PRODUCT NAME: BRULIN SD 1291
PRODUCT NUMBER: 304012
PAGE 1 of 2
MATERIAL SAFETY DATA SHEET
Per 29 CFR 1910.1200 DATE PREPARED : 8/02/02
SECTION I.
P.O. BOX 270, INDIANAPOLIS, IN 46206-0270 (317) 923-3211
BRULIN & COMPANY. INC.
WEST COAST FACTORY SOUTHEASTERN FACTORY
Richmond, California Tampa, Florida
24 HOUR EMERGENCY NUMBER
CHEMTREC 1-800-424-9300
Health: 2
IDENTITY (As listed on label): HMIS HAZARD RATINGS: Flammability: 2
Reactivity: 0
BRULIN SD 1291
SECTION II - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
Hazardous Components ACGIH OTHER LIMITS
(Specific Chemical Identity: Common Name(s) CAS # OSHA PEL TLV-TWA RECOMMENDED PERCENT
Ethyl 3-Ethoxypropionate 763-69-9 Not Estab. Not Estab. Supplier 50 PPM 10-30
Dipropylene Glycol Methyl Ether 34590-94-8 100 PPM 100 PPM STEL 150 PPM 50-70
SECTION 313 SUPPLIER NOTIFICATION
The toxic chemical(s) listed above which are marked with an (*) are subject to the reporting requirements of Section 313 of the Emergency Planning and
Community Right-To-Know Act of 1986 and of 40 CFR 372. Not all chemicals subject to Section 313 of EPCRA appear on the OSHA Floor List of
Hazardous Chemicals.
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Boiling Point: 212-350 F Specific Gravity (H2O=1): .948
Vapor Pressure (mm Hg): .4 Melting Point: Less than 0 F
Vapor Density (Air=1): 5.11 Evaporation Rate (n Butyl Acetate=1): Less than 0.1
Solubility in Water: 15-20% (v/v)
Appearance and Odor: Clear liquid, sweet/pungent odor.
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used): 155 F PMCC/157 F COC
Flammable Limits LEL Unknown UEL Unknown
Extinguishing Media: Carbon dioxide, foam, dry chemicals
Special Fire Fighting Procedures: Full protective equipment including self-contained breathing apparatus should
be worn. During emergency conditions, overexposure to decomposition
products may cause a health hazard. Symptoms may not be immediately
apparant. Get medical attention. Water may be used to cool & protect closed
containers exposed to extreme heat.
Unusual Fire and Explosion Hazards: Warning! Combustible liquid. Keep away from heat and open flame. Never
use welding or cutting torch on or near drum, even empty.
PRODUCT NAME: BRULIN SD 1291
PRODUCT NUMBER: 304012
PAGE 2 of 2
SECTION V - REACTIVITY DATA
Stability Unstable Stable X
Conditions to Avoid: None
Incompatibility (Materials to Avoid): Strong oxidizers
Hazardous Decomposition or Byproducts: Carbon monoxide, carbon dioxide upon thermal
decomposition.
Hazardous Polymerization: May Occur May Not Occur X
Conditions to Avoid: None
SECTION VI - HEALTH HAZARD DATA
Route(s) of Entry: Ingestion? Yes Skin? Yes Inhalation? Yes Eyes? Yes
Health Hazards (Acute and Chronic): Direct contact may cause moderate eye irritation. Excessive inhalation may
cause respiratory irritation. Moderately toxic if ingested. Prolonged or repeated skin contact may cause
irritation. Chronic skin exposure may cause dermatitis. Overexposure by air and/or prolonged skin contact
may cause temporary blurring of vision.
Carcinogenicity: NTP? No IARC Monographs? No OSHA Regulated? No
Signs and Symptoms of Exposure: Eye contact may cause redness, tearing. Skin irritation may be seen as
redness. Excessive inhalation may cause headache, nausea, dizziness.
Ingestion may cause gastrointestinal irritation, nausea, vomiting, diarrhea.
Medical Conditions Generally Aggravated by Exposure: None Known
Emergency & First Aid Procedures:
Eye Contact: Flush with large amounts of water for 15 minutes lifting upper & lower lids occasionally. Get
medical attention.
Inhalation: Remove to fresh air. Administer oxygen if breathing is difficult. Get medical attention.
Skin Contact: Wash with mild soap and water. Remove contaminated clothing and launder before reuse. If
irritation persists, consult a physician.
Ingestion: Give two glasses of water and induce vomiting immediately by sticking finger down throat.
Call a physician. Never give anything by mouth to unconscious person.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to be Taken in Case Material is Released or Spilled: Remove all sources of ignition. Ventilate the area
well. Absorb on solid absorbent and shovel into containers. Flush residues with water.
Waste Disposal Method: Dispose according to Federal, State and Local Laws and 40 CFR.
Precautions to be Taken in Handling and Storing: Store between 40 and 120 F. Keep containers tightly closed.
SECTION VIII - CONTROL MEASURES
Respiratory Protection (Specify Type): If recommended limits are exceeded, use a NIOSH/MSHA approved respirator
for organic vapors. Contact your local safety equipment supplier for recommendations.
Ventilation: Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below
TLV.
Protective Gloves: Butyl rubber
Eye Protection: Goggles or full face shield
Other Protective Clothing or Equipment:As necessary to prevent skin contact.
Work/Hygienic Practices: Use only with adequate ventilation. Avoid breathing vapor and mist. Avoid contact
with skin & eyes. Do not take internally. Wash thoroughly after handling. Observe
"NO SMOKING" when using this product.
|