MSDS No.: 299
Revision No.: 000
Revision Date: 11/03/03
庐 Page: 1 of 2
MATERIAL SAFETY DATA SHEET
Product name: CP 675 T- Firestop Board
Rigid polyurethane firestop board
Description:
Hilti, Inc. P.O. Box 21148, Tulsa, OK 74121
Supplier:
1 800 424 9300 (USA, PR, Virgin Islands, Canada); 001 703 527 3887 (other countries)
Emergency # (Chem-Trec.):
INGREDIENTS AND EXPOSURE LIMITS
This product is regarded as an 鈥渁rticle鈥? by definition under OSHA Regulation 29 CFR 1910.1200 (c). CP 675T is a rigid polyurethane
firestop board. The physical form of the product precludes exposure to workers under normal conditions of use or any foreseeable
emergency.
PHYSICAL DATA
Dark red, rigid polyurethane None
Appearance: Odor:
board
3 3
320 kg/m / 20 lb/ft Not applicable
Density: Vapor Pressure:
Not applicable
Decomposition Temp: >250潞 C / 482潞 F VOC Content:
Not applicable Not soluble
Evaporation Rate: Solubility in Water:
Not applicable Not applicable
Specific Gravity: pH:
FIRE AND EXPLOSION HAZARD DATA
Not applicable Not applicable
Flash Point: Flammable Limits:
Not applicable
Extinguishing Media:
Not applicable
Special Fire Fighting
Procedures:
None known
Unusual Fire and Explosion
Hazards:
REACTIVITY DATA
Stable. Will not occur.
Stability: Hazardous Polymerization:
None known; see special handling and storage instructions
Incompatibility:
If heated to decomposition, can yield COx, NOx, and HCN
Decomposition Products:
See handling and storage requirements.
Conditions to Avoid:
HEALTH HAZARD DATA
None known None expected
Known Hazards: Routes of Exposure:
None expected
Signs and Symptoms of
Exposure:
No ingredients are classified as a carcinogen by IARC, NTP or OSHA.
Carcinogenicity:
None known
Medical Conditions
Aggravated by Exposure:
EMERGENCY AND FIRST AID PROCEDURES
No effects expected Not a route of exposure
Skin: Inhalation:
No effects expected.
Eyes:
Not a likely route of exposure
Ingestion:
Referral to a physician is recommended if there is any question about the seriousness of any
Other:
injury/exposure.
HILTI 庐 is a registered trademark of Hilti Corp.
CONTROL MEASURES AND PERSONAL PROTECTIVE EQUIPMENT
General (natural or mechanically induced fresh air movements).
Ventilation:
As appropriate for the work area or the work being done.
Eye Protection:
Not required.
Skin Protection:
Not applicable.
Respiratory Protection:
PRECAUTIONS FOR SAFE HANDLING AND USE
For industrial use only. Keep out of reach of children. Observe good hygiene practices; i.e. wash
Handling and Storing
after using and before eating or smoking. Store in a cool dry area out of direct sunlight. Storage
Precautions:
above 140 F may degrade product.
Not applicable
Spill Procedures:
REGULATORY INFORMATION
This MSDS has been prepared in accordance with the federal OSHA Hazard Communication
Hazard Communication:
Standard. 29 CFR 1910.1200.
Health 0, Flammability 0, Reactivity 0, PPE A
HMIS Codes:
Not regulated.
DOT Shipping Name:
Not regulated.
IATA / ICAO Shipping Name:
Chemical components listed on TSCA inventory.
TSCA Inventory Status:
This product is classified as an "article" and is not subject to reporting under Section 313 of SARA
SARA Title III, Section 313:
Title III (40 CFR Part 372).
Not regulated by EPA as a hazardous waste
EPA Waste Code(s):
Consult with regulatory agencies or your corporate personnel for disposal methods that comply
Waste Disposal Methods:
with local, state, and federal safety, health and environmental regulations.
CONTACTS
1 800 879 8000 1 800 879 8000
Customer Service: Technical Service:
1 800 879 6000 Jerry Metcalf (x6704)
Health / Safety:
1 800 424 9300 (USA, PR, Virgin Islands, Canada); 001 703 527 3887 (other countries)
Emergency # (Chem-Trec):
The information and recommendations contained herein are based upon data believed to be correct; however, no guarantee or
warranty of any kind expressed or implied is made with respect to the information provided.
MSDS 299, Page 2 of 2
|