**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 5447-99-4 |3-Nitro-2-pentanol | 99.0 | 226-669-0 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
The toxicological properties of this material have not been fully
investigated.Combustible liquid.
Potential Health Effects
Eye:
Non-irritating to the eyes.
Skin:
Non-irritating to the skin.
Ingestion:
Low hazard for usual industrial handling. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Flush skin with plenty of water for at least 15 minutes while
removing contaminated clothing and shoes. Get medical aid if
irritation develops or persists. Wash clothing before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid. Wash mouth out with water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid if cough or other symptoms appear.
Notes to Physician:
Antidote:
None reported.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Will burn if involved in a fire. Use water spray to
keep fire-exposed containers cool. Combustible liquid. Vapors may be
heavier than air. They can spread along the ground and collect in
low or confined areas. Containers may explode when heated.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam. Use water spray to cool fire-exposed
containers.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Remove all sources of ignition.
Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use only in a well-ventilated area.
Avoid breathing dust, vapor, mist, or gas. Avoid contact with eyes,
skin, and clothing. Empty containers retain product residue, (liquid
and/or vapor), and can be dangerous. Keep container tightly closed.
Keep away from heat, sparks and flame. Avoid ingestion and
inhalation. Do not pressurize, cut, weld, braze, solder, drill,
grind, or expose empty containers to heat, sparks or open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 5447-99-4:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: colorless to light yellow
Odor: Not available.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 60 deg C @ .50mm Hg
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 90 deg C ( 194.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: 1.0750g/cm3
Molecular Formula: C5H11NO3
Molecular Weight: 133.15
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 5447-99-4 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
3-Nitro-2-pentanol -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
Other
No information available.
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 5447-99-4: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 5447-99-4 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 5447-99-4 is not listed on the TSCA inventory.
It is for research and development use only.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 2/10/1999 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Diethylbenzene (Mixture of 1,2-1,3-and 1,4-Isomers, Sum Min. 95%)
| 25340-17-4 |
|
5-Ethyl-2-thiophenecarboxaldehyde, 98+%
| 36880-33-8 |
|
4-Amino-Heptafluorotoluene, 95% (GC)
| 0-00-1 |
|
Flavone, 99+% (TLC)
| 525-82-6 |
|
4-Bromo-1-Chloro-2-Fluorobenzene, 98+%
| 60811-18-9 |
|
2,6-Dibromoaniline, 97%
| 608-30-0 |
|
4-Epi-Oxytetracycline,"can be used as Secondary Standard"
| 35259-39-3 |
|
Polyvinylsulfuric acid potassium salt, 90% (elem.analysis, c, h, k
| 26837-42-3 |
|
1,8-Naphthalimide, 94%(tlc)
| 81-83-4 |
|
4-Bromo-1,1,2-trifluoro-1-butene
| 10493-44-4 |
|
Diethyl Sebacate, 90% (gc)
| 110-40-7 |
|
trans-3-Hexen-1-ol, 95% (gc)
| 928-97-2 |
|
Resorufin (pract)
| 635-78-9 |
|
Adenosine 5'-Monophosphate, 99%
| 61-19-8 |
|
l-(+)-Norleucine, 99+%
| 327-57-1 |
|
3,4-Difluoronitrobenzene, 99%
| 369-34-6 |
|
2-Ethylthiophene, 99%
| 872-55-9 |
|
Adenosine-2'-Monophosphate Hemihydrate, 99%
| 81012-86-4 |
|
Exton Albumin Reagent
| 97-05-2 |
|
n-Butylurea 99%
| 592-31-4 |
|
2,2-Dimethyl-4-ethenyl-1,3-dioxolane
| 83968-02-9 |
|
N-Methylbenzothiazole-2-Thione, 99%
| 2254-94-6 |
|
Pyrimidine, 99%
| 289-95-2 |
|
Palladium on 1/8" Alumina Pellets (0.5% Pd)
| 1314-08-5 |
|
Dimethyl (2-oxoheptyl)-phosphonate, 98%
| 36969-89-8 |
|
Trimethylacetyl chloride, 99%
| 3282-30-2 |
|
2-Cyclopenten-1-one ethylene ketal, 95%
| 695-56-7 |
|
Tetrazolium violet, 98+%
| 1719-71-7 |
|
2-Bromo-4-Fluorobenzoic acid, 98%
| 1006-41-3 |
|
5-Sulfoisophthalic acid monolithium salt, 98%
| 46728-75-0 |
|
Anhydrochlortetracycline Hydrochloride can be used as Secondary
| 4497-08-9 |
|
3-(Chlorosulfonyl)benzoic acid,98% (titr.)
| 4025-64-3 |
|
Tripiperidinophosphine oxide, 98%
| 4441-17-2 |
|
2,3,3-Trichlorotetrahydro-2H-Pyran, 97+%
| 0-00-1 |
|
1-Methoxy-2-Indanol, 98%
| 56175-44-1 |
|
4'-Methylacetophenone, 95%
| 122-00-9 |
|
1,4-Hexadiene (mixture of cis and trans), 99%
| 592-45-0 |
|
2-Nitrobenzenesulfonyl chloride, 94%
| 1694-92-4 |
|
2-Nitrophenyl-2-acetamido-2-deoxy-alpha-d- glucopyranoside, 99+%
| 10139-01-2 |
|
Phenyl chlorothionocarbonate, 99%
| 1005-56-7 |
|
5-Aminoorotic Acid, 99%
| 7164-43-4 |
|
L-(+)-alpha-Phenylglycine, 99%
| 2935-35-5 |
|
P-Phenylenedipropionic Acid, 98%
| 4251-21-2 |
|
2-(4-Chlorophenyl)-2-Methylpropionic Acid, 98%
| 6247-28-5 |
|
Cyclohexyl Isocyanate, 98%
| 3173-53-3 |
|
4-(Trifluoromethoxy)benzyl bromide, 99+%
| 50824-05-0 |
|
1,3-Diiodobenzene
| 626-00-6 |
|
Trimethyl borate, 99%
| 121-43-7 |
|
Trifluoroacetic acid, silver salt, 98%
| 2966-50-9 |
|
3-Nitro-2-pentanol, 99%
| 5447-99-4 |
|
|