ITW PHILADELPHIA RESINS -- WEAREX ADHESIVE HARDENER
=======================================================
Material Safety Data Sheet
=======================================================
MSDS Num: CCNFJ
MSDS NAME: WEAREX ADHESIVE HARDENER
Kit Part: Y
Responsible Party
Name: ITW PHILADELPHIA RESINS
Address: 130 COMMERCE DR
City: MONTGOMERYVILLE PA 18936
Info Phone: 215-855-8450
Emergency Phone Number: 800-424-9300 (CHEMTREC)
Proprietary Ind: Y
Published: Y
=======================================================
Contractor Summary
=======================================================
Name: ITW PHILADELPHIA RESINS
Address: 130 COMMERCE DR
City: MONTGOMERYVILLE PA 18936
Phone: 215-855-8450
Name: ITW PHILADELPHIA RESINS
Address: 130 COMMERCE DRIVE
Box: 454
City: MONTGOMERYVILLE PA 18936
Phone: 508-777-1100
=======================================================
Ingredients
=======================================================
Name: *** PROPRIETARY ***
-----------------------------
=======================================================
Health Hazards Data
=======================================================
LD50 LC50 Mixture: SEE INGREDIENT 3.
Route Of Entry Inds - Inhalation: YES
Skin: YES
Ingestion: YES
Carcinogenicity Inds - NTP: NO
IARC: NO
OSHA: NO
Effects of Exposure: ACUTE: EYES/SKIN: SEVERE IRRITANT. INHAL: PRODUCT IS LOW
IN VOLATILITY. IF PROD IS HEATED TO HIGH TEMPS, VAPORS MAY BE GENERATED WHICH
MAY CAUSE NASAL IRRIT. INGEST: MAY CAUSE GASTROINTESTINAL DISTRES S,
IRRITATION/ULCERATION. CHRONIC: REPEATED EXCESSIVE OVEREXP MAY CAUSE ASTHMA
& SKIN SENSIT, CNS DEPRESS/LUNG DAMAGE.
Explanation Of Carcinogenicity: NOT RELEVANT.
Signs And Symptions Of Overexposure: SEE HEALTH HAZARDS.
Medical Cond Aggravated By Exposure: PREEXISTING SKIN, AND EYE DISORDERS MAY BE
AGGRAVATED BY EXPOSURE TO THIS PRODUCT.
First Aid: EYES: FLUSH W/CLEAN WATER FOR AT LEAST 30 MINUTES WHILE GENTLY
HOLDING EYELIDS OPEN. GET IMMED MED ATTENTION. SKIN: IMMED REMOVE
CONTAMINATED CLOTHING, & WASH W/PLENTY OF SOAP & WATER. GET MED ATTN
IF SYMPTOMS PERSIST. INHALATION: REMOVE PATIENT TO FRESH AIR. ADMIN OXYGEN
IF BREATHING IS DFCLT. GET MED ATTN. INGEST: DO NOT INDUCE VOMIT. GIVE
PATIENT MILK/WATER TO DILUTE. IMMED CONSULT MD.
=======================================================
Handling and Disposal
=======================================================
Spill Release Procedures: AVOID PERSONAL CONTACT. SCRAPE UP AS MUCH MATERIAL AS
POSSIBLE AND PLACE IN A SUITABLE, LABELED CONTAINER FOR WASTE DISPOSAL.
RESIDUE MAY BE REMOVED USING A SAFETY SOLVENT.
Neutralizing Agent: NONE SPECIFIED BY MANUFACTURER.
Waste Disposal Methods: DISPOSE OF IN ACCORDANCE WITH APPLICABLE LOCAL, STATE
AND FEDERAL REGULATIONS.
Handling And Storage Precautions: STORE IN COOL, DRY PLACE W/ADEQUATE
VENTILATION. KEEP AWAY FROM OPEN FLAME & HIGH TEMPS. HANDLE IN ACCORDANCE
W/THE HAZARD POTENTIAL OF CURING AGENT.
Other Precautions: IF THE MATERIAL IS SANDED OR MACHINED AFTER CURING, TAKE
APPROPRIATE PRECAUTIONS AGAINST INHALATION OF NUISANCE PARTICULATES OF SILICA
QUARTZ, A SUSPECTED HUMAN CARCINOGEN. A TLV OF 0.1 MG/M3 SHOULD B E OBSERVED.
=======================================================
Fire and Explosion Hazard Information
=======================================================
Flash Point Method: PMCC
Flash Point Text: >200F,>93C
Extinguishing Media: CARBON DIOXIDE, DRY CHEMICAL, FOAM.
Fire Fighting Procedures: WEAR NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT (FP N).
