**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 5683-33-0 |2-Dimethylaminopyridine, 97% | | 227-147-5 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 10 36/37/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Flammable. Irritating to eyes, respiratory system and skin.
Potential Health Effects
The toxicological properties of this material have not been
investigated. Use appropriate procedures to prevent opportunities
for direct contact with the skin or eyes and to prevent inhalation.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower lids. Immediately flush eyes
with plenty of water for at least 15 minutes, occasionally lifting
the upper and lower lids. Get medical aid immediately.
Skin:
Get medical aid. Flush skin with plenty of soap and water for at
least 15 minutes while removing contaminated clothing and shoes.
Remove contaminated clothing and shoes.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Get medical aid immediately. Do NOT induce vomiting. Allow the victim
to rinse his mouth and then to drink 2-4 cupfuls of water, and seek
medical advice.
Inhalation:
Get medical aid immediately. Remove from exposure to fresh air
immediately. If not breathing, give artificial respiration. If
breathing is difficult, give oxygen.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Flammable Liquid.
Extinguishing Media:
In case of fire, use water, dry chemical, chemical foam, or
alcohol-resistant foam. Use agent most appropriate to extinguish
fire.
Autoignition Temperature: 430 deg C ( 806.00 deg F)
Flash Point: 47 deg C ( 116.60 deg F)
NFPA Rating: Not published.
Explosion Limits, Lower: Not available.
Upper: Not available.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material, (e.g., dry sand or earth), then
place into a chemical waste container. Clean up spills immediately,
observing precautions in the Protective Equipment section.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Empty containers retain product residue, (liquid and/or vapor), and
can be dangerous. Avoid contact with heat, sparks and flame. Do not
pressurize, cut, weld, braze, solder, drill, grind, or expose empty
containers to heat, sparks or open flames.
Storage:
Keep away from heat, sparks, and flame. Flammables-area.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use adequate general or local exhaust ventilation to keep airborne
concentrations below the permissible exposure limits. Use process
enclosure, local exhaust ventilation, or other engineering controls
to control airborne levels.
Personal Protective Equipment
Eyes:
Wear chemical goggles. Wear safety glasses and
chemical goggles if splashing is possible.
Skin:
Wear appropriate protective gloves and clothing to
prevent skin exposure. Wear appropriate protective
gloves to prevent skin exposure.
Clothing:
Wear appropriate protective clothing to minimize
contact with skin.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR ??1910.134 and ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant a
respirator's use. Wear a NIOSH/MSHA-approved (or
equivalent) full-facepiece airline respirator in the
positive pressure mode with emergency escape
provisions.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Not available.
Appearance: clear colorless to pale yellow
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Vapor Density: Not available.
Evaporation Rate: Not available.
Viscosity: Not available.
Boiling Point: 191 deg C @ 760.00mm Hg
Freezing/Melting Point: 0 deg C
Decomposition Temperature: Not available.
Solubility: immiscible
Specific Gravity/Density: .9840g/cm3
Molecular Formula: C7H10N2
Molecular Weight: 122.17
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, strong oxidants.
Incompatibilities with Other Materials:
Acids - oxidizing agents.
Hazardous Decomposition Products:
Nitrogen oxides, carbon monoxide, irritating and toxic fumes and
gases, carbon dioxide, nitrogen.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 5683-33-0: US9200000
LD50/LC50:
Not available.
Carcinogenicity:
2-Dimethylaminopyridine, 97% -
Not listed by ACGIH, IARC, NIOSH, NTP, or OSHA.
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
For further information, contact Fisher Scientific.
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
CDG/CPL
IMO
Shipping Name: FLAMMABLE LIQUID, N.O.S.
Hazard Class: 3.3
UN Number: 1993
Packing Group: III
IATA
Shipping Name: FLAMMABLE LIQUID, N.O.S.*
Hazard Class: 3
UN Number: 1993
Packing Group: III
RID/ADR
Shipping Name: FLAMMABLE LIQUID, N.O.S.
Dangerous Goods Code: 3(31C)
UN Number: 1993
Canadian TDG
No information available.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 10 Flammable.
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 16 Keep away from sources of ignition - No
smoking.
S 24/25 Avoid contact with skin and eyes.
WGK (Water Danger/Protection)
CAS# 5683-33-0:
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
WHMIS: Not available.
CAS# 5683-33-0 is not listed on Canada's Ingredient Disclosure List.
Exposure Limits
US FEDERAL
TSCA
CAS# 5683-33-0 is not listed on the TSCA inventory.
