MATERIAL SAFETY DATA SHEET
Page: 1
DATE PREPARED: 26/01/2005
MSDS No: DSR - Aerosol
Decal Sticker Remover - Part No's: 16-DSR
HAZARDOUS ACCORDING TO THE CRITERIA OF WOERKSAFE AUSTRALIA
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product Name: Decal Sticker Remover - part #'s: 16-DSR
DISTRIBUTOR: 24 HR. EMERGENCY TELEPHONE NUMBERS:
The Blaster Group Pty Ltd
Unit 30, 8 Victoria Street POISONS INFORMATION CENTRE
13 12 26
Castle Hill NSW 2174
Emergency Phone: 02 9894 7360
Customer Service: 02 9894 7360
2. COMPOSITION/INFORMATION ON INGREDIENTS
wt.% CAS Registry # OSHA PEL ACGIH TLV
5989-27-5 not available
<40
D-Limonene
1569-01-3 not available
<50
1-Propoxy-2-Propanol
124-38-9 5000ppm
Carbon Dioxide <2
3. HAZARDS IDENTIFICATION
POTENTIAL HEALTH EFFECTS
EYES:
Likely to cause immediate or delayed irritation. Irritation will show as redness and/or swelling of the
eyes.
SKIN:
Repeated or prolonged contact with skin may produce irritation, dryness, or dermatitis.
INGESTION:
Ingestion may cause irritation to the mouth, oesophagus, and stomach.
INHALATION:
Inhalation of vapours or mist may irritate respiratory tract. Inhalation of excessive amounts may cause
central nervous system effects such as dizziness, nausea, &/or headaches.
Page: 2
DATE PREPARED: 26/01/2005
MSDS No: DSR - Aerosol
Decal Sticker Remover - Part No's: 16-DSR
PHYSICAL HAZARDS:
Aerosol containers are pressurized (even when empty!) Do not expose to temperatures above 50oC.
Do not puncture or burn can. Failure to observe these precautions may result in a rapid and violent
decompression of the container producing projectiles and atomization of the liquid contents.
COMMENTS:
NOTICE - Reports have associated repeated and prolonged occupational overexposure to solvents with
permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and
inhaling the contents may be harmful or fatal.
4. FIRST AID MEASURES
EYES:
Flush with plenty of clear water. Seek medical attention
SKIN:
Remove contaminated clothing immediately. Wash skin with soap and water. If irritation develops.
seek medical attention
INGESTION:
If swallowed, do NOT induce vomiting. Give victim a glass of water or milk. Call a physician or poison
control centre immediately. Never give anything by mouth to an unconscious person.
INHALATION:
Remove to fresh air. Seek medical attention.
5. FIRE FIGHTING MEASURES
Flashpoint and Method: 48oC TAG CC
GENERAL HAZARD:
This material can be ignited by heat. sparks, flames, or other sources of ignition (static electricity.)
Vapours are heavier than air and will collect in low areas (sewers) or travel considerable distances to a
source of ignition. If containers are not cooled in a fire, they may ignite and explode.
EXTINGUISHING MEDIA:
Dry chemical, carbon dioxide, halon, or foam is recommended. Water spray may be used to cool
containers or structures. Halon may decompose into toxic materials and carbon dioxide will displace
oxygen. Take proper precautions when using these materials.
HAZARDOUS COMBUSTION PRODUCT:
Thermal decomposition in the presence of air may yield, carbon monoxide, carbon dioxide, and
various hydrocarbons.
Page: 3
DATE PREPARED: 26/01/2005
MSDS No: DSR - Aerosol
Decal Sticker Remover - Part No's: 16-DSR
FIRE FIGHTING PROCEDURES:
Emergency responders in the danger area should wear bunker gear and self-contained breathing
apparatus for fires beyond the incipient stage. Wear other protective gear as conditions warrant. Stop
leaks, if it can be done with minimal risk. Water spray may be useful in dispersing vapours or cooling
equipment and containers. Material will float on water. Avoid spreading fire with water.
6. ACCIDENTAL RELEASE MEASURES
SMALL SPILL:
Absorb the liquid and scrub the area with detergent and water.
LARGE SPILL:
After eliminated source of release, absorb free liquid with suitable absorbent. Avoid allowing liquid into
sewers or waterways. Dispose of absorbents and liquid in accordance with local, state and federal
laws.
7. HANDLING AND STORAGE
HANDLING:
Avoid contact. Wash thoroughly after handling.
