FASCAT (R) 9102 Catalyst
Material Safety Data Sheet
Arkema Inc.
1 PRODUCT AND COMPANY IDENTIFICATION
EMERGENCY PHONE NUMBERS:
Additives
Chemtrec: (800) 424-9300 (24hrs) or (703) 527-3887
2000 Market Street
Medical: Rocky Mountain Poison Control Center
28th Floor
(866) 767-5089 (24Hrs)
Philadelphia, PA 19103-3222
Information Telephone Numbers Phone Number Available Hrs
Customer Service Number (800) 331-7654 8:00 AM - 5:00 PM EST
Product Name FASCAT (R) 9102 Catalyst
Product Synonym(s)
Chemical Family Organotin
Chemical Formula C28H54O6Sn
Chemical Name See below
EPA Reg Num NA
Product Use Catalyst
2 COMPOSITION / INFORMATION ON INGREDIENTS
Ingredient Name CAS RegistryNumber Typical Wt. % OSHA
Butyltin tris-2-ethylhexoate 23850-94-4 > 98 Y
The substance(s) marked with a "Y" in the OSHA column, are identified as hazardous chemicals according to the
criteria of the OSHA Hazard Communication Standard (29 CFR 1910.1200)
The components of this product are all on the TSCA Inventory list.
3 HAZARDS IDENTIFICATION
Emergency Overview
Pale yellow liquid with a characteristic odor.
CAUTION!
MAY CAUSE SKIN IRRITATION.
MAY CAUSE RESPIRATORY TRACT IRRITATION.
Potential Health Effects
Inhalation and skin contact are expected to be the primary routes of occupational exposure to this material. Based on
single exposure animal tests, it is considered to be slightly toxic to practically non-toxic if swallowed, practically non-
toxic if absorbed through skin, slightly irritating to eyes and moderately irritating to skin. A number of other organotin
compounds have been shown to cause respiratory tract irritation.
Product Code: RKA03 Page 1
Revision: 5 Issued: 19 OCT 2004 of 6
FASCAT (R) 9102 Catalyst
Material Safety Data Sheet
Arkema Inc.
4 FIRST AID MEASURES
IN CASE OF CONTACT, flush the area with plenty of water. Remove contaminated clothing and shoes.
Wash clothing before reuse. Get medical attention if irritation develops and persists. Thoroughly clean shoes
before reuse.
IF INHALED, remove to fresh air. If breathing is difficult, get medical attention.
IF SWALLOWED, induce vomiting as directed by medical personnel. Get medical attention. NEVER GIVE
ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON.
5 FIRE FIGHTING MEASURES
Fire and Explosive Properties
Auto-Ignition Temperature NE
Flash Point NE Flash Point Method
Flammable Limits- Upper NE
NE
Lower
Extinguishing Media
Use water spray, carbon dioxide, foam or dry chemical.
Fire Fighting Instructions
Contain run-off from fire. Fire fighters and others who may be exposed to products of combustion should wear
full fire fighting turn out gear (full Bunker Gear) and self-contained breathing apparatus (pressure demand
NIOSH approved or equivalent). Fire fighting equipment should be thoroughly decontaminated after use.
Fire and Explosion Hazards
When burned, the following hazardous products of combustion can occur: Carbon monoxide Carbon dioxide Tin
oxides Avoid breathing fumes from fire exposed material.
6 ACCIDENTAL RELEASE MEASURES
In Case of Spill or Leak
Stop the leak, if possible. Ventilate the space involved. Contain, sweep up, place in container for disposal.
Shut off or remove all ignition sources. Prevent waterway contamination. Construct a dike to prevent
spreading. Collect run-off and transfer to drums or tanks for later disposal. Consult a regulatory specialist to
determine appropriate state or local reporting requirements, for assistance in waste characterization and/or
hazardous waste disposal and other requirements listed in pertinent environmental permits.
Clean up procedures: Transfer to containers in preparation for later disposal. Avoid generation of vapors.
Place in non-sparking containers for recovery or disposal. Remove from spill location. Decontaminate area.
7 HANDLING AND STORAGE
Handling
Do not get in eyes, on skin or on clothing. Avoid breathing dust. Keep container closed. Use only with
adequate ventilation. Wash thoroughly after handling.
Storage
Tin oxides, Store in a cool, dry place. Upon exposure to direct sunlight, product degradation to an organic tin
salt may occur.
Product Code: RKA03 Page 2
Revision: 5 Issued: 19 OCT 2004 of 6
FASCAT (R) 9102 Catalyst
Material Safety Data Sheet
Arkema Inc.
8 EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering Controls
Investigate engineering techniques to reduce exposures below airborne exposure limits. Provide ventilation
if necessary to control exposure levels below airborne exposure limits (see below). If practical, use local
mechanical exhaust ventilation at sources of air contamination such as open process equipment.
Eye / Face Protection
Use good industrial practice to avoid eye contact.
Skin Protection
Wear appropriate chemical resistant protective clothing and chemical resistant gloves to prevent skin
contact. Consult glove manufacturer to determine appropriate type glove material for given application.
Wear face shield and chemical resistant clothing such as a rubber apron when splashing may occur. Rinse
contaminated skin promptly. Wash contaminated clothing and clean protective equipment before reuse.
Wash skin thoroughly after handling.
Respiratory Protection
Avoid breathing vapor or mist. When airborne exposure limits are exceeded (see below), use NIOSH
approved respiratory protection equipment appropriate to the material and/or its components. Consult
respirator manufacturer to determine appropriate type equipment for given application. Observe respirator
use limitations specified by NIOSH or the manufacturer. For emergency and other conditions where
exposure limit may be significantly exceeded, use an approved full face positive-pressure, self-contained
breathing apparatus or positive-pressure airline with auxiliary self-contained air supply. Respiratory
protection programs must comply with 29 CFR 搂 1910.134.
