802252PM Page 1 of 5
01-03-2002
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
REVISION DATE: 12-19-2001 03-22-2001
SUPERSEDES:
SECTION 1: CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
COMPANY INFORMATION
Foster Products Corporation
H.B. Fuller Company Subsidiary
2900 Granada Lane
Oakdale, MN 55128
Phone: 651-236-3700
Medical Emergency Phone Number (24 Hours): 1-888-853-1758
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
PRODUCT INFORMATION
PRODUCT IDENTIFIER: 802252PM
PRODUCT NUMBER: FD3016
PRODUCT NAME: FOSTER 30-16
REGISTERED TRADE NAME: ANTI-ABRASION COATING
TRADEMARK: ANTI-ABRASION COATING鈩?
PRODUCT DESCRIPTION: Coating
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
Unlisted ingredients are not 'hazardous' per the Occupational Safety and Health Administration Hazard
Communication Standard (29 CFR 1910.1200) and/or are not found on the Canadian Workplace Hazardous
Materials Information System ingredient disclosure list. See Section 8 for any additional exposure limit guidelines.
Chemical Name CAS # PERCENT OSHA PEL
Bentonite clay 1302-78-9 0.1 - 1 Not established
Titanium dioxide 13463-67-7 TWA (Total dust) 10 MG/M3
Crystalline silica 14808-60-7 TWA (Respirable dust) 0.1 MG/M3
Vinyl acetate 108-05-4 0.1 - 1 TWA 10 ppm
STEL 20 ppm
SECTION 3: HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Cancer hazard.
HMIS RATING: HEALTH -- 0 FLAMMABILITY -- 0 REACTIVITY -- 0
802252PM Page 2 of 5
01-03-2002
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
See SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION for personal protective equipment
recommendations.
POTENTIAL HEALTH EFFECTS BY ROUTE OF ENTRY
EYE: No irritation hazard in normal industrial use.
SKIN: No irritation hazard in normal industrial use.
INHALATION: No irritation hazard in normal industrial use. Inhalation of dusts produced during cutting, grinding
or sanding of this product may cause irritation of the respiratory tract.
Overexposure to crystalline silica may cause silicosis.
INGESTION: Ingestion is not an anticipated route of exposure.
LONG-TERM (CHRONIC) HEALTH EFFECTS
TARGET ORGAN(S): Lungs
REGULATED CARCINOGEN STATUS:
Unless noted below, this product does not contain regulated levels of NTP, IARC, ACGIH, or OSHA listed
carcinogens.
Crystalline silica
Vinyl acetate
EXISTING HEALTH CONDITIONS AFFECTED BY EXPOSURE: Lung disease
SECTION 4: FIRST AID MEASURES
IF IN EYES: Use an eye wash to remove a chemical from your eye regardless of the level of hazard. Flush the
affected eye for at least twenty minutes. Tilt the head to prevent chemical from transferring to the uncontaminated
eye. Seek medical advice after flushing.
IF ON SKIN: Wash with soap and water. Get medical attention if irritation develops or persists.
IF VAPORS INHALED: This material does not present a hazard if inhaled. Remove individual to fresh air after an
airborne exposure if any symptoms develop, as a precautionary measure.
IF SWALLOWED: No hazard in normal industrial use. Do not induce vomiting. Seek medical attention if
symptoms develop. Provide medical care provider with this MSDS. Induce vomiting as a last measure. Induced
vomiting may lead to aspiration of the material into the lungs potentially causing chemical pneumonitis that may be
fatal.
SECTION 5: FIRE FIGHTING MEASURES
FLASH POINT: Non flammable
AUTOIGNITION TEMPERATURE: Not established
LOWER EXPLOSIVE LIMIT (% in air): Not established
UPPER EXPLOSIVE LIMIT (% in air): Not established
EXTINGUISHING MEDIA: Use water spray, foam, dry chemical or carbon dioxide.
UNUSUAL FIRE AND EXPLOSION HAZARDS: There is a possibility of pressure buildup in closed containers
when heated. Water spray may be used to cool the containers.
SPECIAL FIRE FIGHTING INSTRUCTIONS: Persons exposed to products of combustion should wear self-
contained breathing apparatus and full protective equipment.
HAZARDOUS COMBUSTION PRODUCTS: Carbon dioxide, Carbon monoxide
802252PM Page 3 of 5
01-03-2002
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
SECTION 6: ACCIDENTAL RELEASE MEASURES
SPECIAL PROTECTION: No adverse health effects expected from the clean-up of spilled material.
Follow personal protective equipment recommendations found in Section 8
of this MSDS.
CLEAN-UP: Dike if necessary, contain spill with inert absorbent and transfer to containers
for disposal. Keep spilled product out of sewers, watersheds, or water
systems.
