**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 931-88-4 |Cyclooctene | 95 | 213-245-5 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: 10
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Flammable.The toxicological properties of this material have not
been fully investigated.
Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause irritation of the digestive tract. The toxicological
properties of this substance have not been fully investigated.
Inhalation:
May cause respiratory tract irritation. The toxicological properties
of this substance have not been fully investigated. Vapors may cause
dizziness or suffocation.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Vapors may form an explosive mixture with air.
Vapors can travel to a source of ignition and flash back. During a
fire, irritating and highly toxic gases may be generated by thermal
decomposition or combustion. Use water spray to keep fire-exposed
containers cool. Containers may explode in the heat of a fire.
Flammable liquid and vapor. Vapors may be heavier than air. They
can spread along the ground and collect in low or confined areas.
Extinguishing Media:
For small fires, use dry chemical, carbon dioxide, water spray or
alcohol-resistant foam. For large fires, use water spray, fog, or
alcohol-resistant foam. Use water spray to cool fire-exposed
containers. Water may be ineffective. Do NOT use straight streams of
water.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Cover with an activated carbon adsorbent and place
into a closed container for disposal. Remove all sources of ignition.
Use a spark-proof tool. Provide ventilation. A vapor suppressing foam
may be used to reduce vapors.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Ground and bond containers when transferring material. Use
spark-proof tools and explosion proof equipment. Avoid prolonged or
repeated contact with skin. Avoid contact with eyes, skin, and
clothing. Empty containers retain product residue, (liquid and/or
vapor), and can be dangerous. Keep away from heat, sparks and flame.
Avoid ingestion and inhalation. Use with adequate ventilation. Do not
pressurize, cut, weld, braze, solder, drill, grind, or expose empty
containers to heat, sparks or open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
Flammables-area.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use explosion-proof ventilation equipment. Use adequate general or
local exhaust ventilation to keep airborne concentrations below the
permissible exposure limits.
Exposure Limits
CAS# 931-88-4:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: colorless - clear
Odor: None reported.
pH: Not available.
Vapor Pressure: 8 mbar @ 20 C
Viscosity: Not available.
Boiling Point: 145.0 - 146.0 deg C @ 760.00m
Freezing/Melting Point: -16 deg C
Autoignition Temperature: 280 deg C ( 536.00 deg F)
Flash Point: 25 deg C ( 77.00 deg F)
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water:
Specific Gravity/Density: .8460g/cm3
Molecular Formula: C8H14
Molecular Weight: 110.20
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, ignition sources, excess heat, strong
oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 931-88-4 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
Cyclooctene -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
Other
No information available.
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: FLAMMABLE LIQUID, N.O.S.*
Hazard Class: 3
UN Number: 1993
Packing Group: III
IMO
Shipping Name: FLAMMABLE LIQUID, N.O.S.
Hazard Class: 3.3
UN Number: 1993
Packing Group: III
RID/ADR
Shipping Name: FLAMMABLE LIQUID, N.O.S.
Hazard Class: 3
UN Number: 1993
Packing group: III
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
R 10 Flammable.
Safety Phrases:
S 9 Keep container in a well-ventilated place.
S 16 Keep away from sources of ignition - No
smoking.
S 33 Take precautionary measures against static
discharges.
WGK (Water Danger/Protection)
CAS# 931-88-4: 1
Canada
CAS# 931-88-4 is listed on Canada's NDSL List.
