Search   
MSDS 
:
 Bacitracin, zinc salt, potency min. 60 units/mg (on the dry
CAS 
:
 1405-89-6
SYNONYMS 
:
 Zinc bacitracin
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 1405-89-6 |Bacitracin, zinc salt | | 215-787-8 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Hygroscopic (absorbs moisture from the air).The toxicological
properties of this material have not been fully investigated.

Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Immediately flush
eyes with plenty of water for at least 15 minutes, occasionally
lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry
chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up, then place into a suitable container for
disposal. Avoid generating dusty conditions. Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Minimize dust
generation and accumulation. Avoid contact with eyes, skin, and
clothing. Keep container tightly closed. Avoid ingestion and
inhalation.
Storage:
Keep container closed when not in use. Store in a tightly closed
container. Store in a cool, dry, well-ventilated area away from
incompatible substances. Keep refrigerated. (Store below 4C/39F.)
Store protected from moisture.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 1405-89-6:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Wear a NIOSH/MSHA or European Standard EN 149
approved full-facepiece airline respirator in the
positive pressure mode with emergency escape
provisions.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Powder
Color: white to light yellow-gray - white to gray-yellow
Odor: odorless
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: 221.00 - 225.00 deg C
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: soluble
Specific Gravity/Density:
Molecular Formula:
Molecular Weight:

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, alkaline materials, strong
oxidants, exposure to moist air or water.
Incompatibilities with Other Materials:
Strong oxidizing agents, moisture.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, oxides of sulfur, irritating and
toxic fumes and gases, carbon dioxide, nitrogen.
Hazardous Polymerization: Has not been reported.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 1405-89-6 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Bacitracin, zinc salt -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****

Other
No information available.

**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 1405-89-6: No information available.
Canada
CAS# 1405-89-6 is listed on Canada's NDSL List.
CAS# 1405-89-6 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 1405-89-6 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 9/02/1997 Revision #6 Date: 3/18/2003

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Platinum on calcium carbonate (5% pt) 471-34-1
Myricetin, 95% 529-44-2
3,3-Diphenylpropylamine, 98% 5586-73-2
2,4,5-Trimethoxycinnamic Acid, 98+% Trans 24160-53-0
Bacitracin, zinc salt, potency min. 60 units/mg (on the dry 1405-89-6
Pyrithyldione 98% 77-04-3
cis-1,2,3,6-Tetrahydrophthalic anhydride, 98% 935-79-5
2,4,6-Triaminopyrimidine, 97% 1004-38-2
4-Acetylpiperidine Hydrochloride, 98% 0-00-1
3-Chloro-Benzophenone, 99+% 1016-78-0
p-Tolyl isocyanate, 99% 622-58-2
Allylthiourea, 98% 109-57-9
Tetramethylammonium Fluoride Tetrahydrate, 98% 17787-40-5
N,N-Diethylhydroxylamine, 97% 3710-84-7
Aceanthrenequinone, 99+% 6373-11-1
2-Methyl-1-hexene, 98% 6094-02-6
Borane-methyl sulfide complex 13292-87-0
Acetylcholine Iodide, 99% (Titr.) 2260-50-6
Cobalt phthalocyanine 3317-67-7
2,4,4-Trimethyl-2-pentene, 98% 107-40-4
Gamma-Undecalactone, 98% 104-67-6
2,3-Dihydroimidazo(2,1-b)Benzothiazol-6- Amine, 90% (Titr.) 78291-99-3
3,4-Dichlorobenzylamine, 98% 102-49-8
Trifluoroacetic acid 2,2,2-trifluoroethyl ester, 99+% 407-38-5
3,5-Dimethylpyrazole, 98.5% 67-51-6
5-Chloroindole, 99% 17422-32-1
3,4-Dibromothiophene, 97% 3141-26-2
4,5,6-Triaminopyrimidine Sulfate Hydrate, 97% 6640-23-9
(S,S)-(+)-2,5-Bis(Methoxymethyl)Pyrrolidine, 96% 93621-94-4
DL-Camphor, 98% 76-22-2
3-Bromobenzyl alcohol, 99% 15852-73-0
Formaldoxime hydrochloride, 99% (titr.) 3473-11-8
N-Phenyl Di-P-Tolylamine, 97% (GC) 20440-95-3
Poly(vinyl acetate), Secondary Standard, Molecular Weight Series 9003-20-7
Isopropyl beta-D-Thiogalactopyranoside, contains ca. 15% 1,4-Dioxane 123-91-1
Phosphorus Pentachloride, Reagent (Crystals) 10026-13-8
Beryllium fluoride, 98.5+% 7787-49-7
Cholesteryl Oleyl Carbonate, 99+%(TLC) 17110-51-9
Phenylacetone, 99+% 103-79-7
2-Amino-9-Fluorenone 3096-57-9
3,3-Tetramethyleneglutaric Acid, 99% 16713-66-9
Dimethyl Suberimidate Dihydrochloride, 99% 34490-86-3
5-Fluoro-1-indanone, 98% 700-84-5
2,3,5,6-Tetrabromo-4-Methyl-4-Nitrocyclo-Hexa-2,5-Dienone, 97% 95111-49-2
3'-Bromoacetophenone, 97% 2142-63-4
3,5-bis(trifluoromethyl)benzoic acid, 98% 725-89-3
1-Amino-1-cyclohexanecarboxylic acid, 98% 2756-85-6
Methyl Dichlorophosphite, 98% 3279-26-3
1-Chloro-3-Tosylamido-7-Amino-2-Heptanone Hydrochloride, 98% 4238-41-9
Reserpine, 97% (UV-Vis) 50-55-5

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net