Material Safety Data Sheet
SECTION I - IDENTIFICATION
POLYKEN庐 1039 LIQUID ADHESIVE
PRODUCT NAME:
CHEMICAL FAMILY: Petroleum hydrocarbon
DOT ID NO.: UN2234 (Coating Solution)
HAZARD CLASS: Flammable Liquid (IMO Class 3.0;
WHMIS Class B, Division 2, Subdivision B)
EMERGENCY TELEPHONE NUMBER: CHEMTREC 1-800-424-9300
OTHER TECHNICAL/HEALTH/SAFETY INFORMATION: (781) 372-2200
SECTION II - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
CAS REG. NO AMOUNT EXPOSURE LIMITS*
Oxsol-100** 98-56-6 100% Not Determined
* OSHA 29 CFR 1910.1000, 8-hour Time Weighted Average and Short Term Exposure Limits.
** For additional information on Oxsol-100, refer to MSDS #M29358 from Oxy Chem,
Telephone: (716) 278-7021
SECTION III - PHYSICAL/CHEMICAL INFORMATION
BOILING POINT: 139掳C (282 F) VAPOR DENSITY (Air=1): 3.5
pH: Not Applicable VAPOR PRESSURE: 5.3 mm Hg (75掳F)
SPECIFIC GRAVITY: 1.34 WATER SOLUBILITY: Negligible
FREEZING POINT: less than -50掳F EVAPORATION RATE (BuAc=1): ND
VISCOSITY: 40-80 CPS VOC: Zero lbs/gal
APPEARANCE AND ODOR: Black, viscous liquid with odor of hydrocarbon solvents.
SECTION IV - FIRE & EXPLOSION HAZARD DATA
FLASH POINT: (TAGCC) 42.8掳 C (109 F)
AUTOIGNITION TEMPERATURE: > 500掳 C
LEL: 0.9 % UEL: 10.5 % @ 50掳 C
EXTINGUISHING MEDIA: Foam, CO2, dry chemical, water fog or spray.
SPECIAL FIRE FIGHTING PROCEDURES: If only water is available, use spray and not a direct hose
stream. Isolate hazard area and do not permit unnecessary personnel to enter. Avoid breathing fumes
PAGE 1 OF 4 - POLYKEN庐 1039
Issue No: 2 Effective Date: June, 2006
or vapors. Wear full protective clothing, including NIOSH approved self contained breathing apparatus.
Cool surrounding areas and exposed containers with water.
UNUSUAL FIRE & EXPLOSION HAZARDS: Material is an explosion hazard and a dangerous fire
hazard when exposed to heat and flame. Avoid high temperatures, sparks or open flames.
SECTION V - REACTIVITY DATA
STABILITY: Stable under most conditions. Avoid high temperatures, sparks, or open flame.
INCOMPATIBILITY (Materials to avoid): Strong oxidizing agents such as liquid chlorine, pure
oxygen, sodium hypochlorite, and calcium hypochlorite; reactive metals such as sodium, potassium,
aluminum powder, zinc powder, and magnesium, strong caustics such as caustic soda, potash or
amines.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide and complex organic
hydrocarbons may be formed upon combustion.
HAZARDOUS POLYMERIZATION: Will not occur.
SECTION VI - HEALTH HAZARD DATA
THRESHOLD LIMIT VALUE: Not determined for mixture: Corporate Exposure Limit established for
parachlorobenzotrifluoride = 20 ppm, 8 hr. TWA.
COMPONENTS LISTED AS KNOWN OR POTENTIAL CARCINOGENS: None
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Chronic respiratory
disease.
ACUTE EFFECTS OF OVEREXPOSURE:
INHALATION: May be irritating to mucous membranes. Inhalation of vapors may lead to giddiness,
dizziness, nausea, and loss of consciousness.
SKIN CONTACT: May be mildly irritating to the skin. Prolonged or repeated exposure may result in
defatting of skin, possibly leading to dermatitis.
EYE CONTACT: Short-term exposure may lead to irritation. NOTE: Wearing of contact lenses is not
recommended when using this product.
INGESTION: Ingestion of the liquid may lead to vomiting.
CHRONIC EFFECTS OF OVEREXPOSURE: Not Known
EMERGENCY & FIRST AID PROCEDURES:
INHALATION: Move affected person to fresh air and provide oxygen if breathing is difficult. Give
artificial respiration if necessary. Seek medical advice.
