SECTION I CHEMICAL PRODUCTAND COMPANYIDENTIFICATION
-
PRODUCT NAME DECOR VARN DEAD FLAT-M7261
NUMBER DVDF
IDENTIFICATION DATE PRINTED 03/06/03
PRODUCT USE/CLASS
SUPPLIER: MANUFACTURER:
T. J. Ronan Paint Corporation T. J. Ronan Paint Corporation
749 East 135th St. "
749 East 135th St.
Bronx, NY 10454 Bronx, NY 10454
CHEMTREC: (800) 424-9300 CHEMTREC: (800) 424-9300
24 HOUR EMERGENCY HOTLINE 24 HOUR EMERGENCY HOTLINE
JD, PHONE: 718-292-1100, PREPARE DATE: 03/06/03
PRE PARER
IS LESS THAN TLV-TWA OCCUPATIONAL EXPOSURE LIMITS
WT.
PERCENT
TLV-STEL PEL-TWA
CHEMICAL NAME CAS NUMBER PEL-CEILING SKIN
GLYCOL MONOBUTYLETHER NO INFO
IIETHYLENE 5.0 t 35ppm
112-34-5 35ppm
:THYLENEGLYCOL MONOBUTYL ETHER NO
5.0 t 25ppm N.E
111-76-2 SOppm 50ppm
67-63-0 5.0 t 400 PPM 500 PPM N.E.
SOPROPANOL NO
N.E
See Section 11 for abbreviation legend)
SECTION III PHYSICAL DATA
-
BOILING RANGE: 82 999 F
- VAPOR DENSITY: Is heavier than air
ODOR : LOW SPECIFIC GRAVITY: 1.0325
Is slower than Ether
APPEARANCE : CLEAR LIQUID EVAPORATION RATE:
SOLUBILITY IN H2O: YES
VOLATILE BY WEIGHT: 79.5% VOLATILE BY VOL.: 82.4%
VOCS, lbs/gal : 4.81 VOCS, grams/ltr : 577
See Section XI for abbreviation legend)
N.A
FLASH POINT LOWER EXPLOSIVE LIMIT 0.9 %
UPPER EXPLOSIVE LIMIT 24.6 %
EXTINGUISHING MEDIA: CO2 DRY CHEMICAL FOAM
ALCOHOL FOAM
MATERIAL CAN SPLATTER ABOVE 100C/212F
UNUSUAL FIRE AND EXPLOS ION HAZARDS:
POLYMER FILM CAN BURN.
(Continued on Page 2)
~
Preparation Date
Product: DVDF Page -2
03/06/03
SPECIAL FIREFIGHTING PROCEDURES: DO NOT BREATHE FUMES. WEAR SELF-CONTAINED
BREATHING APPARATUS (PRESSURE DEMAND, MSHA/NOISH-APPROVED OR EQUIVALENT)
AND FULL PROTECTIVE GEAR. USE WATER TO KEEP FIRE EXPOSED CONTAINERS COOL
TO REDUCE PRESSURE.
SECTION V HEALTH HAZARD DATA
-
EFFECTS OF OVEREXPOSURE: INHALATION: VAPOR OR SPRAY MIST CAN CAUSE
HEADACHE, NAUSEA, AND IRRITATION OF THE NOSE, THROAT AND LUNG'S. SKIN
CONTACT: IRRITATING TO SKIN UPON REPEATED OR PROLONGED CONTACT. EYE
CONTACT: SLIGHTLY IRRITATING TO EYES. INGESTION: MAY BE HARMFUL IF
SWALLOWED.
NONE KNOWN
MEDICAL CONDITIONS PRONE TO AGGRAVATION
EMERGENCYAND FIRST AID PROCEDURES: INHALATION: MOVE SUBJECT TO FRESH AIR.
EYE CONTACT: FLUSH WITH LARGE QUANTITIES OF WATER FOR 15 MINUTES. IF
IRRITATION PERSISTS GET MEDICAL ATTENTION. SKIN CONTACT: REMOVE SATURATED
CLOTHING. WASH WITH SOAP AND WATER. SEEK MEDICAL ATTENTION IF IRRITATION
DEVELOPS. LAUNDER SATURATED CLOTHING AND CLEAN SHOES BEFORE REUSE.
INGESTION: DO NOT INDUCE VOMITING. SLOWLYDILUTE WITH 3 - 4 GLASSES OF MILK
OR WATERAND SEEK MEDICAL ATTENTION. NEVER GIVE ANYTHING BY MOUTHTO AN
UNCONSCIOUS PERSON. '.
INHALATION
SKIN CONTACT SKIN ABSORPTION
PRIMARY ROUTE(S) OF ENTRY:
INGESTION EYE CONTACT
SECTION VI REACTIVITY DATA
-
HAZARDOUS DECOMPOSITION PRODUCTS: MAY PRODUCE TOXIC FUMES WHEN HEATED TO
DECOMPOSITION. FUMES MAY CONTAIN CARBON MONOXIDE AND/OR CARBON DIOXIDE.
