===================== Product Identification =====================
MSDS NAME:LOW MOISTURE SENSITIVE ZINC CHROMATE PRIMER 34151 GREEN
NIIN:00-582-5318
Status Code:A
MSDS Number: CKYPN
=== Responsible Party ===
Company:FARWEST PAINT MANUFACTURING CO
Address:4522 SOUTH 133RD ST
City:TUKWILA
State:WA
ZIP:98168
Country:US
Info Phone Num:206-244-8844
Emergency Phone Num:(800)424-9300
Preparer's Name:HENRY SIMMONS
Chemtrec Ind/Phone:(800)424-9300
CAGE:6F266
=== Contractor Identification ===
Company:FARWEST PAINT MANUFACTURING CO
Address:4522 SOUTH 133RD ST
Box:City:TUKWILA
State:WA
ZIP:98168
Country:US
Phone:206-244-8844
CAGE:6F266
============= Composition/Information on Ingredients =============
Name:TOLUENE
CAS:108-88-3
RTECS #:XS5250000
= Wt:14.48
OSHA PEL:SEE TABLE Z-2
ACGIH TLV:188 MG/M3;50 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Name:XYLENE
CAS:1330-20-7
RTECS #:ZE2100000
= Wt:26.
ACGIH TLV:434 MG/M3;100 PPM
ACGIH STEL:651 MG/M3;150 PPM
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Name:ZINC CHROMATE
CAS:13530-65-9
RTECS #:GB3290000
= Wt:27.
ACGIH TLV:0.01 MG/M3
===================== Hazards Identification =====================
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Explanation of Carcinogenicity:THIS PRODUCT CONTAINS NO KNOWN
CARCINOGENS IN REPORTABLE QUANTITIES AS DEFINED BY ACGIH, OSHA,
NTP, IARC.
Effects of Overexposure:SKIN: THIS MATERIAL MAY CAUSE IRRITATION,
SENSITIZATION, OR DEFATTING OF SKIN UPON PROLONGED OR REPEATED
CONTACT INHALATION: EXCESSIVE EXPOSURE TO VAPORS OF SPRAY MIST CAN
RESULT IN HEADACHE, DIZZINE SS, NAUSEA AND LOSS OF CONSCIOUSNESS.
SOME REPORTS HAVE ASSOCIATED REPEATED & PROLONGED OCCUPATIONAL
OVEREXPOSURE TO SOLVENTS WITH PERMANENT BRAIN & NERVOUS SYSTEM
DAMAGE. EYES: THIS MATERIAL MAY BE AN EYE IRRITANT.
Medical Cond Aggravated by Exposure:NONE, WHEN USED IN ACCORDANCE WITH
SAFE HANDLING INSTRUCTIONS. (SEE SECTION VIII)
======================= First Aid Measures =======================
First Aid:SKIN: PROMPTLY WASH SOAP AND WATER. REMOVE AND WASH ANY
CONTAMINATED CLOTHING BEFORE REUSE. EYES: FLUSH WITH LARGE
QUANTITIES OF WATER FOR 15 MINUTES AND SEEK MEDICAL ATTENTION.
SWALLOWING: IF INGES TED DO NOT INDUCE VOMITING; KEEP PERSONWARM
AND QUIET AND GET MEDICAL ATTENTION. ASPIRATION OF MATERIAL INTO
LUNGS CAN CAUSE CHEMICAL PNEUMONITIS WHICH CAN BE FATAL.
INHALATION: REMOVE VICTIM TO FRES H AIR IMMEDIATELY, IF RESPIRATORY
SYMPTOMS DEVELOP, SEEK MEDICAL ATTENTION AT ONCE.
===================== Fire Fighting Measures =====================
Flash Point Method:TCC
Flash Point:=1.7C, 35.F
Lower Limits:1.0
Upper Limits:7.0
Extinguishing Media:FOAM, CO2, DRY CHEMICAL, OR WATER FOG. USE THE
ABOVE ANY CLADD B EXTINGUISHING AGENT.WATER MAY BE UNSUITABLE AS AN
EXTINGUISHING MEDIUM.
Fire Fighting Procedures:FIREFIGHTERS AND OTHER EXPOSED TO VAPORS OR
PRODUCTS OF COMBUSTION SHOULD WEAR SELF-CONTAINED BREATHING
APPARATUS. EVACUATE AREA OF UNPROTECTED PERSONNEL. WEAR PROTECTIVE
CLOTHING.