CAS# 931-88-4 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 931-88-4 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 2/05/1999 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Poly(Ethylene Oxide) Approximate m.w.300.000
| 25322-68-3 |
|
Glutaric Dialdehyde, 25 wt.% Solution in Water
| 111-30-8 |
|
Palladium, Powder, 99.99%
| 7440-05-3 |
|
Palladium, Sponge, 99.9%
| 7440-05-3 |
|
Rhodium(II) Acetate, Dimer, Dihydrate (ca43% Rh)
| 29998-99-0 |
|
Rhodiumacetate, Brown, Water Soluble, ca 40% Rh
| 5503-41-3 |
|
N,N-Dimethylacetoacetamide, 70 Wt% Aqueous solution
| 2044-64-6 |
|
Sinigrin, Monohydrate, from Horseradish
| 3952-98-5 |
|
Lithium acetate, p.a.
| 546-89-4 |
|
d-2-Octanol, 99%
| 6169-06-8 |
|
Terephthaldehyde monodiethylacetal, 98+% stabilized with 0.1%
| 121-44-8 |
|
Tyramine hydrochloride, 98%
| 60-19-5 |
|
Methyl Vinyl Ether/Maleic Anhydride, Medium Molecular Weight
| 9011-16-9 |
|
Pyridine-D5, 99 Atom % D
| 7291-22-7 |
|
Pyridine-D5, 99 Atom % D, Contains 1 v/v% TMS
| 7291-22-7 |
|
Pyridine-D5, 99 Atom % D, Packaged in 1.00 ml Ampules
| 7291-22-7 |
|
Pyridine-D5, 100.0 Atom% D, Packaged in 0. 5 ml Ampules
| 7291-22-7 |
|
Plasmocorinth B
| 1058-92-0 |
|
Triethylenetetramine tetrahydrochloride, 97%
| 4961-40-4 |
|
Cyclooctene, 95%
| 931-88-4 |
|
N,N-Dimethylindoaniline, ca.92% Dye Content
| 2150-58-5 |
|
2,5-Dihydroxyphenylacetic Acid, 99%
| 451-13-8 |
|
Benzenesulfonyl Chloride, 96%
| 98-09-9 |
|
Wright stain solution in methanol buffered
| 67-56-1 |
|
Phenylhydrazine, 95%
| 100-63-0 |
|
Wright's stain (cert), 97% (uv-vis)
| 67-56-1 |
|
8-Hydroxyjulolidine, 98%
| 41175-50-2 |
|
2-Methyl-2,4-Pentanediol, 99%
| 107-41-5 |
|
Orcinol, 98% (uv-vis)
| 504-15-4 |
|
5-Bromovanillin, 98%
| 2973-76-4 |
|
2-Phenylbenzimidazole, 97%
| 716-79-0 |
|
Phenylhydrazine, 97%
| 100-63-0 |
|
2-Methylcyclohexanol (Mixture of Cis and Trans), 99%
| 583-59-5 |
|
1,1,3,3-Tetramethylurea, 99%
| 632-22-4 |
|
O-Toluoyl Chloride, 99% (Titr.)
| 933-88-0 |
|
Ethylxanthic Acid Potassium Salt
| 140-89-6 |
|
7-Diethylamino-3-Thenoylcoumarin
| 77820-11-2 |
|
Lithium, Wire, 99+%, Diameter 3.2mm
| 7439-93-2 |
|
Lithium (Granules, Coated with Mineral Oil)
| 7439-93-2 |
|
Thymine, 99%
| 65-71-4 |
|
Methyl stearate, 98%
| 112-61-8 |
|
Octacosane, 99+% (GC)
| 630-02-4 |
|
2,5-Dimethoxyaniline, 99+%
| 102-56-7 |
|
(R)-(-)-2-Amino-1-butanol
| 5856-63-3 |
|
Acetic-D3 Acid-D, 99.5 Atom % D
| 1186-52-3 |
|
Acetic-D3 Acid-D, 99.9 Atom % D (1pk=10x0.5ml)
| 1186-52-3 |
|
2-Mercaptobenzothiazole, 95% Contains 1-2% Oil
| 149-30-4 |
|
2-Mercaptobenzothiazole (Pract), 98% (Titr.)
| 149-30-4 |
|
4-Bromo-m-xylene, tech., 85%
| 583-70-0 |
|
3-(Dibutylamino)propionitrile, 97%
| 25726-99-2 |
|
|