Search   
MSDS 
:
 1-Pyrrolidinecarbodithioic acid, ammonium salt
CAS 
:
 5108-96-3
SYNONYMS 
:
 Ammonium pyrrolidinedithiocarbamate; Ammonium     1-pyrrolidinedithiocarbamate; APDC; Pyrrolidinedithiocarbamate,     ammonium derivative; APDTC; Ammonium pyrrolidine-1-carbodithioate.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 5108-96-3 |1-Pyrrolidinecarbodithioic acid, ammon| >95 | 225-834-4 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.Air sensitive.

Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
Ingestion of large amounts may cause gastrointestinal irritation.
Inhalation:
Causes respiratory tract irritation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Flush skin with plenty of water for at least 15 minutes while
removing contaminated clothing and shoes. Get medical aid if
irritation develops or persists. Wash clothing before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid if cough or other symptoms appear.
Notes to Physician:

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. This
material in sufficient quantity and reduced particle size is capable
of creating a dust explosion.
Extinguishing Media:
Use water spray, dry chemical, carbon dioxide, or chemical foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Minimize dust
generation and accumulation. Avoid contact with eyes, skin, and
clothing. Store and handle protected from air. Avoid breathing dust.
Storage:
Store in a cool, dry place. Keep refrigerated. (Store below
4C/39F.) Keep under a nitrogen blanket. Keep from contact with
oxidizing materials. Keep containers tightly closed.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 5108-96-3:


Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Crystalline powder
Color: white to yellow
Odor: None reported
pH: Not available.
Vapor Pressure: Negligible.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: 148-155 deg C
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: > 155 deg C
Solubility in water: Soluble.
Specific Gravity/Density: Not available.
Molecular Formula: C5H12N2S2
Molecular Weight: 164.28

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable. However, may decompose if heated.
Conditions to Avoid:
Light, dust generation, exposure to air, excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong acids, strong bases.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, oxides of sulfur, carbon dioxide.
Hazardous Polymerization: Will not occur.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 5108-96-3 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
1-Pyrrolidinecarbodithioic acid, ammonium salt -
Not listed by ACGIH, IARC, or NTP.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 37/39 Wear suitable gloves and eye/face
protection.
WGK (Water Danger/Protection)
CAS# 5108-96-3: No information available.
Canada
CAS# 5108-96-3 is listed on Canada's DSL List.
CAS# 5108-96-3 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 5108-96-3 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 4/29/1998 Revision #3 Date: 5/20/2005

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
1,2-Dichloroethane, extra dry, water <50 ppm 107-06-2
1-Pyrrolidinecarbodithioic acid, ammonium salt 5108-96-3
Cyclohexane, Extra Dry, Water <50 ppm 110-82-7
1,2-Cyclohexanedione, 98% 765-87-7
Dichloromethane, Extra Dry, Water <30 ppm 75-09-2
Ether, extra dry, water <50 ppm 60-29-7
Dimethylformamide, extra dry, water <30 ppm 68-12-2
Methyl sulfoxide, extra dry, water <50 ppm 67-68-5
1,4-Dioxane, extra dry, water <50 ppm 123-91-1
4-Acetamidophenol, 98% 103-90-2
Acetyl chloride 75-36-5
Ethyl Acetate, Extra Dry, Water <50 ppm 141-78-6
Rhodium(III) Chloride Trihydrate 38% Rh 20765-98-4
Ammonium Sulfate, Reagent ACS (crystals) 7783-20-2
n-Heptane, extra dry, water <30 ppm 108-87-2
n-Hexane, extra dry, water <20 ppm 110-54-3
N-Methylpyrrolidinone, extra dry, water <50 ppm 872-50-4
Ammonium thiocyanate, reagent acs (crystals) 1762-95-4
2,2,4-Trimethylpentane, extra dry, water <30 ppm 540-84-1
Methyl alcohol, extra dry, water <50 ppm 67-56-1
Disperse Orange 1 2581-69-3
Isopropanol, Extra Dry, Water <50 ppm 67-63-0
Ammonium metavanadate, p.a. 7803-55-6
Tetrahydrofuran, Extra Dry, Water <50 ppm 109-99-9
Aniline, P.A. 62-53-3
Toluene, Extra Dry, Water <10 ppm 108-88-3
Antimony, p.a., powder, 0.15 mm 7440-36-0
Benzyltriphenylphosphonium Tetrafluoroborate, 97% 31240-52-5
n-Butyrophenone, 99% 495-40-9
Potassium antimonyl-tartrate hemihydrate 99+% 28300-74-5
2,3-Dimethylfuran, 99% 14920-89-9
Tween 85 9055-70-3
Antimony trichloride, reagent ACS, crystals, 99+% 10025-91-9
Tween 40 9005-66-7
Antimony(III) Oxide, 99+% 1309-64-4
2-Amino-3,5-Dibromobenzaldehyde, 97% 50910-55-9
Piperonyl Butoxide, Tech., 90% 51-03-6
Arsenic (III) Oxide, P.A. 1327-53-3
4'-Bromo-3-Chloropropiophenone, 99% 31736-73-9
l(+)-Aspartic acid, 98+% 56-84-8
Meldola's Blue 7057-57-0
d-(+)-Isoascorbic acid,sodium salt, 98% 6381-77-7
Auramine O (Cert) 2465-27-2
4-Bromomethyl-3-Nitrobenzoic Acid 55715-03-2
Barbituric Acid, 99+% 67-52-7
3-(Trifluoromethoxy)Cinnamic Acid 0-01-1
(S)-(+)-Nalpha-Benzyl-N??-BOC-L-Hydrazinovaline 0-01-1
1,2-Epoxy-9-Decene, 96% 85721-25-1
Barium Acetate, Reagent ACS (Granular) 543-80-6
trans-1,4-Dichloro-2-butene, 95% 110-57-6

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net