Search   
MSDS 
:
 L-(+)-Tartaric Acid , 99+%
CAS 
:
 87-69-4
SYNONYMS 
:
 2,3-Dihydrosuccinic Acid; 2,3-Dihydroxymutandioic Acid; Threaric     Acid; L-(+)-Tartaric Acid.
**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****

+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 87-69-4 |Tartaric Acid | >99 | 201-766-0 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38

**** SECTION 3 - HAZARDS IDENTIFICATION ****

EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.

Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation. Low hazard for usual industrial handling.
Ingestion:
Causes gastrointestinal irritation with nausea, vomiting and
diarrhea.
Inhalation:
Causes respiratory tract irritation.
Chronic:
No information found.

**** SECTION 4 - FIRST AID MEASURES ****

Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Flush skin with plenty of soap and water for at least 15 minutes
while removing contaminated clothing and shoes. Get medical aid if
irritation develops or persists. Wash clothing before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Do NOT induce
vomiting. If conscious and alert, rinse mouth and drink 2-4 cupfuls
of milk or water. Get medical aid if irritation or symptoms occur.
Inhalation:
Remove from exposure to fresh air immediately. If not breathing,
give artificial respiration. If breathing is difficult, give oxygen.
Get medical aid if cough or other symptoms appear.
Notes to Physician:
Treat symptomatically and supportively.

**** SECTION 5 - FIRE FIGHTING MEASURES ****

General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Use water spray, dry
chemical, carbon dioxide, or appropriate foam.

**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****

General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Avoid runoff into storm sewers and ditches which lead to waterways.
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up or absorb material, then place into a
suitable clean, dry, closed container for disposal. Avoid generating
dusty conditions. Provide ventilation.

**** SECTION 7 - HANDLING and STORAGE ****

Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Minimize dust generation and accumulation. Avoid
contact with eyes, skin, and clothing. Keep container tightly closed.
Avoid ingestion and inhalation. Do not ingest or inhale. Use with
adequate ventilation.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.

**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****

Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Personal Protective Equipment

Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR ??1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant a respirator's use.

**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****

Physical State: Solid
Appearance: white
Odor: odorless
pH: Not available.
Vapor Pressure: Negligible.
Viscosity: Not available.
Boiling Point: Decomposes
Freezing/Melting Point: 170-172 deg C
Autoignition Temperature: 425 deg C ( 797.00 deg F)
Flash Point: 210 deg C ( 410.00 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: 220 deg C
Solubility in water: Soluble in water.
Specific Gravity/Density: Not available.
Molecular Formula: HOOCCH(OH)CH(OH)COOH
Molecular Weight: 150.0384

**** SECTION 10 - STABILITY AND REACTIVITY ****

Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, dust generation, excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, irritating and toxic fumes and gases, carbon
dioxide.
Hazardous Polymerization: Will not occur.

**** SECTION 11 - TOXICOLOGICAL INFORMATION ****

RTECS#:
CAS# 87-69-4: WW7875000
LD50/LC50:
Not available.
Carcinogenicity:
Tartaric Acid -
Not listed by ACGIH, IARC, NIOSH, NTP, or OSHA.
See actual entry in RTECS for complete information.

**** SECTION 12 - ECOLOGICAL INFORMATION ****

Ecotoxicity:
COD 425 mg O2/g
BOD 350 mg O2/g
Biodegradable: 95% after 3 days

**** SECTION 13 - DISPOSAL CONSIDERATIONS ****

Dispose of in a manner consistent with federal, state, and local regulations.

**** SECTION 14 - TRANSPORT INFORMATION ****

IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.

**** SECTION 15 - REGULATORY INFORMATION ****

European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
WGK (Water Danger/Protection)
CAS# 87-69-4: 0
United Kingdom Occupational Exposure Limits

Canada
CAS# 87-69-4 is listed on Canada's DSL List.
CAS# 87-69-4 is not listed on Canada's Ingredient Disclosure List.
Exposure Limits
US FEDERAL
TSCA
CAS# 87-69-4 is listed on the TSCA inventory.