Airborne Exposure Guidelines for Ingredients
Exposure Limit Value
Butyltin tris-2-ethylhexoate
ACGIH Skin designator - Y
ACGIH STEL -Organic tin compounds, as Sn 0.2 mg/m3
ACGIH TWA -Organic tin compounds, as Sn 0.1 mg/m3
ARKEMA 12-hour TWA -Mono- and dibutyl tin compounds, 0.07 mg/m3
as Sn
OSHA TWA PEL -Organic tin compounds, as Sn 0.1 mg/m3
-Only those components with exposure limits are printed in this section.
-Skin contact limits designated with a "Y" above have skin contact effect. Air sampling alone is insufficient to accurately quantitate
exposure. Measures to prevent significant cutaneous absorption may be required.
-ACGIH Sensitizer designator with a value of "Y" above means that exposure to this material may cause allergic reactions.
-WEEL-AIHA Sensitizer designator with a value of "Y" above means that exposure to this material may cause allergic skin reactions.
Product Code: RKA03 Page 3
Revision: 5 Issued: 19 OCT 2004 of 6
FASCAT (R) 9102 Catalyst
Material Safety Data Sheet
Arkema Inc.
9 PHYSICAL AND CHEMICAL PROPERTIES
Appearance/Odor
Pale yellow liquid with a characteristic odor.
pH NE
Specific Gravity 1.13
Vapor Pressure NE
Vapor Density NE
Melting Point -27.4 deg C
Freezing Point -27.4 deg C
Boiling Point NE
Solubility In Water Insoluble
Solubility in Other Materials NE
Evaporation Rate NE
Particle Size NE
Percent Volatile NE
Molecular Weight 605
n-Octanol/Water Partition Coefficient NE
Oil/Water Partition Coefficient NE
Other Physical Data Specific Conductivity: 22 x 10(-6) ohm(-1) cm(-1)
Resistance: 0.05 x 10(6) ohm-cm
10 STABILITY AND REACTIVITY
Stability
This material is chemically stable under normal and anticipated storage and handling conditions.
Hazardous Polymerization
Does not occur.
Incompatibility
Contact with bases and reducing agents may result in a low energy release.
Hazardous Decomposition Products
None known
11 TOXICOLOGICAL INFORMATION
Toxicological Information
Single exposure (acute) studies indicate:
Oral - Slightly Toxic to Practically Non-toxic to Rats (LD50 3,200 to >5,000 mg/kg)
Dermal - Practically Non-toxic to Rabbits (LD50 >8,000 mg/kg)
Eye Irritation - Slightly Irritating to Rabbits (14.7/110)
Skin Irritation - Moderately Irritating to Rabbits (24-hr exposure, 3.9/8.0)
12 ECOLOGICAL INFORMATION
Ecotoxicological Information
No data are available.
Product Code: RKA03 Page 4
Revision: 5 Issued: 19 OCT 2004 of 6
FASCAT (R) 9102 Catalyst
Material Safety Data Sheet
Arkema Inc.
12 ECOLOGICAL INFORMATION
Chemical Fate Information
No data are available.
13 DISPOSAL CONSIDERATIONS
Waste Disposal
Recover, reclaim or recycle when practical. Dispose of in an approved landfill if allowed locally. Comply with
federal, state, and local regulations. Dispose of in a permitted waste management facility if incineration or
landfill is not practical.
14 TRANSPORT INFORMATION
DOT Name not regulated
DOT Technical Name
DOT Hazard Class
UN Number
DOT Packing Group PG
RQ NE
15 REGULATORY INFORMATION
Hazard Categories Under Criteria of SARA Title III Rules (40 CFR Part 370)
Immediate (Acute) Health Y Fire N
Delayed (Chronic) Health N Reactive N
Sudden Release of Pressure N
The components of this product are all on the TSCA Inventory list.
Ingredient Related Regulatory Information:
CERCLA RQ SARA TPQ
SARA Reportable Quantities
Butyltin tris-2-ethylhexoate NE
New Jersey Right to Know
This product does contain the following chemical(s), as indicated below, currently on the New Jersey Right-to-Know Substances List.
Butyltin tris-2-ethylhexoate
16 OTHER INFORMATION
Revision Information
Revision Number 5
19 OCT 2004
Revision Date
Supercedes Revision Dated 11-OCT-2004
Revision Summary
ATOFINA Chemicals, Inc. has changed its name to Arkema Inc..
Product Code: RKA03 Page 5
Revision: 5 Issued: 19 OCT 2004 of 6
FASCAT (R) 9102 Catalyst
Material Safety Data Sheet
Arkema Inc.
Key
NE= Not Established NA= Not Applicable (R) = Registered Trademark
FASCAT is a registered trademark of Arkema Inc.
Arkema Inc. believes that the information and recommendations contained herein (including data and
statements) are accurate as of the date hereof. NO WARRANTY OF FITNESS FOR ANY PARTICULAR
PURPOSE, WARRANTY OF MERCHANTABILITY, OR ANY OTHER WARRANTY, EXPRESSED OR
IMPLIED, IS MADE CONCERNING THE INFORMATION PROVIDED HEREIN. The information provided
herein relates only to the specific product designated and may not be valid where such product is used in
combination with any other materials or in any process. Further, since the conditions and methods of use are
beyond the control of Arkema Inc., Arkema Inc. expressly disclaims any and all liability as to any results
obtained or arising from any use of the product or reliance on such information.
Product Code: RKA03 Page 6
Revision: 5 Issued: 19 OCT 2004 of 6
|