**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 526-75-0 |2,3-Dimethylphenol | 97 | 208-395-3 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: T
Risk Phrases: 34 24/25
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Causes burns. Toxic in contact with skin and if swallowed.Corrosive.
Potential Health Effects
Eye:
Causes eye burns. May cause chemical conjunctivitis and corneal
damage.
Skin:
Harmful if absorbed through the skin. Causes skin burns. May cause
skin rash (in milder cases), and cold and clammy skin with cyanosis
or pale color.
Ingestion:
Harmful if swallowed. May cause severe and permanent damage to the
digestive tract. Causes gastrointestinal tract burns. May cause
perforation of the digestive tract. May cause systemic effects.
Inhalation:
Causes chemical burns to the respiratory tract. Aspiration may lead
to pulmonary edema. May cause systemic effects.
Chronic:
Effects may be delayed.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Get medical aid immediately. Do NOT allow victim to rub eyes or keep
eyes closed. Extensive irrigation with water is required (at least 30
minutes).
Skin:
Get medical aid immediately. Immediately flush skin with plenty of
water for at least 15 minutes while removing contaminated clothing
and shoes. Wash clothing before reuse. Destroy contaminated shoes.
Ingestion:
Do not induce vomiting. If victim is conscious and alert, give 2-4
cupfuls of milk or water. Never give anything by mouth to an
unconscious person. Get medical aid immediately.
Inhalation:
Get medical aid immediately. Remove from exposure and move to fresh
air immediately. If breathing is difficult, give oxygen. Do NOT use
mouth-to-mouth resuscitation. If breathing has ceased apply
artificial respiration using oxygen and a suitable mechanical device
such as a bag and a mask.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam. Use agent most appropriate to extinguish
fire.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use only in a well-ventilated area. Minimize dust
generation and accumulation. Do not get in eyes, on skin, or on
clothing. Keep container tightly closed. Do not ingest or inhale.
Discard contaminated shoes.
Storage:
Keep container closed when not in use. Store in a tightly closed
container. Store in a cool, dry, well-ventilated area away from
incompatible substances. Do not store in steel container.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 526-75-0:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Chunks
Color: brown
Odor: none reported
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 217 deg C
Freezing/Melting Point: 73-76 deg C
Autoignition Temperature: Not applicable.
Flash Point: 95 deg C ( 203.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density:
Molecular Formula: C8H10O
Molecular Weight: 122.17
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat.
Incompatibilities with Other Materials:
Bases, acid anhydrides, acid chlorides, oxidizing agents, steel,
brass, copper, copper alloys.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 526-75-0: ZE5500000
LD50/LC50:
CAS# 526-75-0: Oral, mouse: LD50 = 302000 mg/m3; Oral, rat: LD50 =
562000 mg/m3; Skin, rabbit: LD50 = 1040000 mg/m3.
Carcinogenicity:
2,3-Dimethylphenol -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: T
Risk Phrases:
R 24/25 Toxic in contact with skin and if swallowed.
R 34 Causes burns.
Safety Phrases:
S 2 Keep out of reach of children.
S 28A After contact with skin, wash immediately with
plenty of water.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 526-75-0: No information available.
Canada
CAS# 526-75-0 is listed on Canada's DSL List.
CAS# 526-75-0 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 526-75-0 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 8/24/1997 Revision #5 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Cadmium cyclohexanebutyrate
| 55700-14-6 |
|
1,3-Dichloropropane, 99%
| 142-28-9 |
|
1,2,3,4-Tetrahydrocarbazole, 99%
| 942-01-8 |
|
2-Chloro-4-Nitroaniline, 99%
| 121-87-9 |
|
4,6-Dihydroxypyrimidine, 98%
| 1193-24-4 |
|
(+)-Dehydroisoandrosterone, 99% (hplc)
| 53-43-0 |
|
Tiron(R)
| 149-45-1 |
|
Allyltributyltin, 97%
| 24850-33-7 |
|
Vanadium oxobis(1-phenyl-1,3-butane- dionate)
| 14767-37-4 |
|
Alpha-Methyl-D-Mannopyranoside, 99%
| 617-04-9 |
|
4-Chloro-3-Nitrobenzyl Alcohol, 98%
| 55912-20-4 |
|
3-Ethoxyacrylic Acid Ethyl Ester
| 1001-26-9 |
|
DL-4-Amino-3-Hydroxybutyric Acid, 98%
| 352-21-6 |
|
2-Bromo-4-Methylphenol, 96%
| 6627-55-0 |
|
4-Hydroxy-3-Methoxycinnamic Acid, 99%
| 1135-24-6 |
|
2,4-Dibromothiophene, 96%
| 3140-92-9 |
|
Acridine-9-Carboxylic Acid Hydrate
| 5336-90-3 |
|
Platinum on alumina (5% pt)
| 7440-06-4 |
|
l-Methionine methylsulfonium iodide, 99% e.e.
| 34236-06-1 |
|
N,n'-diheptyl-4,4'-bipyridinium dibromide, 99% (titr.)
| 6159-05-3 |
|
Ethyl 3-exo-aminobicyclo[2.2.1]heptane-2-exo-carboxylate
| 95630-75-4 |
|
Benzenesulfonic Acid Sodium Salt, 98% (uv-vis)
| 515-42-4 |
|
3,4'-Dimethylbenzophenone
| 13152-94-8 |
|
2-Bromobutyric acid, 99%
| 80-58-0 |
|
2-Methylbutylamine, 98%
| 96-15-1 |
|
4-Bromophenyl Methyl Carbinol, 98%
| 5391-88-8 |
|
2,3-Dimethylphenol, 97% (GC)
| 526-75-0 |
|
Phorone (2,6-dimethyl-2,5-heptadien-4- one), 98%
| 504-20-1 |
|
Alpha-Cyano-4-Hydroxycinnamic Acid, 97%
| 28166-41-8 |
|
Cibacron Brilliant Yellow 3G-P
| 50662-99-2 |
|
1-Bromo-2,6-Dichlorobenzene, 99%
| 19393-92-1 |
|
3-Hydroxypiperidine Hydrochloride, 99%
| 64051-79-2 |
|
Brij?? 58, contains 0.01% BHA and 0.005% citric acid as preservatives
| 9004-95-9 |
|
3'-Ethoxyacetanilide, 99+%
| 591-33-3 |
|
2-Fluoro-5-methylsulphonylnitrobenzene 95+%
| |
|
(s)-(-)-2-Phenyl-1-propanol, 99+%
| 1517-68-6 |
|
3,6-Dichloropyridazine, 97%
| 141-30-0 |
|
2-Butoxytetrahydrofuran, 99%
| 1927-59-9 |
|
Benzethonium chloride, 97%
| 121-54-0 |
|
DL-Glyceraldehyde, 98%
| 56-82-6 |
|
Borane-N,N-diethylaniline complex
| 13289-97-9 |
|
4-Octylphenol, 99% (GC)
| 1806-26-4 |
|
Dibenzyldiselenide, 99+%
| 1482-82-2 |
|
1-Pentadecene, 98%
| 13360-61-7 |
|
5-Bromoacenaphthene, 94%
| 2051-98-1 |
|
Acetal, 99%
| 105-57-7 |
|
Niobium atomic absorption standard solution, 1 mg/ml Nb in 5% HF
| 7440-03-1 |
|
Cytochalasin A
| 14110-64-6 |
|
Cumene, 99%
| 98-82-8 |
|
Pentaerythrityl Tetrastearate (Pract)
| 115-83-3 |
|
|