**** SECTION 16 - ADDITIONAL INFORMATION ****

MSDS Creation Date: 2/26/1999 Revision #1 Date: 8/02/2000

The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Search More   
ALL MSDS PAGES IN THIS GROUP
NAMECAS
Sodium Methoxide Titrant (0.5 M in Methanol) 67-56-1
Octanoic Acid, 99% 124-07-2
Sodium Nitrite, p.a. 7632-00-0
Sodium Nitrite, 99%, contains an anticakin reagent 7632-00-0
Sodium oxalate, pure 62-76-0
Sodium periodate, 99% 100g 7790-28-5
Sodium phosphate, dibasic heptahydrate, p.a. 7558-79-4
Dichloromethane-D2, 99.6+ Atom % D 1665-00-5
2,4-Hexanedione, 99 % (GC) 3002-24-2
Dichloromethane-D2, 99.6+ Atom % D, Packaged in 1.00ml Ampules 1665-00-5
Dichloromethane-D2, 100% D, Packaged in 0.5ml Ampules 1665-00-5
Salicylic Acid,Sodium Salt, 99% 54-21-7
Sodium Sulfate, Anhydrous, 99% 7757-82-6
Sodium Sulfate Crystalline, Anhydrous P.A. 7757-82-6
Sodium Sulfate, Anhydrous, Reagent ACS (Granular) 7757-82-6
Sodium Sulfite, Anhydrous, Reagent ACS (Crystals), 98+% (Titr.) 7757-83-7
Sodium Thiocyanate 98%(Titr., Dry) 540-72-7
Sodium Thiosulfate, 0.1N Standard Solution 7732-18-5
Sodium Thiosulfate, Pentahydrate 10102-17-7
Sodium Thiosulfate, Pentahydrate, Reagent ACS (Crystals) 10102-17-7
Sodium tungstate dihydrate, p.a. 10213-10-2
N-(4-Bromobutyl)-Phthalimide, 98% 5394-18-3
Tin(IV) chloride, anhydrous, 99% 7646-78-8
Tin (II) Oxide, 99+%, -100 Mesh 21651-19-4
Starch, Potato, Hydrolyzed for Electro-phoresis 9005-25-8
1-Dodecanesulfonic Acid Sodium Salt, 99+% 2386-53-0
Starch, Potato (Powder) 9005-25-8
Ethyl Propionate, 99+% (gc) 105-37-3
Poly(4-methyl-1-pentene), low molecular weight 25068-26-2
Cholic acid, 97%(tlc) 81-25-4
Styrene, 99%, Stabilized with 10-15 ppm p-Tert. -Butylcatechol 100-42-5
D(+)-sucrose, biochemical grade 57-50-1
Sucrose, RNase Free and DNAse Free 57-50-1
Sucrose, U.S.P./N.F. 57-50-1
Sucrose, Reagent ACS 57-50-1
Sulfamic Acid, p.a. 5329-14-6
Sulfanilic Acid, 99% 121-57-3
Sulfanilic Acid, Reagent ACS 121-57-3
Triethyl Orthoacetate, 97% 78-39-7
5-Sulfosalicylic acid dihydrate, 98% 5965-83-3
Sulfur, 99.999%, ca.12mm Pieces 7704-34-9
Sulfur, Sublimed, 99.5% 7704-34-9
Sulfuric Acid, P.A. 7664-93-9
Sulfuric Acid, Reagent ACS 7664-93-9
Tannic Acid, 95% 1401-55-4
L-(+)-Tartaric Acid , 99+% 87-69-4
Sodium Sulfide Nonahydrate, P.A. 1313-84-4
Tert.- Amyl Alcohol (2-Methyl-2-Butanol), 99% 75-85-4
Diethoxymethane, 99% 462-95-3
Tetrachloroethylene, 99% 127-18-4

Free MSDS Search ( Providing 250,000+ Material Properties )
Chemcas.com| Ads link:todaystock.net