It is for research and development use only.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 3/01/1994 Revision #2 Date: 9/02/1997
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall Fisher be liable
for any claims, losses, or damages of any third party or for lost profits
or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if Fisher has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
3,5-Dichloro-2-hydroxybenzenesulfonic Acid, Sodium Salt, 99%
| 54970-72-8 |
|
1,1,3,3-Tetramethylguanidine, 99% (gc)
| 80-70-6 |
|
Carminic Acid 96%
| 1260-17-9 |
|
Azelaic Acid, 98% (Titr.)
| 123-99-9 |
|
4-Chlorobenzyl Mercaptan, 98%
| 6258-66-8 |
|
3-Methyl-2-buten-1-ol, 99%
| 556-82-1 |
|
2-Aminothiazole, 97%
| 96-50-4 |
|
4-Fluorobenzyl bromide, 97%
| 459-46-1 |
|
2-Bromophenol, 98%
| 95-56-7 |
|
(s)-3-Isopropyl-2,5-piperazinedione, 99% ( hplc)
| 16944-60-8 |
|
Hydrogen tetrachloroaurate(III) hydrate, p.a.
| 16903-35-8 |
|
Cholesteryl Linoleate
| 604-33-1 |
|
Ethyl dibromoacetate tech., 83%
| 617-33-4 |
|
2-Thiophenecarbonitrile, 97%
| 1003-31-2 |
|
Oxazine 1 perchlorate, laser grade, 99+% (uv-vis)
| 24796-94-9 |
|
6-Methoxy-2-tetralone, 98%
| 2472-22-2 |
|
Sodium phosphate dibasic, dodecahydrate, p.a.
| 7558-79-4 |
|
2,4,5,6-Tetraaminopyrimidine Sulfate, 98%
| 5392-28-9 |
|
Prostaglandin VII, 96%
| 0-01-1 |
|
4-Anisylchlorodiphenylmethane, 97%
| 14470-28-1 |
|
Glycyl-L-histidyl-L-lysine acetate, 99%
| 62024-09-3 |
|
Methyl p-fluorobenzoylacetate, 99%
| 63131-29-3 |
|
N-Carbobenzyloxy-DL-Serine, 98%
| 2768-56-1 |
|
2,4,6-Trifluoroaniline, 97+%
| 363-81-5 |
|
2,2,6,6-Tetrachlorocyclohexanol, 98%
| 56207-45-5 |
|
Trimethylsulfonium bromide, 99% (titr.)
| 3084-53-5 |
|
3,5-Diaminobenzoic Acid Dihydrochloride, 99%
| 618-56-4 |
|
Perfluorodecalin (mixture of cis and trans), 95%
| 306-94-5 |
|
1-(4'-Iodophenyl)butane, 98%
| 20651-57-4 |
|
2-tert-Butylanthraquinone, 95%
| 84-47-9 |
|
2-Dimethylaminopyridine, 97%
| 5683-33-0 |
|
1-Propanesulfonyl chloride, 99% (titr.)
| 10147-36-1 |
|
5-Phenyl-o-anisidine, 98+%
| 39811-17-1 |
|
Glycoluril, 98+%
| 496-46-8 |
|
Acrolein, stabilized, 97%
| 107-02-8 |
|
2-(4-Methoxybenzoyl)Thiophene, 99%
| 4160-63-8 |
|
Cyclohexylamine, p.a.
| 108-91-8 |
|
2-(Methylthio)ethanol, 99%
| 5271-38-5 |
|
Penicillic Acid
| 90-65-3 |
|
N-Methylcyclohexylamine, 98%
| 100-60-7 |
|
Ethyl 4-Nitrobenzoate, 99%
| 99-76-3 |
|
Tellurium Atomic Absorption Standard Solution, 1 mg/ml Te in 2% KOH
| 236-81-3 |
|
L(-)-Perillyl Alcohol, 85%
| 536-59-4 |
|
4-Epi-Anhydrotetracycline Hydrochloride, "Can be used as Secondary
| 4465-65-0 |
|
Helicin, 99%
| 618-65-5 |
|
Diethyl 2-Bromo-2-Methylmalonate, 98%
| 29263-94-3 |
|
Iminodibenzyl, 97%
| 494-19-9 |
|
N-Phthaloylglycine, 99%
| 4702-13-0 |
|
(+)-Alpha-Pinene, 98%
| 7785-70-8 |
|
3-Hydroxy-2-Naphthoic Acid, 98%
| 92-70-6 |
|
|