Search   
MSDS 
:
 5-Sulfosalicylic acid dihydrate, 98%
CAS 
:
 5965-83-3
SYNONYMS 
:
 3-Carboxy-4-hydroxybenzenesulfonic acid dihydrate;     2-Hydroxy-5-sulfobenzoic acid dihydrate.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 5965-83-3 |5-Sulfosalicylic acid dihydrate | 98 | unlisted |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.The toxicological
properties of this material have not been fully investigated.

Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea. May be harmful if swallowed.
Inhalation:
Causes respiratory tract irritation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid. Immediately flush skin with plenty of water for at
least 15 minutes while removing contaminated clothing and shoes.
Wash clothing before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid. Wash mouth out with water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Dusts at sufficient concentrations can form
explosive mixtures with air. During a fire, irritating and highly
toxic gases may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use extinguishing media most appropriate for the surrounding fire.
Use water spray, dry chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Vacuum or sweep up material and place into a suitable disposal
container. Clean up spills immediately, observing precautions in the
Protective Equipment section. Avoid generating dusty conditions.
Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Remove contaminated clothing and wash before reuse. Minimize dust
generation and accumulation. Avoid contact with eyes, skin, and
clothing. Keep container tightly closed. Avoid ingestion and
inhalation. Use with adequate ventilation. Store protected from
light. Wash clothing before reuse. Avoid breathing dust.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. Store
protected from light.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant a respirator's use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Crystalline powder
Color: white crystalline powder
Odor: Not available
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: 108 - 110 deg C
Autoignition Temperature: Not applicable.
Flash Point: Not applicable.
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: >265 deg C
Solubility in water: insoluble
Specific Gravity/Density:
Molecular Formula: C7H6O6S.2H2O
Molecular Weight: 254.22

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable under normal temperatures and pressures. May discolor on
exposure to light.
Conditions to Avoid:
Light, dust generation, excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong bases.
Hazardous Decomposition Products:
Carbon monoxide, oxides of sulfur, irritating and toxic fumes and
gases, carbon dioxide.
Hazardous Polymerization: Will not occur.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 5965-83-3 unlisted.
LD50/LC50:
Not available.
Oral, rat: LD50 = 1850 mg/kg for anhydrous material (CAS=97-05-2).
Carcinogenicity:
5-Sulfosalicylic acid dihydrate -
Not listed by ACGIH, IARC, or NTP.
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****



**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Shipping Name: ARYLSULPHONIC ACIDS, SOLID
Hazard Class: 8
UN Number: 2585
Packing Group: III
IMO
Shipping Name: ARYLSULPHONIC ACIDS, SOLID
Hazard Class: 8
UN Number: 2585
Packing Group: III
RID/ADR
Shipping Name: ARYLSULPHONIC ACIDS, SOLID
Hazard Class: 8
UN Number: 2585
Packing group: III

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 37/39 Wear suitable gloves and eye/face
protection.
WGK (Water Danger/Protection)
CAS# 5965-83-3: No information available.
United Kingdom Occupational Exposure Limits

United Kingdom Maximum Exposure Limits

Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 5965-83-3 is not listed on Canada's Ingredient Disclosure List.
Exposure Limits
US FEDERAL
TSCA
CAS# 5965-83-3 is not on the TSCA Inventory because it is a hydrate.
It is considered to be listed if the CAS number for the anhydrous form
is on the inventory (40CFR720.3(u)(2)).

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 5/04/1999 Revision #4 Date: 3/04/2004

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Sodium Methoxide Titrant (0.5 M in Methanol) 67-56-1
Octanoic Acid, 99% 124-07-2
Sodium Nitrite, p.a. 7632-00-0
Sodium Nitrite, 99%, contains an anticakin reagent 7632-00-0
Sodium oxalate, pure 62-76-0
Sodium periodate, 99% 100g 7790-28-5
Sodium phosphate, dibasic heptahydrate, p.a. 7558-79-4
Dichloromethane-D2, 99.6+ Atom % D 1665-00-5
2,4-Hexanedione, 99 % (GC) 3002-24-2
Dichloromethane-D2, 99.6+ Atom % D, Packaged in 1.00ml Ampules 1665-00-5
Dichloromethane-D2, 100% D, Packaged in 0.5ml Ampules 1665-00-5
Salicylic Acid,Sodium Salt, 99% 54-21-7
Sodium Sulfate, Anhydrous, 99% 7757-82-6
Sodium Sulfate Crystalline, Anhydrous P.A. 7757-82-6
Sodium Sulfate, Anhydrous, Reagent ACS (Granular) 7757-82-6
Sodium Sulfite, Anhydrous, Reagent ACS (Crystals), 98+% (Titr.) 7757-83-7
Sodium Thiocyanate 98%(Titr., Dry) 540-72-7
Sodium Thiosulfate, 0.1N Standard Solution 7732-18-5
Sodium Thiosulfate, Pentahydrate 10102-17-7
Sodium Thiosulfate, Pentahydrate, Reagent ACS (Crystals) 10102-17-7
Sodium tungstate dihydrate, p.a. 10213-10-2
N-(4-Bromobutyl)-Phthalimide, 98% 5394-18-3
Tin(IV) chloride, anhydrous, 99% 7646-78-8
Tin (II) Oxide, 99+%, -100 Mesh 21651-19-4
Starch, Potato, Hydrolyzed for Electro-phoresis 9005-25-8
1-Dodecanesulfonic Acid Sodium Salt, 99+% 2386-53-0
Starch, Potato (Powder) 9005-25-8
Ethyl Propionate, 99+% (gc) 105-37-3
Poly(4-methyl-1-pentene), low molecular weight 25068-26-2
Cholic acid, 97%(tlc) 81-25-4
Styrene, 99%, Stabilized with 10-15 ppm p-Tert. -Butylcatechol 100-42-5
D(+)-sucrose, biochemical grade 57-50-1
Sucrose, RNase Free and DNAse Free 57-50-1
Sucrose, U.S.P./N.F. 57-50-1
Sucrose, Reagent ACS 57-50-1
Sulfamic Acid, p.a. 5329-14-6
Sulfanilic Acid, 99% 121-57-3
Sulfanilic Acid, Reagent ACS 121-57-3
Triethyl Orthoacetate, 97% 78-39-7
5-Sulfosalicylic acid dihydrate, 98% 5965-83-3
Sulfur, 99.999%, ca.12mm Pieces 7704-34-9
Sulfur, Sublimed, 99.5% 7704-34-9
Sulfuric Acid, P.A. 7664-93-9
Sulfuric Acid, Reagent ACS 7664-93-9
Tannic Acid, 95% 1401-55-4
L-(+)-Tartaric Acid , 99+% 87-69-4
Sodium Sulfide Nonahydrate, P.A. 1313-84-4
Tert.- Amyl Alcohol (2-Methyl-2-Butanol), 99% 75-85-4
Diethoxymethane, 99% 462-95-3
Tetrachloroethylene, 99% 127-18-4

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net