SKIN CONTACT: Flush with water, then wash affected area with soap and water. Remove
contaminated clothing immediately and launder before reuse. If irritation develops, seek medical
advice.
EYE CONTACT: Flush with water for at least 15 minutes and seek medical advice.
PAGE 2 OF 4 - POLYKEN庐 1039
Issue No: 2 Effective Date: June, 2006
INGESTION: DO NOT INDUCE VOMITING! If vomiting occurs spontaneously, keep head below hips
to prevent aspiration of liquid into lungs. Seek medical advice.
TOXICITY INFORMATION: Not Determined
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: DANGER!
FLAMMABLE! Eliminate all ignition sources. Handling equipment must be grounded to prevent
sparking.
LARGE SPILLS: Isolate the hazard area and keep unnecessary personnel away.
Wear NIOSH-approved protective clothing and self-contained breathing apparatus.
Ventilate area. Confine free liquid by diking and remove liquid with vacuum truck or pump to chemical
storage vessel.
Soak up residue with inert absorbent material such as clay or sand; place in leak-free container, label
as to contents, and hold for proper disposal. Dispose of spill material according to applicable
regulations. DO NOT ALLOW MATERIAL TO ENTER SEWERS OR WATER COURSES LEADING
TO SURFACE WATERS.
SMALL SPILLS: Take up with inert absorbent material and place in non-leaking containers; label as
to contents; seal tightly for proper disposal.
WASTE DISPOSAL: Dispose of material according to RCRA regulations. D001 designates ignitable
mixtures not specifically covered by another RCRA Number.
PRECAUTIONS FOR HANDLING AND STORING: Do not store in excessive heat so as to avoid
pressure buildup in containers. Keep liquid and vapor away from very intense heat sources to
eliminate decomposition into toxic products. Avoid inhalation of vapors and excessive or repeated skin
contact.
SECTION VI - HEALTH HAZARD DATA
VENTILATION: Local or mechanical explosion-proof.
RESPIRATORY PROTECTION: If exposure exceeds, or there is a possibility that it may exceed
OSHA exposure limits use NIOSH-approved respirators. At extreme exposure levels, use positive-
pressure self-contained breathing apparatus.
PROTECTIVE GLOVES: Chemically impervious.
EYE PROTECTION: Goggles.
OTHER PROTECTIVE EQUIPMENT: Chemical impervious clothing to prevent skin contact.
PAGE 3 OF 4 - POLYKEN庐 1039
Issue No: 2 Effective Date: June, 2006
SECTION IX - SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Do not handle or store near heat,
sparks, flame or strong oxidizers. Adequate ventilation required. Avoid breathing vapors; avoid
prolonged or repeated skin contact.
NOTE: FLAMMABLE LIQUID LABEL REQUIRED!
SECTION X - REGULATORY INFORMATION
SARA (313) Chemicals:
This product does not contain toxic chemicals which are subject to the reporting requirements of
Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 and 40 CFR
Part 372.
DATE OF ISSUE: September 8, 2005
REVISED DATE: June 2, 2006 SUPERCEDES: All previous versions
The information presented herein was prepared at COVALENCE ADHESIVES (R&D Laboratory, 17
Hartwell Avenue, Lexington, MA 02173, 781 861-3200) by qualified technical personnel, and to our
knowledge it is true and accurate. The information and recommendations are furnished for this product
with the understanding that the purchaser will independently determine the suitability of the product for
his purposes. The data do not constitute a warranty, expressed or implied, statutory or otherwise, nor
are they a representation for which COVALENCE ADHESIVES assumes legal responsibility. The data
are submitted for the user's information and consideration only.
Any use of this product must be determined by the user to be in accordance with the applicable
federal, state and local laws and regulations.
Covalence Corporation Covalence Specialty Materials Europe
25 Forge Parkway Nieuwlandlaan B15
Franklin, MA 02038 USA B-3200 Aarschot, Belgium
Tel: +1 508-918-1600 Tel: +32 16 55 36 00
US Toll Free: +1 800-248-7659 Fax: +32 16 55 36 74
Fax: +1 508-918-1910 E-mail: CPGE@covcorp.com
E-mail: CPG@covcorp.com
PAGE 4 OF 4 - POLYKEN庐 1039
Issue No: 2 Effective Date: June, 2006
|