**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 84-76-4 |Dinonyl phthalate | >97 | 201-560-0 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Not available.
Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. The toxicological properties of this substance have not
been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid. Do NOT use mouth-to-mouth
resuscitation.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
with caution and in flooding amounts. Water may be ineffective.
Material is lighter than water and a fire may be spread by the use of
water. Vapors may be heavier than air. They can spread along the
ground and collect in low or confined areas. Containers may explode
when heated.
Extinguishing Media:
Water may be ineffective. Use agent most appropriate to extinguish
fire. Cool containers with flooding quantities of water until well
after fire is out. Use water spray, dry chemical, carbon dioxide, or
appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Avoid runoff into storm sewers and
ditches which lead to waterways. Clean up spills immediately,
observing precautions in the Protective Equipment section. Provide
ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Wash hands before eating. Remove
contaminated clothing and wash before reuse. Use with adequate
ventilation. Avoid contact with eyes, skin, and clothing. Keep
container tightly closed. Avoid ingestion and inhalation.
Storage:
Keep away from heat, sparks, and flame. Store in a tightly closed
container. Keep from contact with oxidizing materials. Store in a
cool, dry, well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 84-76-4:
United Kingdom, WEL - TWA: 5 mg/m3 TWA
United Kingdom, WEL - STEL: 15 mg/m3 STEL
Germany: 5 mg/m3 TWA (all isomers except Diisononylphthalate)
Russia: 1 mg/m3 TWA
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: yellow-brown - clear, oily
Odor: none reported
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 279-287 deg C
Freezing/Melting Point: Not available.
Autoignition Temperature: Not applicable.
Flash Point: 216 deg C ( 420.80 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: Not available.
Solubility in water: Insoluble in water.
Specific Gravity/Density: 0.97
Molecular Formula: C26H42O4
Molecular Weight: 418.61
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 84-76-4: TI1800000
LD50/LC50:
CAS# 84-76-4: Oral, mouse: LD50 = 21500 mg/kg.
Carcinogenicity:
Dinonyl phthalate -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 84-76-4: No information available.
Canada
CAS# 84-76-4 is listed on Canada's DSL List.
CAS# 84-76-4 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 84-76-4 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 9/02/1997 Revision #5 Date: 12/01/2004
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
3-Methyl-5-Methoxycarbonyl-1-Benzyl-4-Piperidone Hydrochloride, 99%
| 0-01-1 |
|
4-Decanol, 99%
| 2051-31-2 |
|
5-Chloro-1,3-dimethoxybenzene, 97+%
| 7051-16-3 |
|
Bis-(Benzonitrile)-Palladium(II)Chloride, 99+%
| 14220-64-5 |
|
N-(1-Anilinonaphthyl-4)-Maleimide
| 50539-45-2 |
|
4-Chloro-O-Anisic Acid, 99%
| 57479-70-6 |
|
Furfuryl Mercaptan, 97%
| 98-02-2 |
|
4-Methoxybenzenethiol, 98%
| 696-63-9 |
|
6-Dimethylaminopurine
| 938-55-6 |
|
2-Amino-4,6-Dichloropyrimidine, Tech.
| 56-05-3 |
|
2,4-Dihydroxy-n-(2-Hydroxyethyl)benzamide, 99% (TLC)
| 24207-41-8 |
|
Brucine dihydrate, 99%
| 145428-94-0 |
|
2-Indanol, 99%
| 4254-29-9 |
|
Trifluoroacetic Acid, Ammonium Salt, 98%
| 3336-58-1 |
|
10-Methylphenothiazine
| 1207-72-3 |
|
Trimethyl Phosphate, P.A.
| 512-56-1 |
|
4-Bromotoluene, 99%
| 106-38-7 |
|
Ethylenediaminetetraacetic Acid Copper, Disodium Salt Dihydrate, 98%
| 61916-40-3 |
|
3-Methylsalicylic acid, 99%
| 83-40-9 |
|
5-Benzyloxytryptamine hydrochloride, 98%
| 52055-23-9 |
|
3-Formylsalicylic acid, 97%
| 610-04-8 |
|
3-Methylcyclopentanol, 99%, mixture of isomers
| 18729-48-1 |
|
L(-)-Dibenzoyl-L-tartaric acid monohydrate , 98%
| 2743-38-6 |
|
1-Phenoxy-2-propanol,97%
| 770-35-4 |
|
Ethyl 2(2-Aminothiazole-4-yl)-2-Methoxyiminoacetate, 98%
| 64485-88-7 |
|
Borane-tetrahydrofuran complex, 1M solution in tetrahydrofuran
| 109-99-9 |
|
N-Phenyl-P-Phenylenediamine Monohydro-Chloride, 99% (Titr.)
| 2198-59-6 |
|
Dipentaerythritol, 90%
| 126-58-9 |
|
2,4'-Dipyridyl, 97+%
| 581-47-5 |
|
N,N-Bis(2-Cyanoethyl)Formamide
| 3445-84-9 |
|
L-(+)-Lysine Monohydrate 99%
| 39665-12-8 |
|
Albizziin, 98%
| 1483-07-4 |
|
2-Methyltetrahydrofuran-3-one, 98%
| 3188-00-9 |
|
N-Acryloyltris(Hydroxymethyl)aminomethane (Nat)
| 13880-05-2 |
|
Sulforhodamine 101 (Free Acid), Laser Grade, 99% (UV-Vis)
| 82354-19-6 |
|
Progesterone, 98%
| 57-83-0 |
|
5-Bromo-2-Fluorobenzaldehyde, 98%
| 93777-26-5 |
|
5-Amino-3-Methylisothiazole Hydrochloride
| 52547-00-9 |
|
Pentafluoropropionic Anhydride
| 356-42-3 |
|
Albumine bovine serum,additional reagent for igss, protease free
| |
|
D-(+)-Methioninol
| 87206-44-8 |
|
alpha-Chloro-o-xylene, 99%
| 552-45-4 |
|
2-(5-Bromo-2-Pyridylazo)-5- (Diethylamino)Phenol, 99+% (Titr.)
| 14337-53-2 |
|
(S)-(+)-alpha-Methoxy-alpha-trifluoro-methylphenylacetyl chloride,
| 20445-33-4 |
|
(1S,2S,3R,5S)-(+)-2,3-Pinanediol, 98%
| 18680-27-8 |
|
Molecular Sieves, 3A, 8 to 12 Mesh
| 308080-99-1 |
|
1-Methyl-4-piperidone, 98%
| 1445-73-4 |
|
2-Amino-6,7-Dimethyl-4-Hydroxypteridine
| 611-55-2 |
|
Dinonyl Phthalate
| 84-76-4 |
|
Phenyl sulfoxide, 97%
| 945-51-7 |
|
|