Material Safety Data Sheet
SECTION I - IDENTIFICATION
POLYKEN庐 1027 LIQUID ADHESIVE
PRODUCT NAME:
CHEMICAL FAMILY: Petroleum hydrocarbon
DOT ID NO.: UN1139 (Coating Solution)
HAZARD CLASS: Flammable Liquid (IMO Class 3.0; WHMIS Class B,
Division 2)
EMERGENCY TELEPHONE NUMBER: CHEMTREC 1-800-424-9300
OTHER TECHNICAL/HEALTH/SAFETY INFORMATION: (781) 372-2200
SECTION II - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
CAS REG. NO. AMOUNT EXPOSURE LIMITS*
VM&P NAPHTHA 8032-32-4 Approx. 60% 300 ppm TWA, 400 STEL
TOLUENE 108-88-3 Approx. 12% 100 ppm TWA, 150 STEL
METHANOL 67-56-1 Approx.1.5% 200 ppm TWA, 250 STEL
* OSHA 29 CFR 1910.1000, 8-hour Time Weighted Average and Short Term Exposure Limits.
SECTION III - PHYSICAL/CHEMICAL INFORMATION
BOILING POINT: 230-278掳 F VAPOR DENSITY (Air = 1): 4*
pH: Neutral VAPOR PRESSURE: 45 mm Hg (75掳F)*
SPECIFIC GRAVITY: 1.03 WATER SOLUBILITY: Negligible
FREEZING POINT: below 0掳F EVAPORATION RATE (BuAc=1): 2*
VISCOSITY: 56 cP VOC: 4.9 lbs/gal
APPEARANCE AND ODOR: Black, viscous liquid with odor of hydrocarbon solvents. Odor
threshold 10-15 ppm for Toluene, <300 ppm for VM&P Naphtha.
* Based on VM&P Naphtha (most volatile component)
SECTION IV - FIRE & EXPLOSION HAZARD DATA
FLASH POINT: 40掳 F (Pensky-Martens)
AUTOIGNITION TEMPERATURE: Approximately 480掳 F (VM&P Naphtha)
LEL: 1.2 % UEL: 7.1%
EXTINGUISHING MEDIA: Foam, CO2, Dry Chemical, water fog or spray.
SPECIAL FIRE FIGHTING PROCEDURES: If only water is available, use spray and not a direct hose
stream. Isolate hazard area and do not permit unnecessary personnel to enter.
Avoid breathing fumes or vapors. Wear full protective clothing, including NIOSH approved self
contained breathing apparatus. Cool surrounding areas and exposed containers with water.
UNUSUAL FIRE & EXPLOSION HAZARDS: This material is a moderate explosion hazard and a
dangerous fire hazard when exposed to heat and flame, due mostly to its flammable solvent content.
Issue No: 2 Effective Date: June, 2006 PAGE 1 OF 4 鈥? POLYKEN庐 1027 Liquid Adhesive
SECTION V - REACTIVITY DATA
STABILITY: Stable under most conditions. Avoid high temperatures, sparks, open flame.
INCOMPATIBILITY (Materials to avoid): Strong oxidizing agents such as liquid chlorine, pure
oxygen, sodium hypochlorite, and calcium hypochlorite.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide and complex organic
hydrocarbons may be formed upon combustion.
HAZARDOUS POLYMERIZATION: Will not occur.
SECTION VI - HEALTH HAZARD DATA
THRESHOLD LIMIT VALUE: Not determined for mixture; 100 ppm for Toluene; 300 ppm for VM&P
Naphtha. 200 ppm for Methanol
COMPONENTS LISTED AS KNOWN OR POTENTIAL CARCINOGENS: None.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: None known.
ACUTE EFFECTS OF OVEREXPOSURE:
INHALATION: May be irritating to mucous membranes. Inhalation of vapors may lead to giddiness,
dizziness, nausea, and loss of consciousness.
SKIN CONTACT: May be mildly irritating to the skin. Prolonged or repeated exposure may result in
defatting of skin, possibly leading to dermatitis.
EYE CONTACT: Short-term exposure may lead to irritation.
NOTE: Wearing contact lenses is not recommended when using this product.
INGESTION: Ingestion of the liquid may lead to vomiting.
CHRONIC EFFECTS OF OVEREXPOSURE: None known.
EMERGENCY & FIRST AID PROCEDURES:
INHALATION: Move affected person to fresh air and provide oxygen if breathing is difficult. Give
artificial respiration if necessary. Seek medical advice.