Transport Emergency Phone Number (CHEMTREC): 1-800-424-9300
SECTION 7: HANDLING AND STORAGE
Handling: No special handling instructions due to toxicity.
Storage: Store in a cool, dry place.
Consult the Technical Data Sheet for specific storage instructions.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
EYE PROTECTION: Wear safety glasses when handling this product.
SKIN PROTECTION: Avoid skin contact by wearing chemically resistant gloves.
GLOVES: Not normally required. Use nitrile gloves if conditions warrant.
RESPIRATORY PROTECTION: No respiratory protection required under normal conditions of use.
Respirators should be selected by and used following requirements
found in OSHA's respirator standard (29 CFR 1910.134).
VENTILATION: Use local exhaust ventilation or other engineering controls to
minimize exposures.
EXPOSURE LIMITS:
Chemical Name ACGIH EXPOSURE LIMITS AIHA WEEL
Bentonite clay Not established Not established
Titanium dioxide TWA (Total dust) 10 MG/M3 Not established
Crystalline silica TWA (Respirable dust) 0.05 MG/M3 Not established
Vinyl acetate TWA 10 ppm Not established
STEL 15 ppm
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE: Liquid
COLOR: Off-white
ODOR: Mild
802252PM Page 4 of 5
01-03-2002
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
ODOR THRESHOLD: Not established
WEIGHT PER GALLON (lbs.): 13.7
SPECIFIC GRAVITY: 1.58
SOLIDS (% by weight): 69.3
pH: 7.9
BOILING POINT (deg. C): Not established
FREEZING/MELTING POINT (deg. C): Not established
VAPOR PRESSURE (mm Hg): Not established
VAPOR DENSITY: Not established
EVAPORATION RATE: Not established
OCTANOL/WATER COEFFICIENT: Not established
SECTION 10: STABILITY AND REACTIVITY
STABILITY: Stable under normal conditions.
CHEMICAL INCOMPATIBILITY: Not established
HAZARDOUS POLYMERIZATION: Will not occur.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide
SECTION 11: TOXICOLOGICAL INFORMATION
CHEMICAL NAME LD50/LC50
Bentonite clay Not established
Titanium dioxide Not established
Crystalline silica Not established
Vinyl acetate Oral LD50 Rat = 2920 mg/kg
Inhalation LC50 Rat =11400 ml/cu m
Dermal LD50 Rabbit = 2335 mg/kg
TOXICOLOGY SUMMARY: No additional health information available.
SECTION 12: ECOLOGICAL INFORMATION
OVERVIEW: No ecological information available
SECTION 13: DISPOSAL CONSIDERATIONS
To the best of our knowledge, this product does not meet the definition of hazardous waste under the U.S. EPA
Hazardous Waste Regulations 40 CFR 261. Solidify and dispose of in an approved landfill. Consult state, local or
provincial authorities for more restrictive requirements.
SECTION 14: TRANSPORTATION INFORMATION
Consult Bill of Lading for transportation information.
DOT: NOT REGULATED ,,,
SECTION 15: REGULATORY INFORMATION
INVENTORY STATUS
802252PM Page 5 of 5
01-03-2002
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
U.S. EPA TSCA: This product is in compliance with the Toxic Substances Control Act's
Inventory requirements.
If you need more information about the inventory status of this product call 651-236-5858.
FEDERAL REPORTING
EPA SARA Title III Section 313
Unless listed below, this product does not contain toxic chemical(s) subject to the reporting requirements of section
313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA) and 40 CFR part 72. EPA
has advised that when a percentage range is listed the midpoint may be used to fulfill reporting obligations.
Chemical Name CAS# %
Vinyl acetate 108-05-4 0.1 - 1
WHMIS STATUS: Unless listed below, this product is not controlled under the Canadian Workplace Hazardous
Materials Information System.
D2A
STATE REPORTING
This MSDS is not prepared for distribution in California.
SECTION 16: ADDITIONAL INFORMATION
This Material Safety Data Sheet is prepared to comply with the United States Occupational Safety and Health
Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the Canadian Workplace
Hazardous Materials Information System (WHMIS).
Prepared by: The Global Regulatory Department
Phone: 651-236-5842
The information and recommendations set forth herein are believed to be accurate. Because some of the information
is derived from information provided to Foster Products Corporation from its suppliers, and because Foster Products
Corporation has no control over the conditions of handling and use, Foster Products Corporation makes no warranty,
expressed or implied, regarding the accuracy of the data or the results to be obtained from the use thereof. The
information is supplied solely for your information and consideration, and Foster Products Corporation assumes no
responsibility for use or reliance thereon. It is the responsibility of the user of Foster Products Corporation products
to comply with all applicable federal, state and local laws and regulations.
|