DECOMPOSITION IS DEPENDENT ON TIME AND TEMPERATURE.
AVOID
ONSET OF DECOMPOSITION IS 177C/350F
CONDITIONS TO AVOID:
FREEZING.
AVOID CONTACTWITH STRONGOXIDIZING AGENTS
INCOMPATABILITY
Will not occur under normal conditions
HAZARDOUS POLYMERIZATION
This product is stable under normal storage conditions
STABILITY
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: LARGE SPILLS:
KEEP SPECTATORS AWAY. FLOOR MAY BE SLIPPERY: USE CARE TO AVOID FALLING.
DIKE AND CONTAIN SPILL WITH INERT MATERIAL (E.G SAND, EARTH). SMALL
SPILLS: TAKE UP WITH AN ABSORBENT MATERIAL AND SEAL TIGHTLY FOR PROPER
(Continued on Page 3)
Product DVDF Preparation Date: 03/06/03 Page 3
SPILL OR LEAK PROCEDURES
SECTION VII -
DISPOSAL. TRANSFER LIQUID TO CONTAINERS FOR RECOVERY OR DISPOSAL AND SOLID
DIKING MATERIAL TO SEPARATE CONTAINERS FOR DISPOSAL. KEEP SPILLS AND
CLEANING RUNOFFS OUT OF MUNICIPAL SEWERS AND OPEN BODIES OF WATER.
WASTE DISPOSAL METHOD: DISPOSE OF PRODUCT IN ACCORDANCE WITH LOCAL,
COUNTY, STATE AND FEDERAL REGULATIONS.
SAFE HANDLING AND USE INFORMATION
SECTION VIII -
RESPIRATORY PROTECTION: WEAR TO AVOID BREATHING SPRAY MIST, HEATED VAPORS
OR FUMES OR IF EXPOSURE MAY OR DOES EXCEED OCCUPATIONAL EXPOSURE LIMITS
(SECTION II). USE A NIOSH - APPROVED RESPIRATOR TO PREVENT OVEREXPOSURE.
MECHANICAL LOCAL EXHAUSTAT THE POINT OF VAPOR OR MIST
VENTILATION:
RELEASE.
WEAR IMPERVIOUS GLOVES
PROTECTIVE GLOVES:
EYE PROTECTION WEAR CHEMICAL RESISTANT GOGGLES TO PREVENT EYE CONTACT
OTHER PROTECTIVE EQUIPMENT: WEAR PROTECTIVE CLOTHING AS REQUIRED TO
PREVENT SKIN CONTACT. EYE WASH STATION SHOULD BE AVAILABLE.
HYGIENIC PRACTICES: WASH WITH SOAP AND WATER AFTER HANDLING AND BEFORE
EATING, DRINKING, SMOKING OR USING TOILET FACILITIES. LAUNDER CONTAMINATED
CLOTHING BEFORE REUSE.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: AVOID CONTACT WITH VAPORS
AND FUMES. AVOID CONTACT WITH EYES SKIN AND CLOTHING. STORAGE TEMPERATURE
MAX. 49C/120F; MIN.1C/34F. KEEP FROM FREEZING. STORE AWAY FROM SPARKS
AND FLAMES. DO NOT BREATHE SPRAY MIST.
OTHER PRECAUTIONS DO NOT TAKE INTERNALLY. OBSERVE LABEL PRECAUTIONS
HMIS RATINGS HEALTH 1 FLAMMABILITY: a
- REACTIVITY:
SECTION XI OTHER REGULATIONS
-
(Continued on Page 4
Page -4
Product: DVDF Preparation Date: 03/06/03
SECTION XI OTHER REGULATIONS
-
SARA SECTION 313:
This product contains the following substances subject to the reporting
requirements of Section 313 of Title III of the Superfund Amendments and
Reauthorization Act of 1986 and 40 CFR Part 372:
WT/WT % IS LESS THAN
CAS NUMBER
DIETHYLENE GLYCOL MONOBUTYL ETHER
CHEMICAL NAME
5.0 %
112-34-5
111-76-2 5.0 %
ETHYLENEGLYCOL MONO BUTYL ETHER
5.0 %
67-63-0
ISOPROPANOL
PREVIOUS MSDS REVISION DATE 03/06/03
Not Established
Not Applicable, N.E.
LEGEND N.A. -
-
Not Determined
N.D. -
The information contained on this MSDS is to the best of our knowledge and
belief, accurate. However, since the conditions of handling and use are
beyond our control, we make no guarantee of results, and assume no
liability for damages incurred by use of this material. It is the
responsibility of the user to comply with all applicable federal, state and
local laws and regulations.
|