STORAGE:
Store containers sealed and upright when not in use. Rotate stock. Store away from excessive heat.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
PERSONAL PROTECTION
EYES AND FACE:
Standard safety glasses with splash shields are adequate protection. Where excessive splashing is
possible, a face shield should be used.
SKIN:
Excessive contact should be avoided. Neoprene gloves and aprons will provide adequate protection
when contact cannot be avoided.
RESPIRATORY:
Good general ventilation should be sufficient to control airborne levels. Maintain airborne
concentrations below the established exposure limits of ingredients in Section 2.
Page: 4
DATE PREPARED: 26/01/2005
MSDS No: DSR - Aerosol
Decal Sticker Remover - Part No's: 16-DSR
PROTECTIVE CLOTHING:
Chemical resistant aprons and boots are suggested when contact with material cannot be avoided.
Remove and wash any contaminated clothing immediately.
WORK HYGIENIC PRACTICES:
Wash thoroughly after handling.
OTHER USE PRECAUTIONS:
Eye wash stations and emergency showers should be available.
COMMENTS:
The BLASTER GROUP PTY LTD takes no responsibility for determining what measures are required for
personal protection in any specific application. The information provided should be used with discretion.
9. PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Liquid
Odour: Heavy Citrus Odour
Appearance: Transparent
Colour: Clear
Percent Volatile: 95
o
Boiling Point: 175 C
Solubility in Water: Completely Miscible
Specific Gravity: 0.8578
10. STABILITY AND REACTIVITY
STABLE: YES
HAZARDOUS POLYMERIZATION: NO
CONDITIONS TO AVOID:
Avoid high temperatures.
STABILITY:
Stable.
POLYMERIZATION:
Will not occur.
Page: 5
DATE PREPARED: 26/01/2005
MSDS No: DSR - Aerosol
Decal Sticker Remover - Part No's: 16-DSR
11. TOXICOLOGICAL INFORMATION
COMMENTS:
Toxicological information on this product as a mixture has yet to be determined. See section 15 for
reportable ingredients.
12. ECOLOGICAL INFORMATION
ENVIRONMENTAL DATA:
No data available. Contact Env. Dept.
ECOTOXICOLOGICAL INFORMATION
No data available. Contact Env. Dept.
13. DISPOSAL CONSIDERATIONS
DISPOSAL METHOD:
Used or unused product should be disposed of in accordance with local, state, and federal regulations.
EMPTY CONTAINER:
Empty containers will contain residual product and should be handled in the same manner as the
product. Containers should be returned to a reputable container recycler.
14. TRANSPORT INFORMATION
Proper Shipping Name: Aerosols, Flammable,
Hazard Class: 2.1
NA/UN Number: 1950
Packing Group: II
Hazchem 2Y
NAERG: 126
Other Shipping Information:
15. REGULATORY INFORMATION
UNITED STATES
SARA TITLE III (SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT)
Title III Notes: There are no SARA 313 reportable materials in this product.
Page: 6
DATE PREPARED: 26/01/2005
MSDS No: DSR - Aerosol
Decal Sticker Remover - Part No's: 16-DSR
CERCLA (COMPREHENSIVE RESPONSE, COMPENSATION, AND LIABILITY ACT)
CERCLA RQ: This product has no CERCLA Reportable Quantity. However, release into a waterway
may require reporting to the National Response Centre.
TSCA (TOXIC SUBSTANCE CONTROL ACT)
TSCA Regulatory: This product complies with all TSCA Inventory requirements.
16. OTHER INFORMATION
Approval date: 26/01/05
REVISION SUMMARY
Revision #: 4
This MSDS replaces the March 05, 2001 MSDS. Any changes in information are as follows:
In Section 1
MSDS Number
In Section 3
Physical Hazards (text)
In Section 14
Proper Shipping Name Technical Name DOT Hazard Class UN/NA Number Other DOT
Shipping Information (text) DOT Emergency Response Guide
HMIS CODES
Fire: 2 Health: 1 Reactivity: 0 Protection: C
MANUFACTURER DISCLAIMER:
To the best of our knowledge, the information contained herein is accurate. However, neither The
Blaster Group Pty Ltd nor any of its subsidiaries assumes any liability whatsoever for the accuracy or
completeness of the information contained herein. Final determination of suitability of any material is
the sole responsibility of the user. All materials may present unknown hazards and should be used
with caution. Although certain hazards are described herein, we cannot guarantee that these are the
only hazards which exist.
|