**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 150-77-6 |N,N,N',N'-Tetraethylethylenediamine | >98 | 205-770-3 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: C
Risk Phrases: 22 34
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Harmful if swallowed. Causes burns.
Potential Health Effects
Eye:
Causes eye burns.
Skin:
Causes skin burns. Amines have been known to cause skin irritation
and sensitization.
Ingestion:
Harmful if swallowed. May cause severe gastrointestinal tract
irritation with nausea, vomiting and possible burns. May cause
central nervous system effects.
Inhalation:
May cause severe irritation of the respiratory tract with possible
burns.
Chronic:
Chronic exposure may cause effects similar to those of acute
exposure.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
In case of contact, immediately flush eyes with plenty of water for
at least 15 minutes. Get medical aid immediately.
Skin:
In case of contact, immediately flush skin with plenty of water for
at least 15 minutes while removing contaminated clothing and shoes.
Get medical aid immediately. Wash clothing before reuse.
Ingestion:
If swallowed, do NOT induce vomiting. Get medical aid immediately.
If victim is fully conscious, give a cupful of water. Never give
anything by mouth to an unconscious person.
Inhalation:
If inhaled, remove to fresh air. If not breathing, give artificial
respiration. If breathing is difficult, give oxygen. Get medical aid.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors may form an explosive mixture with air. Use
water spray to keep fire-exposed containers cool. Containers may
explode in the heat of a fire. Flammable liquid and vapor. Vapors are
heavier than air and may travel to a source of ignition and flash
back. Vapors can spread along the ground and collect in low or
confined areas.
Extinguishing Media:
Use water spray, dry chemical, or carbon dioxide.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Remove all sources of ignition.
Use a spark-proof tool. Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Ground and bond containers when transferring
material. Use spark-proof tools and explosion proof equipment. Do not
get in eyes, on skin, or on clothing. Empty containers retain product
residue, (liquid and/or vapor), and can be dangerous. Keep container
tightly closed. Keep away from heat, sparks and flame. Do not
pressurize, cut, weld, braze, solder, drill, grind, or expose empty
containers to heat, sparks or open flames. Use only with adequate
ventilation. Do not breathe vapor or mist.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 150-77-6:
Personal Protective Equipment
Eyes:
Wear chemical splash goggles.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: clear light yellow
Odor: amine-like
pH: Not available.
Vapor Pressure: 0.44 mm Hg @ 20 deg C
Viscosity: Not available.
Boiling Point: 189-192 deg C @ 760 mm Hg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 58 deg C ( 136.40 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: Slightly soluble.
Specific Gravity/Density: 0.81 g/ml
Molecular Formula: C10H24N2
Molecular Weight: 172.31
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Ignition sources, excess heat, confined spaces.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, carbon dioxide.
Hazardous Polymerization: Will not occur.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 150-77-6 unlisted.
LD50/LC50:
Not available.
Oral, rat: LD50 = 0.67 ml/kg or 542.7 mg/kg.
0.06 ml/kg or 48.6 mg/kg.
9/2/92.
Carcinogenicity:
N,N,N',N'-Tetraethylethylenediamine -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: AMINES, LIQUID, CORROSIVE, FLAMMABLE, N.O.S.*
Hazard Class: 8 (3)
UN Number: 2734
Packing Group: II
IMO
Shipping Name: AMINES, LIQUID, CORROSIVE, FLAMMABLE, N.O.S.
Hazard Class: 8 (3)
UN Number: 2734
Packing Group: II
RID/ADR
Shipping Name: AMINES, LIQUID, CORROSIVE, FLAMMABLE, N.O.S.
Hazard Class: 8
UN Number: 2734
Packing group: II
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: C
Risk Phrases:
R 22 Harmful if swallowed.
R 34 Causes burns.
Safety Phrases:
S 25 Avoid contact with eyes.
S 36/37/39 Wear suitable protective clothing, gloves
and eye/face protection.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 150-77-6: No information available.
Canada
CAS# 150-77-6 is listed on Canada's NDSL List.