Unusual Fire/Explosion Hazard: CLOSED CONTAINERS MAY RUPTURE WHEN EXPOSED TO
HIGH HEAT.
=======================================================
Control Measures
=======================================================
Respiratory Protection: NIOSH APPROVED RESPIRATORY PROTECTION REQUIRED IN
CONFINED AREAS. FOR EMERGENCIES, A NIOSH APPROVED SCBA, OR FULL FACE
RESPIRATOR IR RECOMMENDED.
Ventilation: BREATHING OF VAPS MUST BE AVOIDED. VENT MUST BE SUFFICIENT TO
CONTROL VAPORS. IN CONFINED AREAS, LOC VENT MAY REQUIRED.
Protective Gloves: CHEMICAL RESISTANT RUBBER GLOVES.
Eye Protection: ANSI APPRVD CHEM WORKERS GOGG (SUP DAT)
Other Protective Equipment: EMERGENCY EYEWASH AND DELUGE SHOWER MEETING ANSI
DESIGN CRITERIA (FP N). CLEAN LONG-SLEEVE AND LONG LEG CLOTHING.
Work Hygienic Practices: PRACTICE GOOD HOUSEKEEPING PROCEDURES TO AVOID ALL
SKIN CONTACT AND BREATHING OF VAPORS. WASH THOROUGHLY AFTER HANDLING.
Supplemental Safety and Health: EYE PROTECTION: AND FULL LENGTH FACESHIELD (FP
N).
=======================================================
Physical/Chemical Properties
=======================================================
Spec Gravity: 1.44
Evaporation Rate & Reference: NON-VOLATILE
Solubility in Water: SLIGHT
Appearance and Odor: BLACK PASTE, WITH AMINE ODOR
=======================================================
Reactivity Data
=======================================================
Stability Indicator: YES
Stability Condition To Avoid: HEAT, SPARKS, AND OPEN FLAMES.
Materials To Avoid: STRONG ACIDS, OXIDIZING MATERIAL, MINERAL ACIDS & EPOXY
RESINS UNDER UNCONTROLLED CONDITIONS.
Hazardous Decomposition Products: CARBON MONOXIDE, CARBON DIOXIDE, AND OXIDES
OF NITROGEN.
Hazardous Polymerization Indicator: NO
Conditions To Avoid Polymerization: NOT RELEVANT.
=======================================================
Toxicological Information
=======================================================
=======================================================
Ecological Information
=======================================================
=======================================================
MSDS Transport Information
=======================================================
=======================================================
Regulatory Information
=======================================================
=======================================================
Other Information
=======================================================
=======================================================
HAZCOM Label
=======================================================
MSDS NAME: WEAREX ADHESIVE HARDENER
Company: ITW PHILADELPHIA RESINS
Street: 130 COMMERCE DRIVE
PO Box: 454
City: MONTGOMERYVILLE PA
Zipcode: 18936
Health Emergency Phone: 800-424-9300 (CHEMTREC)
Label Required IND: Y
Date Of Label Review: 10/08/1996
Status Code: C
Label Date: 10/08/1996
Origination Code: G
Chronic Hazard IND: Y
Eye Protection IND: YES
Skin Protection IND: YES
Signal Word: WARNING
Respiratory Protection IND: YES
Health Hazard: Moderate
Contact Hazard: Moderate
Fire Hazard: Slight
Reactivity Hazard: None
Hazard And Precautions: COMBUSTIBLE. ACUTE: EYES/SKIN: SEVERE IRRITANT.
INHALATION: PRODUCT IS LOW IN VOLATILITY. IF PRODUCT IS HEATED TO HIGH
TEMPERATURES, VAPORS MAY BE GENERATED WHICH MAY CAUSE NASAL IRRITATION.
INGESTION : MAY CAUSE GASTROINTESTINAL DISTRESS, IRRITATION OR ULCERATION.
CHRONIC: REPEATED EXCESSIVE OVEREXPOSURE MAY CAUSE ASTHMA AND SKIN
SENSITIZATION, CENTRAL NERVOUS SYSTEM DEPRESSION OR LUNG DAMAGE.
=======================================================
Disclaimer (provided with this information by the compiling agencies): This
information is formulated for use by elements of the Department of Defense.
The United States of America in no manner whatsoever expressly or implied
warrants, states, or intends said information to have any application, use or
viability by or to any person or persons outside the Department of Defense
nor any person or persons contracting with any instrumentality of the United
States of America and disclaims all liability for such use. Any person
utilizing this instruction who is not a military or civilian employee of the
United States of America should seek competent professional advice to verify
and assume responsibility for the suitability of this information to their
particular situation regardless of similarity to a corresponding Department
of Defense or other government situation.
