**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 39910-98-0 |4-morpholinoacetophenone | 99.0 | 254-698-9 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.The toxicological
properties of this material have not been fully investigated.
Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
Causes respiratory tract irritation. The toxicological properties of
this substance have not been fully investigated.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Immediately flush skin with plenty of water for at
least 15 minutes while removing contaminated clothing and shoes.
Wash clothing before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh
air immediately. If not breathing, give artificial respiration. If
breathing is difficult, give oxygen.
Notes to Physician:
Antidote:
None reported.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Avoid
generating dusty conditions. Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Minimize dust generation and accumulation. Avoid
contact with eyes, skin, and clothing. Keep container tightly closed.
Avoid ingestion and inhalation. Use with adequate ventilation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use process enclosure,
local exhaust ventilation, or other engineering controls to control
airborne levels.
Exposure Limits
CAS# 39910-98-0:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Solid
Color: Not available.
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: 96 - 98 deg C
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density:
Molecular Formula: C12H15NO2
Molecular Weight: 205.26
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Dust generation.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong bases
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 39910-98-0: AM9486200
LD50/LC50:
Not available.
Carcinogenicity:
4-morpholinoacetophenone -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
Other
No information available.
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 37/39 Wear suitable gloves and eye/face
protection.
WGK (Water Danger/Protection)
CAS# 39910-98-0: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 39910-98-0 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 39910-98-0 is not listed on the TSCA inventory.
It is for research and development use only.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 2/09/1999 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
3-Dimethylaminopropiophenone Hydrochloride, 99%
| 879-72-1 |
|
Polycarbonate resin, approximate m.w. 64.000,pellets
| 24936-68-3 |
|
Serotonin Hydrochloride Hydrate, 99%
| 153-98-0 |
|
Triphenylmethyl bromide, 98%
| 596-43-0 |
|
2-Amino-5-picoline, 99%
| 1603-41-4 |
|
Lead subacetate
| 1335-32-6 |
|
5,6-Diamino-2,4-dihydroxypyrimidine hemisulfate, hydrate, 98%
| 63981-35-1 |
|
Trans-2-Heptene, 97%
| 14686-13-6 |
|
Lead Sulfide
| 1314-87-0 |
|
Uric acid, 99+%
| 69-93-2 |
|
Tetrabutylammonium Perchlorate, 99% (Titr.)
| 1923-70-2 |
|
Cis-1,2,3,6-Tetrahydrophthalimide, 96%
| 27813-21-4 |
|
Lead Tetraoxide
| 1314-41-6 |
|
trans-2-Methylcyclohexanol, 97%
| 7443-52-9 |
|
Lecithin
| 8002-43-5 |
|
2-Pyridinealdoxime methochloride, 99%
| 51-15-0 |
|
4-Fluorobenzal chloride, 98%
| 456-19-9 |
|
Dimethyl cyanamide, 97+%
| 1467-79-4 |
|
d-Camphoroquinone
| 2767-84-2 |
|
Light Green SF, Yellowish
| 5141-20-8 |
|
Petroleum ether (EMD)
| 8032-32-4 |
|
2-Ethylanisole, 99%
| 14804-32-1 |
|
4-(2-Keto-1-benzimidazolinyl)piperidine, 97%
| 20662-53-7 |
|
n-Methoxymethylaza-12-crown-4, 95%
| |
|
1-Hexyne, 99%
| 693-02-7 |
|
Ethyl 1-methylpipecolinate, 97%
| 30727-18-5 |
|
Lithium
| 7439-93-2 |
|
4-Chloro-3,5-Dinitrobenzoic Acid, 99%
| 118-97-8 |
|
1,5-Hexadiene, Tech. 80+%
| 592-42-7 |
|
Lithium Bromide
| 7550-35-8 |
|
Lithium Carbonate
| 554-13-2 |
|
Myristanilide, 96% (gc)
| 622-56-0 |
|
Lithium chloride
| 7447-41-8 |
|
2,6-Di-Tert.-Butyl-P-Benzoquinone, 98%
| 719-22-2 |
|
2-Methyl-3-nitroaniline 97%
| 603-83-8 |
|
9-Amino-1,2,3,4-tetrahydroacridine hydrochloride hydrate, 99+% (tlc)
| 321-64-2 |
|
Lithium dodecyl sulfate
| 2044-56-6 |
|
Lithium Fluoride
| 7789-24-4 |
|
Silver Difluoride, 99%
| 7783-95-1 |
|
Lithium Hydroxide Anhydrous
| 554-13-2 |
|
Lithium Hydroxide Monohydrate
| 1310-66-3 |
|
Lithium nitrate
| 7790-69-4 |
|
(r)-(+)-2-Phenyl-1-propanol, 99+%
| 1572-95-8 |
|
2S,4s-(+)-pentanediol, 99%
| 72345-23-4 |
|
Alpha, Alpha, Alpha-Trifluoro-M-Cresol 98+%
| 98-16-8 |
|
Thallic Trifluoroacetate
| 23586-53-0 |
|
2-(4-Chloro-3-Nitrobenzoyl)benzoic Acid, 98%
| 85-54-1 |
|
2-AMINO-QUINOLINE
| 580-22-3 |
|
4-Bromobutyl acetate, 98%
| 18991-98-5 |
|
4-Morpholinoacetophenone, 99%
| 39910-98-0 |
|
|