LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:YES OSHA:NO
Health Hazards Acute and Chronic:IRRITATING TO SKIN AND EYES. CHRONIC
EXPOSURE MAY CAUSE SKIN SENSITIZATION.
Explanation of Carcinogenicity:CHRYSTALLINE SILICA - IARC 2A
Effects of Overexposure:NONE SPECIFIED BY MANUFACTURER.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.
======================= First Aid Measures =======================
First Aid:EYE: FLUSH EYES WITH WARM WATER FOR AT LEAST 15 MIN. SEE MD.
SKIN: FLUSH WITH PLENTY OF WATER. WASH SKIN THOROUGHLY WITH SOAP
AND WATER. DO NOT USE OTHER SOLV TO REMOVE MATL FROM SKIN. IF IRRIT
PERSIS TS SEE MD. REMOVE CONTAMD CLTHG & LAUNDER BEFORE REUSE.
INHAL: REMOVE TO FRESH AIR. INGEST: OBTAIN MED ATTN.
===================== Fire Fighting Measures =====================
Flash Point:200F,93C
Lower Limits:0.4%
Upper Limits:1.3%
Extinguishing Media:DRY CHEMICAL OR HALON FIRE EXTINGUISHER, WATER
SPRAY OR FOG, AND FOAM.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT .
Unusual Fire/Explosion Hazard:DENSE SMOKE AND TOXIC GASES MAY BE
PRODUCED UPON COMBUSTION.
Spill Release Procedures:SCRAPE UP AND TRANSFER TO METAL CONTAINER FOR
DISPOSAL. USE A RAG OR PAPER TOWEL WITH DETERGENT TO WIPE AND CLEAN
OFF REMAINING RESIDUE.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
====================== Handling and Storage ======================
Handling and Storage Precautions:STORE IN A COOL DRY PLACE. DO NOT MIX
IN BATCHES OF GREATER THAN ONE POUND TOTAL. FOLLOW RECOMMENDED
CURING PROCEDURES.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.
Respiratory Protection:NOT REQUIRED IF VENTILATION IS SUFFICIENT.
Ventilation:LOCAL EXHAUST VENTILATION IS RECOMMENDED. GENERAL
VENTILATION MAY BE ACCEPTABLE.
Protective Gloves:IMPERVIOUS PLASTIC OR RUBBER GLOVES.
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:AS NEEDED TO PROTECT SKIN AND CLOTHING.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
CNDTNS (POLYM): BONDED. FAILURE TO OBSERVE CAUTIONS MAY RESULT IN
EXCESSIVE HEAT BUILD-UP WITH THE RELEASE OF TOXIC GASES.
HCC:N1
Boiling Pt:B.P. Text:531F,277C
Vapor Pres:<0.01
Vapor Density:>1
Spec Gravity:0.98
Solubility in Water:20%
Appearance and Odor:AMBER LIQUID WITH SLIGHT AMMONIA LIKE ODOR.
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS, STRONG LEWIS ACIDS OR MINERAL ACIDS.
Stability Condition to Avoid:NONE
Hazardous Decomposition Products:CO, CO*2, NO*X, ALDEHYDES, ORGANIC
ACIDS, AND UNDETERMINED ORGANICS.
Conditions to Avoid Polymerization:AVOID MIXING RESIN AND CURING AGENT
IN BATCHES >ONE LB TOTAL. DO NOT HEAT MATL UNLESS CURING SURF TO BE
(SEE SUPP DATA)
Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE, AND
FEDERAL RULES AND REGULATIONS. APPROPRIATE DISPOSAL METHODS MAY
INCLUDE LANDFILL OR INCINERATION.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.