LPS LABORATORIES
MSDS
MATERIAL SAFETY DATA SHEET
Section 1 - Product Identification and Use
Manufacturer's Name: Trade Name:
LPS Laboratories LPS Force 842掳 Dry Moly Lubricant
Address (Number Street): Chemical Family:
4647 Hugh Howell Road Aliphatic and Oxygenated Hydrocarbons
Address (City, State, Zip): Part Numbers:
Tucker, GA 30085-5052 02516
Telephone Number: 770-934-7800
Emergency Telephone Number: 1-800-424-9300 Chemtrec
Outside U.S.: (703) 527-3887
Hazardous Materials Description and proper shipping name (49 CFR 172.101): Compound,Boiler, Preserving Liquid
NMFC 50093 SUB 2 BRL/BXS CL55 CONSUMER COMMODITY ORM-D
TSCA Inventory: HMIS Labeling: Health: 1
All of the ingredients are listed on the TSCA inventory. Flammability: 3
Reactivity: 0
Section 2 - Hazardous Ingredients / Identity Information
Ingredients CAS Numbers %WW OSHA PEL ACGIH TLV OTHER LIMITS
Isohexane 107-83-5 40-50 500 ppm 500 ppm 1,000 ppm STEL
Isopropyl Alcohol; Isopropanol 67-63-0 15-25 400 ppm 400 ppm 500 ppm STEL
n-Hexane 110-54-3 1-2 50 ppm 50 ppm -
Aromatic 100 64742-95-6 1-2 100 ppm 25 ppm NE
Molybdenum Disulfide 1317-33-5 3-4 15 mg/m3* N.E. None
Isobutane/Propane Propellant 68476-85-7 20-30 1,000 ppm N.E. None
* Nuisance dust
Section 3 - Physical / Chemical Characteristics
Boiling point (F潞): 141掳 Specific gravity (H20 = 1): 0.750
Vapor pressure @ 20潞C: 40-50 PSIG Percent volatile by volume (%): 95%
Vapor density (Air = 1): Approx. 3.0 Evaporation rate (Ethyl Ether = 1): <1
Solubility in water: <25%
Appearance/Odor: Gray, black liquid with mild alcohol odor.
Section 4 - Fire and Explosion Hazard
Flash point (method used): N.E. (aerosol package) Flammable limits: LEL = N.E. UEL = N.E.
Extinguishing media: Foam, Carbon Dioxide, Dry Chemical.
Firefighting procedures: Wear self-contained breathing apparatus approved by NIOSH. Use water to keep containers
cool.
Unusual fire and explosive hazards: Intense heat created by fire will cause aerosols to burst. Flammable vapors which
are heavier than air may accumulate in low areas and/or spread along the ground away from handling site.
Section 5 - Health Hazard Data
N.E. = Not established
N.A. = Not applicable
Primary route(s) of entry: Eyes, inhalation, skin.
Health hazard/effects of over exposure:
Eyes: Vapor and liquid may cause irritation.
Skin: Prolonged or repeated contact may cause drying of skin. Can be absorbed through skin.
Inhalation: Headache, light headedness, giddiness, central nervous system depression. May irritate mucosal tissue at
high concentration.
Ingestion: Unlikely route of exposure. However, minute amounts aspirated into lungs during ingestion may cause
chemical pneumonia.
Medical conditions aggravated by exposure: Pre-existing respiratory disorders.
Chemicals listed as potential carcinogen: NTP: No IARC: No OSHA: No
Emergency and first aid procedures:
Eyes: Flush with plenty of cold water and contact physician.
Skin: Wash with soap and water; apply medicated skin cream.
Inhalation: Move to fresh air and contact physician. Give oxygen if indicated.
Ingestion: Do not induce vomiting. Contact physician immediately
Section 6 - Reactivity Data
Stability: Stable
Conditions to avoid: Open flames, electric arcs and other hot surfaces which may cause thermal decomposition.
Incompatibility (Materials to avoid): Oxygen and strong oxidizing agents.
Hazardous decomposition products: Carbon monoxide, carbon dioxide, if burned.
Hazardous polymerization: Will not occur.
Section 7 - Precautions for Safe Handling and Use
Steps to be taken when material is released or spilled: Evacuate area and ventilate. Remove leaking container and transfer
remaining product to another vessel. Mop or soak up spill with absorbent material and transfer to disposal drums using non-sparking
equipment. Store in closed containers. Do not flush product to sewer.
Waste disposal methods: Dispose of in accordance with federal, state and local regulations for flammable hydrocarbons.
RCRA Hazardous Waste No.: This material has the RCRA characteristic of ignitability and if discarded in its purchased form, would
have the hazardous waste number D001.
CERCLA Reportable Quantity: 100 lbs.
SARA TITLE III Chemicals: Yes. CAS # 110-54-3.
Precautions to be taken in handling and storage: Store aerosols below 120潞F and above 32潞F. Store away from ignition sources
and avoid breathing vapors and prolonged skin contact. Vapors will collect in low areas. Use and store with adequate ventilation.
Section 8 - Control Measures
Respiratory Protection: None required if good ventilation is maintained. If vapor concentration rises above TLV, use NIOSH
approved organic respirator or self-contained breathing apparatus.
Ventilation: Use adequate ventilation to maintain TLV and prevent accumulation of vapors in low lying areas.
Protective Gloves: Use solvent resistant gloves for liquid handling (Buna-N or Neoprene).
Eye protection: Goggles if splashing is likely.
Other protective equipment: None
Work/hygienic practices: Do not get in eyes, skin, or clothing. Remove contaminated clothing and launder before reuse.
Section 9 - Preparation Date of MSDS
The foregoing technical information and recommendations are compiled from sources that are believed to be accurate and reliable.
However, they are supplied without warranty or guarantee of any kind either expressed or implied. The purchaser is responsible for
selecting and determining the suitability of products for purchaser鈥檚 particular needs and we disclaim any responsibility for improper
applications or misuse of our products in any manner whatsoever.
January 31, 2003
Fred Fugitt, Technical Services Chemist
Ed Williams, Manager of Research and Development Form # 2518
LPS Laboratories MSDS LPS Force 842掳 Dry Moly Lubricant
|