MATERIAL SAFETY DATA SHEET
HMIS HAZARD RATINGS
OSHA - Meets 29 CFR 1910.1200 Standards
HEALTH 0 = INSIGNIFICANT 3 = HIGH
1
FLAMMABILITY 1 = SLIGHT 4 = EXTREME
0
REACTIVITY 2 = MODERATE
0
TRANSPORTATION INFORMATION
PROPER SHIPPING NAME: Not Regulated
HAZARD CLASS / PKG GRP: Not regulated Not Applicable
REF:
IDENTIFICATION NUMBER: None None Required
LABEL:
SECTION 1 - PRODUCT / COMPANY IDENTIFICATION
IDENTITY (AS USED ON LABEL AND LIST)
Page 1 of 2
SD - 25
MANUFACTURER'S NAME EMERGENCY TELEPHONE NUMBER
Gator Chemical CHEM 鈥? TEL (800) 255-3924 Outside USA (813) 248-0585
ADDRESS (NUMBER, STREET, P.O. BOX) TELEPHONE NUMBER FOR INFORMATION
P.O. Box 1990 (727) 584-5174
(CITY, STATE AND ZIP CODE) DATE PREPARED: January 12, 2004
Largo, FL 33779 SUPERSEDES: New
SECTION 2 - HAZARDOUS INGREDIENTS / IDENTITY INFORMATION
OSHA PEL ACGIH TWA
HAZARDOUS COMPONENTS % SARA RQ
CAS #
TITLE III LBS
(OPTIONAL) PPM MG/M3 PPM MG/M3
(SPECIFIC CHEMICAL IDENTITY; COMMON NAME(S))
Quaternary Ammonium Compound 5.85
n-Alkyl dimethyl benzyl ammonium chloride 68424-95-3 not established
Alkyl (C12-C16) dimethyl benzyl ammonium chloride 68424-85-1 not established
SECTION 3 - HEALTH HAZARD DATA
ROUTES OF ENTRY - SIGNS AND SYMPTOMS OF EXPOSURE EMERGENCY AND FIRST AID PROCEDURES
INHALATION: Inhalation of mists or vapors may cause irritation to upper Remove affected person to fresh air; if symptoms persist seek medical
respiratory tract and mucous membranes. attention.
SKIN: Contact with skin may cause irritation, dermatitis. Remove contaminated clothing; wash affected area with soap and water;
launder contaminated clothing before reuse; if irritation persists, seek medical
attention.
EYES: Contact with eyes may cause pain and irritation. Remove contact lenses. Flush eyes with water for 15 minutes; if irritation
persists, seek medical attention.
INGESTION: May be irritating to digestive tract; may cause gastric distress, Give two glasses of water for dilution; DO NOT induce vomiting; never give
stomach pains. anything by mouth to an unconscious person; seek medical attention.
CARCINOGENICITY No No No
NTP? IARC MONOGRAPHS? OSHA REGULATED?
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Preexisting skin, eye, or respiratory disorders may become aggravated through
prolonged exposure.
Form revised 09 / 01
MATERIAL SAFETY DATA SHEET
IDENTITY (AS USED ON LABEL AND LIST) Page 2 of 2
SD - 25 Date: January 12, 2004
SECTION 4 - FIRE FIGHTING MEASURES
FLASH POINT (METHOD USED) NFPA RATING FLAMMABLE LIMITS
Non-flammable None LEL: Not applicable UEL: Not applicable
EXTINGUISHING MEDIA
Carbon dioxide, water, water fog, dry chemical, chemical foam
SPECIAL FIRE FIGHTING PROCEDURES
Keep containers cool with water spray to prevent container rupture due to steam buildup; floor will become slippery if material is released.
UNUSUAL FIRE AND EXPLOSION HAZARDS
None
SECTION 5 - ACCIDENTAL RELEASE MEASURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Small spills - wash to sanitary sewer with plenty of water. Large spills - confine spill,
soak up with approved absorbent, shovel product into approved container for disposal. Wash area with plenty of water. Do not discharge into lakes, ponds,
streams or public waters.
SECTION 6 - HANDLING AND STORAGE
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Keep container closed when not in use; protect containers from abuse; protect from extreme
temperatures. Keep this and other chemicals out of reach of children.
SECTION 7 - EXPOSURE CONTROLS / PERSONAL PROTECTION
RESPIRATORY PROTECTION (SPECIFY TYPE): None required while threshold limits are kept below maximum allowable concentrations; if TWA exceeds
standard workplace limits, NIOSH approved respirator must be worn. Refer to 29 CFR 1910.134 or European Standard EN 149 for complete regulations.
VENTILATION LOCAL EXHAUST: Required SPECIAL: To maintain minimum TWA and STEL levels.
MECHANICAL (GENERAL): Yes OTHER: Engineering and work controls as required.
PROTECTIVE GLOVES: Neoprene or rubber gloves with cuffs. EYE PROTECTION: Protective eyeglasses or chemical safety goggles.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Coveralls, apron, or other equipment should be worn to minimize skin contact.
WORK / HYGIENIC PRACTICES: Practice safe workplace habits. Minimize body contact with this, as well as all chemicals in general.
SECTION 8 - PHYSICAL / CHEMICAL PROPERTIES
BOILING POINT SPECIFIC GRAVITY (WATER = 1)
212掳 F 0.989
VAPOR PRESSURE (MM Hg) pH
17 mm Hg @ 20 掳 C 7.0 - 8.0
VAPOR DENSITY (AIR = 1) EVAPORATION RATE (WATER = 1)
>1 <1
SOLUBILITY IN WATER % VOLATILE (BY WEIGHT)
Complete 91%
APPEARANCE AND ODOR
Colorless liquid, characteristic odor
SECTION 9 - STABILITY AND REACTIVITY
CONDITIONS TO AVOID: Extreme temperatures
STABILITY UNSTABLE:
STABLE: XXX
INCOMPATIBILITY (MATERIALS TO AVOID): Strong oxidizers, strong acids
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: Decomposition will not occur if handled and stored properly. In case of a fire, oxides of carbon,
hydrocarbons, fumes, and smoke may be produced.
HAZARDOUS POLYMERIZATION MAY OCCUR: CONDITIONS TO AVOID:
WILL NOT OCCUR: XXX None
SECTION 10 - DISPOSAL CONSIDERATIONS
WASTE DISPOSAL METHOD: Dispose of in accordance with Local, State, and Federal Regulations; do not discharge into lakes, ponds, streams or public
waters. Product is classified as non - hazardous, however, non-hazardous materials may become hazardous waste upon contact with other products. Refer to
"40 CFR Protection of Environment Parts 260 - 299" for complete waste disposal regulations. Consult your local, state, or Federal Environmental Protection
Agency before disposing of any chemicals.
The information contained herein is believed to be accurate but is not warranted to be so. Data and calculations are based on information furnished by the
manufacturer of the product and manufacturers of the components of the product. Users are advised to confirm in advance of need that information is current,
applicable and suited to the circumstances of use. Vendor assumes no responsibility for injury to vendee or third persons proximately caused by the material if
reasonable safety procedures are not adhered to as stipulated in the data sheet. Furthermore, vendor assumes no responsibility for injury caused by abnormal use
of this material even if reasonable safety procedures are followed. Any questions regarding this product should be directed to the manufacturer of the product as
described in Section 1.
MSDS PREPARED BY: CDB, Inc., P.O. Box 5604, Lakeland, FL 33807 (863) 644 - 3298 www.compdatabase.com
|