**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 2491-17-0 |1-Cyclohexyl-3-(2-Morpholinoethyl)Carb| 95% | 219-650-3 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.Moisture sensitive.
Potential Health Effects
Eye:
Causes eye irritation. May cause chemical conjunctivitis.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea.
Inhalation:
Causes respiratory tract irritation. Can produce delayed pulmonary
edema.
Chronic:
Effects may be delayed.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If breathing
is difficult, give oxygen. Get medical aid. Do NOT use mouth-to-mouth
resuscitation. If breathing has ceased apply artificial respiration
using oxygen and a suitable mechanical device such as a bag and a
mask.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Runoff from
fire control or dilution water may cause pollution.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Do NOT get water
inside containers. Use water spray, dry chemical, carbon dioxide, or
appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation. Do not get water inside containers.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Minimize dust generation and accumulation. Avoid
contact with eyes, skin, and clothing. Keep container tightly closed.
Avoid ingestion and inhalation. Use with adequate ventilation. Do not
allow contact with water. Keep from contact with moist air and steam.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. Keep
refrigerated. (Store below 4C/39F.) Store protected from moisture.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 2491-17-0:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Powder
Color: white to beige
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: @ 760.00mm Hg
Freezing/Melting Point: 113.00 - 115.00 deg C
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: soluble in water
Specific Gravity/Density:
Molecular Formula: C21H33N3O4S
Molecular Weight: 423.57
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions. May decompose on exposure to moist air or
water.
Conditions to Avoid:
Incompatible materials, dust generation, moisture, excess heat,
strong oxidants.
Incompatibilities with Other Materials:
Oxidizing agents, strong acids, moisture.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, irritating and toxic fumes and
gases, carbon dioxide, nitrogen.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 2491-17-0 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
1-Cyclohexyl-3-(2-Morpholinoethyl)Carbodiimide
Metho-P-Toluenesulfonate -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 28A After contact with skin, wash immediately with
plenty of water.
WGK (Water Danger/Protection)
CAS# 2491-17-0: No information available.
Canada
CAS# 2491-17-0 is listed on Canada's DSL List.
CAS# 2491-17-0 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 2491-17-0 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 9/02/1997 Revision #5 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Ethyl delta-bromo-beta,beta-dimethyl levulinate, 96%
| 197234-17-6 |
|
1-Cyclohexyl-3-(2-Morpholinoethyl)Carbodiimide
| 2491-17-0 |
|
3-Chloroanisole, 99%
| 2845-89-8 |
|
2-Acetamidoacrylic acid, 99+ %
| 5429-56-1 |
|
Bianthrone
| 434-85-5 |
|
1-(4-Chlorophenyl)-1-cyclopentanecarbonyl chloride, 97%
| 71501-44-5 |
|
Acetic acid-d, 98 atom % d
| 758-12-3 |
|
n-Phenyl-1-naphthylamine, 98%
| 90-30-2 |
|
5-Methyl-2-Nitrobenzyl Chloride
| 66424-91-7 |
|
2-Hydroxy-4-Methoxybenzophenone, 98%
| 131-57-7 |
|
Myristyltrimethylammonium bromide, 99% (ti tr.)
| 1119-97-7 |
|
Cyclododecanone, 99+%
| 830-13-7 |
|
4,4'-Biphenol, 97%
| 92-88-6 |
|
Diphenylacetylene (Tolan), 99%
| 501-65-5 |
|
Dicyclohexyl Phenyl Phosphine
| 6476-37-5 |
|
(+/-)-2-azabicyclo2.2.1hept-5-en-3-one 98% (hplc)
| 49805-30-3 |
|
Iron (III) Sulfate Tetrahydrate, Reagent (Powder), 97% (Titr.)
| 15244-10-7 |
|
Phenyl Isocyanate (Pract), 98% (gc)
| 103-71-9 |
|
3,5-Dichlorosalicylaldehyde
| 90-60-8 |
|
1,5-Dicyanopentane, 98%
| 646-20-8 |
|
2-Pyridinecarboxaldehyde, 99%
| 1121-60-4 |
|
Lithium Iodide, Anhydrous, 99%
| 10377-51-2 |
|
Alginic Acid, Sodium Salt
| 9005-38-3 |
|
(2R,3R)-1-Carboxy-4,5-dichloro-2,3-dihydroxycyclohexa-4,6-diene
| 205587-32-2 |
|
4-Chloro-3-Nitrobenzoic Acid, 99.5%
| 96-99-1 |
|
Barium Titanate(iv), 99%
| 12047-27-7 |
|
2,3-Dichloro-5,6 Dicyano-1,4-Benzoquinone, 98%
| 84-58-2 |
|
Triethanolamine hydrochloride
| 637-39-8 |
|
2,6-Diisopropylaniline, 95%
| 24544-04-5 |
|
3-Quinuclidinol, 99%
| 1619-34-7 |
|
n,n-Dimethylformamide diethyl acetal, 98%
| 1188-33-6 |
|
(R)-4-Benzyl-2-oxazolidinone, 99%, (>99% e.e.)
| 102029-44-7 |
|
2-Ethylimidazole, 98%
| 1072-62-4 |
|
All-Trans-Retinoic Acid 97%
| 302-79-4 |
|
Bis(2-Ethylhexyl) Terephthalate, 98.5% (GC)
| 6422-86-2 |
|
D(+)-10-camphorsulfonic acid 99%
| 3144-16-9 |
|
1,6-Hexanedithiol, 97%
| 1191-43-1 |
|
Ferric benzoylacetonate
| 14323-17-2 |
|
3-Chlorophenyl isothiocyanate
| 2392-68-9 |
|
1-Bromodecane, 98%
| 112-29-8 |
|
Didodecyldimethylammonium bromide, 99%
| 3282-73-3 |
|
1,4-Cyclohexadiene, 97%
| 628-41-1 |
|
Dl-3-(alpha-acetonyl-4'-chlorobenzyl)- 4-hydroxycoumarin, 98%
| 81-82-3 |
|
3-Nitrophenol, 99%
| 554-84-7 |
|
O,O-Dimethyl-1-Hydroxy-2,2,2-Trichloroethylphosphonate, 98%
| 52-68-6 |
|
Allyl Chloride
| 107-05-1 |
|
1,2,3,4-Tetrahydroacridine-9-Carboxylic Acid Dihydrate
| 38186-54-8 |
|
1-Bromododecane, 98%
| 143-15-7 |
|
Ethyl 2,4-dioxovalerate, 98%
| 615-79-2 |
|
Arsenazo I, Indicator Grade
| 520-10-5 |
|
|