CAS# 150-77-6 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 150-77-6 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 6/03/1998 Revision #3 Date: 6/07/2004
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
L-Epicatechin, Mixture of ca.60% (-)-Epicatechin and ca.40% Catechin
| 490-46-0 |
|
2,4,6-Tri-2-Pyridyl-S-Triazine, 99%
| 3682-35-7 |
|
Oxalacetic acid, 96%
| 328-42-7 |
|
Nile Blue Hydrochloride
| 2381-85-3 |
|
Dimethylsulfamoyl Chloride, 97%
| 13360-57-1 |
|
Adenine Sulfate 98%
| 321-30-2 |
|
3,3'-Diethylthiatricarbocyanine Iodide
| 3071-70-3 |
|
7-Chlortetracycline Monohydrochloride, Potency 900 mu/mg
| 64-72-2 |
|
4-Aminobenzoic Acid, Sodium Salt, 99%
| 555-06-6 |
|
Sodium Thiocarbonate (40% in Water)
| 534-18-9 |
|
n-Acetyl-s-benzyl-l-cysteine
| 19542-77-9 |
|
3-Hydroxypropionitrile, 98%
| 109-78-4 |
|
2-Ethylhexanoic acid, 99%
| 149-57-5 |
|
Trans,Trans-1,4-Diphenyl-1,3-Butadiene, 99%
| 886-65-7 |
|
Benzyl chloride, stabilized, 99.5+% (with 0.25% propylene oxide)
| 75-56-9 |
|
Benzyl chloride, pract., 90%
| 100-44-7 |
|
Azure b, high purity biological stain
| 531-55-5 |
|
4-Amino-3-Hydroxy-1-Naphthalenesulfonic Acid, 95%
| 116-63-2 |
|
2-Bromoethylamine Hydrobromide, 99%
| 2576-47-8 |
|
2-Nitrophenol, 99%
| 88-75-5 |
|
Diethoxydimethylsilane, 97%
| 78-62-6 |
|
Calcium sulfate, anhydrous, 99%
| 7778-18-9 |
|
Drierite, 6 mesh, without indicator
| 7778-18-9 |
|
Drierite, 8 mesh, without indicator
| 7778-18-9 |
|
Drierite, 10-20 mesh, without indicator
| 7778-18-9 |
|
Drierite, 20-40 mesh, without indicator
| 7778-18-9 |
|
Drierite, 4 mesh, with indicator
| 7778-18-9 |
|
Drierite, 8 mesh, with indicator
| 7778-18-9 |
|
Drierite, 20-40 mesh, with indicator
| 7778-18-9 |
|
4,4,4-Trifluoro-1-phenyl-1,3-butanedione, 99%
| 326-06-7 |
|
2-Bromoethanesulfonic Acid, Sodium Salt, 98%
| 4263-52-9 |
|
Sodium 4-Nitrophenoxide, Hydrate, 98% (On Dry Basis)
| 824-78-2 |
|
2-Octylamine
| 693-16-3 |
|
4-Nitrobenzyl chloride, 99%
| 100-14-1 |
|
Palmitic Acid, 98% (GC)
| 57-10-3 |
|
n-Butyllithium, 1.6M solution in hexanes
| 109-72-8 |
|
n-Butyllithium (15% in heptane)
| 109-72-8 |
|
Barium Fluoride, 99.99%
| 7787-32-8 |
|
Decanoic Acid (Capric Acid), 96%
| 334-48-5 |
|
trans-4-Butyl-alpha-chloro-4'-etoxystilben 99+%
| 54513-47-2 |
|
Cyclohexanepropionic Acid, 99%
| 701-97-3 |
|
Carbon tetrachloride, 99%
| 56-23-5 |
|
Carbon Tetrachloride, P.A.
| 56-23-5 |
|
Carbon Tetrachloride, Low Absorbance at 2900 to 3050 cm-1
| 56-23-5 |
|
Lauric Acid, 95%
| 143-07-7 |
|
N,N,N',N'-Tetraethylethylenediamine
| 150-77-6 |
|
Phenyl chloroformate, 99% (gc)
| 1885-14-9 |
|
Methyl-p-benzoquinone, 99+%
| 553-97-9 |
|
1-Phenylpiperazine, 97%
| 92-54-6 |
|
3,4-Dimercaptotoluene, 99%
| 496-74-2 |
|
|