**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 5329-14-6 |Sulfamic Acid | 98+ | 226-218-8 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to eyes and skin.The toxicological properties of this
material have not been fully investigated.
Potential Health Effects
Eye:
Causes eye irritation. Concentrated solutions may produce
corrosive effects. May cause chemical conjunctivitis.
Skin:
Causes skin irritation. Contact with the liquid or high
concentration of vapors may cause blistering of the skin.
Concentrated solutions may produce corrosive effects.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea.
Inhalation:
May cause respiratory tract irritation. Can produce delayed
pulmonary edema.
Chronic:
Chronic inhalation and ingestion may cause effects similar to those
of acute inhalation and ingestion. Effects may be delayed.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Flush skin with plenty of soap and water for at
least 15 minutes while removing contaminated clothing and shoes. Wash
clothing before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid.
Inhalation:
Remove from exposure to fresh air immediately. If not breathing,
give artificial respiration. If breathing is difficult, give oxygen.
Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use extinguishing media most appropriate for the surrounding fire.
Use water spray, dry chemical, carbon dioxide, or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up or absorb material, then place into a
suitable clean, dry, closed container for disposal. Avoid generating
dusty conditions. Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use only in a well-ventilated area. Minimize dust
generation and accumulation. Avoid contact with eyes, skin, and
clothing. Keep container tightly closed. Avoid ingestion and
inhalation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR ??1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant a respirator's use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Solid
Appearance: white
Odor: odorless
pH: 1.2
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Decomposes
Freezing/Melting Point: 205 deg C
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: 205 deg C
Solubility in water: Soluble.
Specific Gravity/Density: 2.15
Molecular Formula: H3 N O3 S
Molecular Weight: 97.1
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong bases.
Hazardous Decomposition Products:
Nitrogen oxides, oxides of sulfur, irritating and toxic fumes and
gases, ammonia and/or derivatives.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 5329-14-6: WO5950000
LD50/LC50:
CAS# 5329-14-6: Draize test, rabbit, eye: 20 mg Moderate; Draize
test, rabbit, eye: 250 ug/24H Severe; Draize test, rabbit, skin: 500
mg/24H Severe; Oral, mouse: LD50 = 1312 mg/kg; Oral, rat: LD50 =
3160 mg/kg.
Carcinogenicity:
Sulfamic Acid -
Not listed by ACGIH, IARC, NIOSH, NTP, or OSHA.
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: SULPHAMIC ACID
Hazard Class: 8
UN Number: 2967
Packing Group: III
IMO
Shipping Name: SULPHAMIC ACID
Hazard Class: 8
UN Number: 2967
Packing Group: III
RID/ADR
Shipping Name: SULPHAMIC ACID
Dangerous Goods Code: 8(16C)
UN Number: 2967
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/38 Irritating to eyes and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 28 After contact with skin, wash immediately
with...
WGK (Water Danger/Protection)
CAS# 5329-14-6: 1
United Kingdom Occupational Exposure Limits
Canada
CAS# 5329-14-6 is listed on Canada's DSL List.
CAS# 5329-14-6 is listed on Canada's Ingredient Disclosure List.
Exposure Limits
US FEDERAL
TSCA
CAS# 5329-14-6 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 6/24/1999 Revision #1 Date: 8/02/2000
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Sodium peroxide, p.a.
| 1313-60-6 |
|
(+)-(1S,2R)-2-Amino-1-Cyclopentanecarboxylic Acid
| 64191-14-6 |
|
1,2,3,4-Tetrahydroisoquinoline-3-carboxylic acid hydrochloride, 98%
| 35186-99-3 |
|
2-Amino-3-Chloro-5-Nitrobenzonitrile, 98%
| 20352-84-5 |
|
Sodium phosphate, dibasic heptahydrate, reagent ACS, crystals
| 7558-79-4 |
|
Adipic Acid Monomethyl Ester, 98%
| 627-91-8 |
|
4-Methyl-3-nitrophenol, 98%
| 2042-14-0 |
|
6-Fluoroindole, 98%
| 399-51-9 |
|
Potassium sodium tartrate tetrahydrate, p.a.
| 6381-59-5 |
|
Methylboronic acid, 97%
| 13061-96-6 |
|
Sodium Pyrophosphate Decahydrate, P.A.
| 13472-36-1 |
|
Dotriacontane, 99% (GC)
| 544-85-4 |
|
Salicylic Acid, Sodium Salt, P.A.
| 54-21-7 |
|
Sodium sulfate, powder, anhydrous, 99%, p.a.
| 7757-82-6 |
|
4-Chlorobenzyl Chloride, 99+% (GC)
| 104-83-6 |
|
Sodium Sulfite, Anhydrous, P.A.
| 7757-83-7 |
|
Sodium Thiocyanate, Reagent ACS (Crystals)
| 540-72-7 |
|
3-Tolylboronic acid, 97%
| 17933-03-8 |
|
4-Tolylboronic acid, 97%
| 5720-05-8 |
|
4-Chlorophenylboronic Acid, 97%
| 1679-18-1 |
|
3-Fluorophenylboronic Acid, 97%
| 768-35-4 |
|
Sodium Thiosulfate, Anhydrous
| 7772-98-7 |
|
4-Carboxyphenylboronic Acid, 97%
| 14047-29-1 |
|
3-Carboxyphenylboronic acid, 98%
| 25487-66-5 |
|
2-Carboxyphenylboronic acid, 97%
| 149105-19-1 |
|
2-Methoxyphenylboronic Acid, 97%
| 5720-06-9 |
|
Hexahydro-4-Methylphthalic Anhydride, 98% Mixture of Cis and Trans
| 19438-60-9 |
|
Sodium Thiosulfate Pentahydrate, P.A.
| 10102-17-7 |
|
Sodium Tripolyphosphate, Tech., 85%
| 7758-29-4 |
|
Sodium tungstate, dihydrate, reagent acs
| 10213-10-2 |
|
Biuret, 99% (TLC)
| 108-19-0 |
|
Tin(IV) Chloride, 99.999%
| 7646-78-8 |
|
Tin (II) Chloride, Anhydrous, 98%
| 7772-99-8 |
|
Tin (II) Oxide, 98+%
| 21651-19-4 |
|
Tin (II) Sulfate, 99%
| 7488-55-3 |
|
3-Nitrophenylboronic acid, 97%
| 13331-27-6 |
|
(2S,3R)-2-Amino-3-Hydroxy-4-Methylpentanoic Acid, 99+% e.e.
| 10148-71-7 |
|
4-(Methylthio)phenylboronic acid, 97%
| 98546-51-1 |
|
Starch, mais
| 9005-25-8 |
|
Styrene, P.A., Stabilized With 10-15 ppm p-Tert-Butylcatechol
| 100-42-5 |
|
3-Thiopheneboronic acid, 97%
| 6165-69-1 |
|
1,3-Dichloro-1,1,3,3-tetraisopropyldisiloxane, 96% (GC)
| 69304-37-6 |
|
2-Thiopheneboronic acid
| 6165-68-0 |
|
1-Naphthaleneboronic Acid, 97%
| 13922-41-3 |
|
n-Hexylboronic Acid
| 16343-08-1 |
|
Sucrose
| 57-50-1 |
|
Sulfamic Acid, 98+%
| 5329-14-6 |
|
Sulfanilamide, 98%
| 63-74-1 |
|
Ethyl 2-amino-1-cyclopentene-1-carboxylate 99%
| |
|
Sulfanilic Acid, 99+%
| 121-57-3 |
|
|