*** END OF RECORD *** |
|
|
| ALL PAGES On Chemical Property IN THIS GROUP
| | NAME | CAS |
|
P/N 522894, BATTERY
| |
|
A-2 EPOXY ADHESIVE RESIN, PART A
| |
|
NAPA QUALITY TRACTOR HYDRAULIC FLUID
| |
|
MOBIL DTE 15M
| |
|
DIMPLE GREEN (INDUSTRIAL CLEANER/DEGREASER)
| 111-76-2 |
|
T-6230 TONER FOR M6230
| 27136-15-8
25869-00-5
1333-86-4 |
|
3M BRAND BATHROOM CLEANER CONCENTRATE
| 2687-94-7
79-14-1
7732-18-5
6915-15-7
68424-95-3
64-17-5 |
|
BOROTHENE SOLVENT
| |
|
PARABOND M-251
| |
|
ETCH-KLENZ, 0011
| |
|
5235 FLUX REMOVER
| 67-63-0
71-55-6 |
|
ENVIROTEX LITE RESIN, 2006
| |
|
ENVIROTEX LITE HARDENER, 2006
| |
|
POTASSIUM REAGENT C, 5162
| 7732-18-5
64-17-5
67-56-1
493-52-7 |
|
KEROSENE 1-K
| 64742-81-0
7704-34-9 |
|
KWIK SEAL TUB & TILE CAULK, 10009
| |
|
HYDROLASTIC FINISH COATING (078 LINE) 078193
| |
|
CCX-77, 0289
| |
|
EA 50
| 1343-93-7
64-19-7
67-56-1
107-21-1
548-26-5
5141-20-8 |
|
UNITED 174
| 76-13-1
75-45-6 |
|
PERMATEX FORM-A-GASKET NO 2 SEALANT, 2E
| 1332-58-7
8050-09-7
68439-93-0
67-63-0
8002-43-5 |
|
PERMATEX FORM-A-GASKET NO 2 SEALANT, 2D
| 1332-58-7
8050-09-7
68439-93-0
67-63-0
8002-43-5 |
|
PERMATEX FORM-A-GASKET NO 2 SEALANT, 2B
| 1332-58-7
8050-09-7
68439-93-0
67-63-0
8002-43-5 |
|
ST-21, POLY SPRAY JET
| 111-76-2
67-63-0
9016-45-9 |
|
CUT-THRU, 1740
| |
|
POLYDIMETHYLSILOXANE, RTV700
| |
|
ESSENTIALUBE, 01-0
| |
|
FLUSHING OIL, 93060
| 64741-88-4 |
|
CHEMLOK AP-131
| 64-17-5
108-88-3
67-56-1
71-36-3
111-76-2 |
|
POLYOL/FLUOROPOLYMER, DSX-EXTRA
| |
|
80697, SPRAY-A-GASKET COPPER HIGH TEMP ADH (SUPDAT)
| |
|
WALLBOARD JOINT COMPOUND RTU, 70288
| |
|
CHAINMATE LUBRICANT, 02416
| 107-83-5
67-63-0
110-54-3
64742-01-4
1317-33-5
68476-85-7 |
|
DURO 1M SUPER GLUE ADHESIVE REMOVER, SGR-M
| 67-64-1
7732-18-5 |
|
PRECISION CLEAN, 02728
| 6834-92-0
34590-94-8 |
|
PRECISION CLEAN, 02701
| 6834-92-0
34590-94-8 |
|
PRECISION CLEAN, 02705
| 6834-92-0
34590-94-8 |
|
WEAREX ADHESIVE HARDENER
| |
|
COLOR GUARD TOUGH RUBBER COATING-RED, 81807
| 78-93-3
64475-85-0
66070-58-4
110-54-3
108-88-3 |
|
FERROZINE IRON REAGENT, 2301
| 5421-46-5
7732-18-5 |
|
5247 UP TIGHT AD (AERO)
| 68476-86-8
110-54-3
67-64-1 |
|
AQUA ZAR SATIN, 27
| 7732-18-5
872-50-4
57-55-6 |
|
CW WHITE
| |
|
NUTS N'BOLTS 427
| 80-15-9
114-83-0
110-16-7
81-07-2 |
|
DEEP ACTION
| 1330-72-7
68439-46-3
68-04-2
7732-18-5
61789-19-3 |
|
POLYLITE 33031-00
| |
|
CITRI-CON, 0395
| |
|
CITRI-CON, 0395
| |
|
HI-TEMP OIL 101
| 64742-01-4
64741-45-3
9003-28-5
8052-42-4 |
|
SCOTCHKOTE BRAND 206N (SLOW) FUSION BONDED (SUP DAT)
| 25068-38-6
10101-39-0
1317-70-0
461-58-5
12027-58-6
14483-19-3
1308-38-9 |
|
|