloride, 98% 6276-54-6
2-Amino-3-Methylbenzoic Acid, 98% 4389-45-1
m-Phenetidine, 96% (gc) 621-33-0
4,4-Diphenylsemicarbazide, 98% 603-51-0
3-Methyl-1-pentyn-3-ol, 99+% 77-75-8
(R)-(+)-N-Benzyl-alpha-methylbenzylamine, 98% 38235-77-7
1,7-Diaza-15-Crown-5, 99% 31249-95-3
l-(-)-Xylose, p.a. 609-06-3
4-Hydroxybenzylidenemalonodinitrile, 99% 3785-90-8
2,2'-Dithiodipyridine, 98% 2127-03-9
Mercury atomic absorption standard solution, 1 mg/ml Hg in 10% HNO3 7439-97-6
Lissamine Rhodamine B Sulfonyl Chloride, 99+% (UV-VIS) 62796-29-6
2,4-Diethyl-2,6-heptadienal, 97% Mixture of Isomers 85136-07-8
Dimethyldiselenide, 99+% 7101-31-7
2-Amino-4-Hydroxy-1H-Pteridine 2236-60-4
Alpha-Bromo-O-Tolunitrile, 98% 22115-41-9
(2-Chloroethyl)trimethylammonium chloride, 98% 999-81-5

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net