SKIN CONTACT: Flush with water, then wash affected area with soap and water. Remove
contaminated clothing immediately and launder before reuse. If irritation develops, seek medical
advice.
EYE CONTACT: Flush with water for at least 15 minutes and seek medical advice.
INGESTION: DO NOT INDUCE VOMITING! If vomiting occurs spontaneously, keep head below hips
to prevent aspiration of liquid into lungs. Seek medical advice.
TOXICITY INFORMATION:
VM&P NAPHTA ihl-hmn TCLo 600 mg/m3/8H oral-rat LD50 >5000 mg/kg
Issue No: 2 Effective Date: June, 2006 PAGE 2 OF 4 鈥? POLYKEN庐 1027 Liquid Adhesive
TOLUENE ihl-hmn TCL0 200 ppm, ihl-mul LC50 5320 ppm/8H
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: DANGER!
FLAMMABLE! Eliminate all ignition sources. Handling equipment must be grounded to prevent
sparking.
LARGE SPILLS: Isolate the hazard area and keep unnecessary personnel away. Wear NIOSH-
approved protective clothing and self-contained breathing apparatus. Ventilate area. Confine free
liquid by diking and remove liquid with explosion-proof vacuum truck or pump to chemical storage
vessel. Soak up residue with inert absorbent material such as clay or sand; place in leak-free
container, label as to contents, and hold for proper disposal. Dispose of spill material according to
applicable regulations.
DO NOT ALLOW MATERIAL TO ENTER SEWERS OR WATER COURSES LEADING TO
SURFACE WATERS.
SMALL SPILLS: Take up with inert absorbent materials and place in non-leaking containers; label as
to contents; seal tightly for proper disposal.
WASTE DISPOSAL: Dispose of material according to RCRA regulations. RCRA Number for Toluene
is U220. D001 designates ignitable mixtures not specifically covered by another RCRA Number.
PRECAUTIONS FOR HANDLING AND STORING: Do not store in excessive heat so as to avoid
pressure buildup in containers. Keep liquid away from very intense heat sources to eliminate
decomposition into toxic products. Avoid inhalation of vapors and excessive or repeated skin contact.
SECTION VIII - CONTROL MEASURES
VENTILATION REQUIREMENT: Local or mechanical explosion-proof.
RESPIRATORY PROTECTION: If exposure exceeds, or there is a possibility that it may exceed
OSHA exposure limits (200 ppm for Toluene; 300 ppm for VM&P Naphtha), use NIOSH approved
respirators. At extreme exposure levels, use self-contained breathing apparatus.
PROTECTIVE GLOVES: Chemically impervious.
EYE PROTECTION: Goggles.
OTHER PROTECTIVE EQUIPMENT: Chemical impervious clothing to prevent skin contact.
SECTION IX - SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Do not handle or store near heat,
sparks, flame or strong oxidizers. Adequate ventilation required. Avoid breathing vapors; avoid
prolonged or repeated skin contact.
NOTE: FLAMMABLE LIQUID LABEL REQUIRED!
Issue No: 2 Effective Date: June, 2006 PAGE 3 OF 4 鈥? POLYKEN庐 1027 Liquid Adhesive
DATE OF ISSUE: September 08, 2005
REVISED DATE: June 2, 2006 SUPERCEDES: All previous versions
The information presented herein was prepared at COVALENCE ADHESIVES (R&D Laboratory, 17
Hartwell Avenue, Lexington, MA 02173, 781 861-3200) by qualified technical personnel, and to our
knowledge it is true and accurate. The information and recommendations are furnished for this product
with the understanding that the purchaser will independently determine the suitability of the product for
his purposes. The data do not constitute a warranty, expressed or implied, statutory or otherwise, nor
are they a representation for which COVALENCE ADHESIVES assumes legal responsibility. The data
are submitted for the user's information and consideration only.
Any use of this product must be determined by the user to be in accordance with the applicable
federal, state and local laws and regulations.
Covalence Corporation Covalence Specialty Materials Europe
25 Forge Parkway Nieuwlandlaan B15
Franklin, MA 02038 USA B-3200 Aarschot, Belgium
Tel: +1 508-918-1600 Tel: +32 16 55 36 00
US Toll Free: +1 800-248-7659 Fax: +32 16 55 36 74
Fax: +1 508-918-1910 E-mail: CPGE@covcorp.com
E-mail: CPG@covcorp.com
Issue No: 2 Effective Date: June, 2006 PAGE 4 OF 4 鈥? POLYKEN庐 1027 Liquid Adhesive
|