Page 1 of 2
Material Safety Data Sheet
Date last revised: 15 December 2005
I. General Information
Chemical Name and Synonyms Trade Name & Synonyms
Sumithrin Anvil 10+10 ULV
Piperonyl Butoxide
Chemical Family EPA Registration Number
Synergized Synthetic Pyrethroid 1021-1688-8329
Proper DOT Shipping Name DOT Hazard Classification
Environmentally Hazardous Substances, Liquid, N.O.S., Class 9, UN 3082 [bulk only]
Marine Pollutant (d-Phenothrin) [bulk only]
Manufacturer Manufacturer鈥檚 Phone Number
Clarke Mosquito Control Products, Inc. (630) 894-2000
Manufacturer鈥檚 Address INFOTRAC (Emergency) Hotline
159 North Garden Avenue 1-800-535-5053
Roselle, Illinois 60172
II. Ingredients
Principal Hazardous Components CAS # Percent
Sumithrin庐 [3-Phenoxybenzyl-(1RS, 3RS; 1RS, 3SR) 2,2- 026002-80-2
dimethyl-3-(2-methylprop-2-enyl) cyclopropane-carboxylate] 10.00%
Piperonyl Butoxide [Alpha-(2-(1-butoxyethoxy)-4,5- 000051-03-6 10.00%
methylenedioxy-2-propyltoluene]
Petroleum Distillates 1 鈥? 15%
Inert Ingredients are propriety or non-hazardous. Values
are not product specifications 40 鈥?78%
III. Physical Data
Specific Gravity (H2O = 1): 0.884
Boiling Point (掳F): Not Established
Vapor Pressure (mm Hg.): Not Established Vapor Density (Air = 1): Not Established
Solubility in Water: Emulsifiable pH: Not Applicable
Appearance: Liquid, Clear with a light yellow tinge Odor: Pungent aromatic, similar to smell of mothballs
IV. Fire & Explosion Hazard Data
Flash Point (Test Method: +200 掳F (Tag Closed Cup)
Extinguishing Media: Foam, carbon dioxide, or dry chemical
Special Fire Fighting Procedures: Treat as an oil fire. Use a full-faced self-contained breathing apparatus along with
full protective gear. Keep nearby containers and equipment cool with a water stream. Contain the run-off, if possible, for
proper disposal.
V. Health Hazard Data
Exposure Limits: Not established by OSHA or ACGIH
EMERGENCY FIRST AID
Skin Contact: CAUTION. Can cause a burning sensation on more sensitive areas (face, eyes, mouth). Prolonged or repeated
exposure can cause irritation and reddening of the skin, possibly progressing into dermatitis. Immediately flush affected area with large
amounts of water. Remove contaminated clothing and wash affected areas with soap and water. If irritation persists, get medical
attention.
Eye: CAUTION. Can cause temporary irritation, tearing, and blurred vision. Hold eye open and rinse slowly and gently with water for
15-20 minutes. Remove contact lenses, if present, after the first 5 minutes, then continue rinsing Call a poison control center or doctor
for treatment advice.
Inhalation: CAUTION. Excessive inhalation can cause nasal and respiratory irritation. Remove affected person to fresh air. Give
oxygen, if necessary. If breathing has stopped, administer artificial respiration and get medical attention immediately
Ingestion: CAUTION. Can cause stomach irritation, resulting in nausea, cramps and vomiting. Excessive ingestion can cause nervous
system disorders, such as fatigue, dizziness, headaches, lack of coordination, tremors and unconsciousness. Do not induce vomiting
because of aspiration pneumonia hazard. Call a physician or poison control center.
Page 2 of 2
Material Safety Data Sheet Anvil 10+10 ULV
Date last revised: 15 December, 2005
VI. Reactivity Data
Stable
Stability:
Strong acidic or alkaline materials
Incompatibility
Not Applicable
Hazardous Decomposition
Products
VII. Environmental Protection Procedures
Spill Response:
Shut off ignition sources. Stop release, if possible without risk. Dike or contain release, if possible, and if immediate
response can prevent further damage or danger. Isolate and control access to the release area. Take actions to reduce
vapors. Absorb with appropriate absorbent. For large spills, collect product into drums, etc., via drains, pumps, etc.
Absorb with appropriate absorbent. Clean spill area of residues and absorbent. Contaminated absorbent and wash water
should be disposed of according to local, state and federal regulations.
Storage:
Store containers upright and closed. Store in areas that are cool, dry and well ventilated. Keep away from heat, ignition
sources and strong oxidizers. Emptied contained may retain product residues.
Waste Disposal:
Do not contaminate water when disposing of equipment wash waters. Do not discharge effluent containing this product
into lakes, streams, ponds, estuaries, oceans, or other waters unless in accordance with the requirements of a National
Pollutant Discharge Elimination System (NPDES) permit and the permitting authority has been notified in writing prior to
discharge. Do not discharge effluent containing this product into sewer systems without previously notifying the sewage
treatment plant authority. For guidance, contact your State Water Board or Regional Office of the EPA. Do not mix with
other waste materials.
VIII. Special Protection Information
Eye Protection: OSHA-approved safety glasses, goggles Skin Protection: Handlers should wear protective clothing,
or face shield chemical resistant gloves, and chemical resistant apron
when cleaning mixing or loading.
Respiratory Protection: Not required Ventilation: Mechanical ventilation should be used when
handling this product in enclosed spaces.
Other: IMPORTANT. Read and observe all precautions and instructions on the label.
IX. Additional Regulatory Information
SARA Title III Data
Section 313: (Title III Superfund Amendment and Reauthorization Act)
This product contains the following toxic chemicals subject to the reporting requirements of section 313 of Title III of the
Superfund Amendments and Reauthorization Act of 1986 and 40 CFR Part 372.
Ingredient CAS Number Percentage (by weight)
Piperonyl butoxide 51-03-6 10.0%
Fire
NFPA Code Key
4 = Severe
3 = Serious
1
Health Reactivity 2 = Moderate
1 0 1 = Minimal
The information and statements herein are believed to be reliable but are not to be construed as a warranty or
representation for which we assume legal responsibility. Users should undertake sufficient verification and
testing to determine the suitability for their own particular purpose of any information or products referred to
herein. NO WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE IS MADE.
|