**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 4441-30-9 |3-Morpholinopropanol | ca 100 | unlisted |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to eyes.The toxicological properties of this material
have not been fully investigated.
Potential Health Effects
Eye:
Causes eye irritation. May cause chemical conjunctivitis.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Do NOT induce vomiting. If conscious and alert, rinse mouth and
drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Vapors may be heavier
than air. They can spread along the ground and collect in low or
confined areas. Containers may explode when heated.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Cool containers with
flooding quantities of water until well after fire is out. Use water
spray, dry chemical, carbon dioxide, or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Avoid runoff into storm sewers and ditches which lead to waterways.
Clean up spills immediately, observing precautions in the Protective
Equipment section. Absorb spill using an absorbent, non-combustible
material such as earth, sand, or vermiculite. Do not use combustible
materials such as sawdust. Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use with adequate ventilation. Avoid
contact with eyes, skin, and clothing. Keep container tightly closed.
Avoid ingestion and inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 4441-30-9:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: Clear - colorless, oily
Odor: alcohol-like
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density:
Molecular Formula: C7H15NO2
Molecular Weight: 145.1105
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, excess heat.
Incompatibilities with Other Materials:
Oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, irritating and toxic fumes and
gases, carbon dioxide.
Hazardous Polymerization: Has not been reported
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 4441-30-9: QE9104700
LD50/LC50:
Not available.
Carcinogenicity:
3-Morpholinopropanol -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Products which are considered hazardous for supply are classified as Special
Waste and the disposal of such chemicals is covered by regulations which may
vary according to location. Contact a specialist disposal company or the local
waste regulator for advice. Empty containers must be decontaminated before
returning for recycling.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
No information available.
IMO
No information available.
RID/ADR
No information available.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36 Irritating to eyes.
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 4441-30-9: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 4441-30-9 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 4441-30-9 is not listed on the TSCA inventory.
It is for research and development use only.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 12/02/1999 Revision #3 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
4-Chloromethyl-2-methylquinoline hydrochloride
| 0-00-1 |
|
2,4,5-Trifluoroaniline, 99%
| 367-34-0 |
|
2,4-Diamino-5-Phenylthiazole Monohydrobromide
| 6020-54-8 |
|
1,4-Dibromobenzene-d4, 98 atom% D
| 4165-56-4 |
|
5-Hydroxy-1-Naphthalenesulfonamide, 98%
| 17286-26-9 |
|
2-Ethyl-1,3-Cyclopentanedione, 99%
| 823-36-9 |
|
Sodium persulfate, 5-25% w/v
| 7732-18-5 |
|
3-Buten-2-ol, 98%
| 598-32-3 |
|
Tert.-butan(ol-d), 98+ atom % d
| 3972-25-6 |
|
Copper(II) chromate
| 13548-42-0 |
|
Five Alcohol Blend
| 67-63-0 |
|
Gas Generating Kit (Campylobacter System)
| 87-69-4 |
|
(Bromodifluoromethyl)triphenylphosphonium bromide, 97%
| 58201-66-4 |
|
Lancerclean Detergent
| 0-00-1 |
|
Casein, Tech.
| 9000-71-9 |
|
Lancerinse Lancer Acid
| 64-19-7 |
|
Sodium Hydroxide 6.25% W/V
| 1310-73-2 |
|
Oxalic Acid Potassium Salt, Dihydrate, 99% (Titr.)
| 127-96-8 |
|
L-Leucine-(4-Methyl-7-Coumarinylamide) Hydrochloride, 99%
| 62480-44-8 |
|
4 Alcohol Blend
| 71-23-8 |
|
4-(2-Thienyl)-3-O-MOP-B-Lactam
| 0-00-1 |
|
2,6-Dichloro-3-Nitrobenzenesulfonamide, 98%
| 89281-19-6 |
|
Water--UK
| 7732-18-5 |
|
Orthophosphoric acid, 2.5% w/w
| 7664-38-2 |
|
0.1% Trifluoroacetic acid blended into acetonitrile
| 75-05-8 |
|
3-Morpholinopropanoic Acid Hydrobromic Salt
| 4497-04-5 |
|
3-Morpholinopropanol
| 4441-30-9 |
|
3-Morpholinopropanal 1M solution in acetone
| 67-64-1 |
|
3-(N-Methylpiperazine)-Propanoic Acid Hydrobromide Salt
| 0-00-1 |
|
3-(N-Methylpiperazine)-Propanol
| 5317-33-9 |
|
3-(N-Methylpiperazine)propanal 1M solution in acetone.
| 0-00-1 |
|
3-(N-Methylpiperazine)-Propyl Bromide Hydrobromic Salt
| 0-00-1 |
|
3-[1H-(1,2,4-Triazolyl)]-Propanoic Acid
| 76686-84-5 |
|
3-[1H-(1,2,4-Triazolyl)]-Propanol
| 84497-70-1 |
|
3-[1H-(1,2,4-Triazoyl)]-Propanal 10% wt/v Solution in Dichloromethane
| 0-00-1 |
|
3-[1H-(1,2,4-Triazolyl)]-Propylbromide Hydrobromide Salt
| 0-00-1 |
|
3-[1H-(1,2,4-Triazoyl)]-Propanamine Dihydrochloride Salt
| 69807-82-5 |
|
Aqualine Electrolyte CG
| 67-56-1 |
|
Ethyl-2-Bromobenzoate, 98%
| 6091-64-1 |
|
Aqualine Electrolyte AG
| 0-00-0 |
|
2,6-Dichloro-3-nitrobenzenesulfonamide
| 89281-19-6 |
|
Oxoid Anaerogen
| 50-81-7 |
|
Pyridine, 65% in Water
| 110-86-1 |
|
Trans-1-Acetyl-4-Hydroxy-2-Proline
| 33996-33-7 |
|
1,1,1-Trifluoro-2,4-Pentanedione, 98%
| 367-57-7 |
|
Diaminethanetetra-Acetic Acid, Disodium Salt, 18.5 g/L Solution.
| 0-00-1 |
|
Sulfuric Acid/Orthophosphoric Acid Mixture
| 7664-38-2 |
|
Amberlyst xn-1010 ion-exchange resin
| 54991-00-3 |
|
Tetrakis(triphenylphosphine)nickel(0)
| 15133-82-1 |
|
Sodium Carbonate 0.274N
| 497-19-8 |
|
|