=====================  Product Identification  =====================

MSDS NAME:MAXIMUM-PLUS
NIIN:00N083582
MSDS Number: CGQYS
=== Responsible Party ===
Company:ZYP COATINGS INC
Address:120 VALLEY COURT
Box:2590
City:OAK RIDGE
State:TN
ZIP:37831
Country:US
Info Phone Num:423-482-5717
Emergency Phone Num:423-482-5717
CAGE:0PGY8
=== Contractor Identification ===
Company:ZYP COATINGS INC
Box:City:OAK RIDGE
State:TN
ZIP:37831
Country:US
Phone:615-482-5717
CAGE:0PGY8

=============  Composition/Information on Ingredients  =============

Name:BORIC ACID (ACTIVE INGREDIENT)
CAS:10043-35-3
RTECS #:ED4550000
Fraction by Wt: 50%
OSHA PEL:10 MG/M3
ACGIH TLV:5 MG/M3

Name:ACRYLIC LATEX (58% SOLIDS IN WATER) (BINDER)
Fraction by Wt: 50%
OSHA PEL:N/K 
ACGIH TLV:N/K 

Name:VOLATILE ORGANIC COMPOUND: 0 G/L.
RTECS #:9999999VO
OSHA PEL:N/K 
ACGIH TLV:N/K 

=====================  Hazards Identification  =====================

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:NO
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:POTENTIAL HEALTH EFFECTS: TARGET
    ORGANS: EYES, SKIN AND RESPIRATORY SYSTEM. EYE: IRRITATION. SKIN
    CONT: POSSIBLE MILD IRRITATION/REDDENING. SKIN ABSORPTION: NOT
    APPLICABLE. INGESTION: IRRITATION TO GI  TRACT. INHALATION:
    IRRITATION TO UPPERRESPIRATORY SYSTEM. ACUTE: PROLONGED CONTACT TO
    SKIN MAY CAUSE (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:HEALTH HAZARDS: SLIGHT REDDENING OR IRRITATION.
    CONTACT WITH EYES MAY CAUSE IRRITATION. INGESTION MAY CAUSE NAUSEA,
    VOMITING AND DIARRHEA. INHALATION OF PAINT MIST IF SPRAYED MAY BE
    IRRITATING AND CAU SE SNEEZING AND COUGHING. CHRONIC: NO EVIDENCE
    OF ADVERSE EFFECTS FROM AVAILABLE INFORMATION.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

=======================  First Aid Measures  =======================

Eyes: FLUSH EYES, INCLUDING UNDER EYELIDS, WITH LARGE AMOUNTS
    OF WATER FOR AT LEAST 15 MINUTES. IF IRRITATION PERSISTS, SEEK
    MEDICAL ATTENTION. SKIN: WASH THOROUGHLY WITH MILD SOAP AND WATER.
    INGESTIO N: GIVE COPIOUS AMOUNTS OF WATER OR PREFERABLY MILK AND
    SEEK MEDICAL ATTENTION. INHALATION: REMOVE TO FRESH AIR. SEEK
    MEDICAL ATTENTION IF SYMPTOMS PERSIST.

=====================  Fire Fighting Measures  =====================

Extinguishing Media:NOT APPLICABLE. USE CARBON DIOXIDE OR DRY CHMICAL
    MEDIA IF BURNING OCCURS.
Fire Fighting Procedures:NOT APPLICABLE. USE NIOSH APPROVED SCBA AND
    FULL PROTECTIVE EQUIPMENT . AFTER WATER EVAPORATES, REMAINING
    MATERIAL MAY BURN.
Unusual Fire/Explosion Hazard:PAINT IS NON-FLAMMABLE.

==================  Accidental Release Measures  ==================

Spill Release Procedures:CONTAIN THE SPILL. CLEAN-UP PERSONNEL SHOULD
    WEAR ANSI APPROVED RUBBER GLOVES AND GOGGLES TO PREVENT IRRITATION
    FROM CONTACT. DISPOSE ACCORDING TO LOCAL, STATE AND FEDERAL
    REGULATIONS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE IN ORIGINAL CONTAINER. AVOID
    FREEZING. NOTE EXPOSURE CONTROLS AND PERSONAL PROTECTION BEFORE
    USING.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:FOR SPRAY APPLICATION USE NIOSH APPROVED
    RESPIRATOR.
Ventilation:PROVIDE ADEQUATE GENERAL VENTILATION AND LOCAL VENTILATION
    TO CONTROL MIST/DUSTS BELOW THE TLV.
Protective Gloves:RUBBER GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
    NIOSH APPROVED LONG SLEEVED PROTECTIVE CLOTHING.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

==================  Physical/Chemical Properties  ==================

Boiling Pt:B.P. Text:212F,100C
Melt/Freeze Pt:M.P/F.P Text:30.0F,-1.1C
Vapor Pres:10-20
Vapor Density:< AIR
Spec Gravity:1.05
Evaporation Rate & Reference:LESS THAN THAT OF WATER
Solubility in Water:MISCIBLE
Appearance and Odor:LIGHT GREEN PAINT, MILD ACRYLIC ODOR.
Percent Volatiles by Volume:21

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
ACETIC ANHYDRIDE, ELEMENTAL POTASSIUM. AS GOOD PRACTICE, DO NOT MIX
    WITH ANY OTHER MATERIALS.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:BURNING WOULD PRODUCE NORMALLY
    EXPECTED OXIDES OF CARBON.

====================  Disposal Considerations  ====================

Waste Disposal Methods:CONSULT LOCAL, ST & FED REGS FOR COMPLIANCE.
    NON-CONTAM PAINT MAY BE RETURNED TO MFR FOR PROPER DISP. DRIED
    PAINT GENERALLY DOES NOT EXHIBIT ANY CHARACTERISTICS OF HAZ WASTE.
    NOT REGULATED UNDER SECTI ON 313 OF SARA TITLE III OR RCRA (40 CFR
    261.33.)

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***