Unusual Fire/Explosion Hazard:VAPORS MAY FORM AN EXPLOSIVE MIXTURE IN
AIR AND MAY BE IGNITED BY SPARKS, PILOT LIGHTS, ETC. CLOSED
CONTAINERS MAY RUPTURE WHEN EXPOSED TO EXTREME HEAT.
================== Accidental Release Measures ==================
Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE
AREA. ABSORB SPILL WITH AN ABSORBENT MATERIAL SUCH AS SAWDUST,
VERMICULITE OR SAND AND PLACE MATERIAL INTO A CLOSED MATERIAL. IF
LARGE SPILL, DIKE AREA TO PRE VENT THIS MATERIAL FROM ENTERING
WATER SYSTEMS OR SEWERS. WEAR PROTECTIVE EQUIPMENT DURING CLEANUP.
====================== Handling and Storage ======================
Handling and Storage Precautions:AVOID PROLONGED OR REPEATED INHALATION
OF HEATED VAPORS OR SPRAY MIST. KEEP AWAY FROM HEAT OR OPEN FLAME.
THIS MATERIAL MAY CAUSE SENSITIZATION. DO NOT GET IN EYES, OR SKIN
OR CLOTHING. DO NOT ALLOW C ONTAMINATED CLOTHING TO CONTACT SKIN.
DO NOT WELD ON FULL OR EMPTY CONTAINERS.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:A CANISTER-TYPE RESPIRATOR MUST BE WORN TO
PREVENT THE INHALATION OF VAPORS OR SPRAY MIST WHEN THE TLV OR PEL
IS EXCEEDED.
Ventilation:GENERAL VENTILATION IS REQUIRED DURING NORMAL USE. LOCAL
VENTILATION MAY BE REQUIRED DURING CERTAIN OPERATIONS.
Protective Gloves:CHEMICAL RESISTANT NITRILE, NEOPRENE OR RUBBER GLOVES
REQUIRED.
Eye Protection:WEAR FACE SHIELD OR CHEMICAL GOGGLES.
Other Protective Equipment:WEAR PROTECTIVE CLOTHING TO PREVENT SKIN
CONTACT. EYE WASH STATION AND SAFETY SHOWER SHOULD BE AVAILABLE.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING.
Supplemental Safety and Health
THIS MATERIAL HAS BEEN CATEGORIZED AS HAVING THE FOLLOWING HAZARD(S) AS
DEFINED BY SARA TITLE III REGULATIONS (40 CFR 370): ACUTE, FIRE
THE INFORMATION IN THIS DATA SHEET IS BELIEVED TO BE ACCURATE A ND
TRUE AT THE TIME OF PREPARATION OF THIS DOCUMENT. THIS IS NOT A
WARRANTY OR PRODUCT SPECIFICATION.
================== Physical/Chemical Properties ==================
Boiling Pt:=110.6C, 231.F
B.P. Text:231-284F
Vapor Pres:22MMHG@20C
VOC Pounds/Gallon:506
Evaporation Rate & Reference:SLOWER THAN ETHEL
Solubility in Water:NIL
Appearance and Odor:GREEN LIQUID, AROMATIC ODOR
Percent Volatiles by Volume:58.62
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
AVOID CONTACT WITH STRONG OXIDANTS, ACIDS, BASES AND EPOXY HARDENERS
UNDER UNCONTROLLED CONDITIONS
Stability Condition to Avoid:HEAT, SPARKS & OPEN FLAMES. IF PRODUCT
CONTAINS ALUMINUM, MOISTURE IN CLOSED CONTAINERS WILL GENERATE
HYDROGEN GAS.
Hazardous Decomposition Products:INCOMPLETE COMBUSTION CAN YIELD CARBON
MONOXIDE AND TOXIC VAPORS.
Conditions to Avoid Polymerization:WILL NOT OCCUR.
==================== Disposal Considerations ====================
Waste Disposal Methods:IF DISCARDED, THIS MATERIAL AND CONTAINERS
SHOULD BE TREATED AS HAZARDOUS WASTE BASED ON THE CHARACTERISTICS
OF IGNITABILITY AS DEFINED UNDER FEDERAL AREA REGULATIONS (40 CFR
261). DISPOSAL OF THIS MA TERIAL OR ITS CONTAINERS REQUIRE
COMPLIANCE WITH APPLICABLE LABELING, PACKAGING AND RECORDKEEPING ST
ANDARDS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|