===================== Product Identification =====================
MSDS NAME:NYSYN ELASTOMER, 305V
Status Code:A
MSDS Number: CKZKS
=== Responsible Party ===
Company:COPOLYMER RUBBER & CHEMICAL CORPORATION
Address:5955 SCENIC HIGHWAY
Box:2591
City:BATON ROUGE
State:LA
ZIP:70805
Country:US
Info Phone Num:504-355-5655
Emergency Phone Num:504-355-5655
Resp. Party Other MSDS Num.:CR 2285 (R 9/90)
CAGE:TO546
=== Contractor Identification ===
Company:COPOLYMER RUBBER & CHEMICAL CORPORATION
Address:5955 SCENIC HIGHWAY
Box:2591
City:BATON ROUGE
State:LA
ZIP:70805
Country:US
Phone:504-355-5655
CAGE:TO546
============= Composition/Information on Ingredients =============
Name:ACRYLONITRILE-BUTADIENE RUBBER
CAS:9003-18-3
= Wt:72.
Name:DISPROPORTIONATED TALL OIL (MFR INVALID CAS # 68152-82-1)
= Wt:1.6
Name:VINYL CHLORIDE POLYMER
CAS:9002-86-2
RTECS #:KV0350000
= Wt:32.
===================== Hazards Identification =====================
LD50 LC50 Mixture:LD50: NOT ESTABLISHED; LC50: NOT APPLIC.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:SPECIFIC HAZARDS: NO ACUTE HAZARDS OR
EFFECTS ARE KNOWN. ROUTES OF EXPOSURE: EYE CONTACT: NOT A PROBABLE
SOURCE OF EXPOSURE. PARTICULATES MAY SCRATCH EYE SURFACE OR CAUSE
IRRITATION. SKIN CONTACT: A SINGLE PROLONGED EXPOSURE OR REPEATED
PROLONGED EXPOSURES ARE NOT LIKELY TO RESULT IN MATERIAL BEING
ABSORBED THROUGH THE SKIN IN A HARMFUL AMOUNT. EXPOSURE TO HOT
MATERIAL MAY CAUSE THERMAL BURNS. IN GESTION: NOT A PROBABLE ROUTE
OF EXPOSURE. INHALATION: NOT A PROBABLE ROUTE OF EXPOSURE UNDER
CONDITIONS OF NORMAL USE. HOT FUMES OR VAPORS WHICH MAY FORM DURING
PROCESSING CAN CAUSE IRRITATION TO THE RESPIRATORY TRACT.
Explanation of Carcinogenicity:CARCINOGENICITY: NONE REPORTED.
Effects of Overexposure:N/P.
Medical Cond Aggravated by Exposure:SOME INDIVIDUALS WITH SPECIFIC
SENSITIVITIES MAY EXHIBIT EYE, NOSE, THROAT OR THERMAL IRRITATION
WITH PROLONGED EXPOSURE TO PROCESSING FUMES OR VAPORS.
======================= First Aid Measures =======================
First Aid:SKIN CONTACT: WASH WITH SOAP AND WATER. IF THERMAL
IRRITATION, FLUSH AFFECTED AREA WITH COLD WATER TO DISSIPATE HEAT,
THEN COVER WITH CLEAN COTTON SHEETING OR GAUZE AND GET PROMPT
MEDICAL ATTENTION. E YE CONTACT: REMOVE AS FOR ANY FOREIGN OBJECT.
FLUSH WITH CLEAN WATER FOR 15 MINUTES. OBTAIN MEDICAL ATTENTION IF
IRRITATION PERSISTS. INHALATION: IF FUMES OR VAPORS ARE INHALED,
MOVE TO FRESH AIR, AID BREATHING IF NECESSARY. OBTAIN MEDICAL
ATTENTION IF IRRITATION PERSISTS. INGESTION: UNLIKELY TO OCCUR.
===================== Fire Fighting Measures =====================
Flash Point:=350.C, 662.F
IGNITION TEMP
Autoignition Temp:>373.C, 703.4F
Lower Limits:NA
Upper Limits:NA
Extinguishing Media:ALL FIRE EXTINGUISHING MEDIA PERMITTED - WATER
RECOMMENDED; CARBON DIOXIDE NOT RECOMMENDED.
Fire Fighting Procedures:DURING EMERGENCY CONDITIONS EXPOSURE TO
THERMAL DECOMPOSITION PRODUCTS MAY CAUSE A HEALTH HAZARD. USE OF
NIOSH APPROVED SELF CONTAINED BREATHING APPARATUS AND FULL
PROTECTIVE EQUIPMENT IS RECOM MENDED.
Unusual Fire/Explosion Hazard:HAZARDOUS COMBUSTION PRODUCTS: CARBON
MONOXIDE, CARBON DIOXIDE, PRODUCTS FROM INCOMPLETE COMBUSTION,
NITROGEN OXIDES, HYDROGEN CHLORIDE, VINYL CHLORIDE, ACRID FUMES AND
TOXIC GASES. COMBUSTIBLE: YES , WITH PRESENCE OF AN IGNITION
SOURCE. SENSITIVITY TO IMPACT/SHOCK: NA. SENSITIVITY TO STATIC
DISCHARGE: NA.
================== Accidental Release Measures ==================
Spill Release Procedures:REPACKAGE UNCONTAMINATED RUBBER. REUSE OR
DISPOSE OF AS NOTED (IN WASTE DISPOSAL SECTION) IF CONTAMINATED.
====================== Handling and Storage ======================
Handling and Storage Precautions:HANDLING PROCEDURES AND EQUIPMENT:
AVOID SKIN AND EYE CONTACT. AVOID INHALATION OF FUMES OR VAPORS
FROM HOT RUBBERS, COMPOUNDS AND VULCANIZATES. STORAGE: STORE AT
AMBIENT TEMPERATURE, KEEP AWAY FROM EXCESSIVE HEAT AND FLAME.
Other Precautions:LABELS: OSHA: NOT REQUIRED. WHMIS: NOT REQUIRED.
============= Exposure Controls/Personal Protection =============
Respiratory Protection:NOT NORMALLY REQUIRED AT AMBIENT TEMPERATURES.
IF PROCESSING IN AN AREA WHERE VENTILATION IS INADEQUATE, WEAR A
NIOSH APPROVED ORGANIC VAPOR RESPIRATOR WITH MECHANICAL FILTRATION.
EXPOSURE GUIDELI NES: NOT APPLICABLE.
Ventilation:LOCAL EXHAUST VENTILATION IS RECOMMENDED DURING ALL HOT
PROCESSING OPERATIONS.
Protective Gloves:WHERE CONTACT MAY OCCUR WITH HOT MATERIAL, WEAR
THERMAL RESISTANT GLOVES.
Eye Protection:WEAR SAFETY GLASSES (ANSI APPROVED - ).
Other Protective Equipment:EYEWASH AND DELUGE SHOWER MEETING ANSI
DESIGN CRITERIA . WEAR CLOTHING APPROPRIATE TO PREVENT SKIN
CONTACT. WHERE CONTACT MAY OCCUR WITH HOT MATERIAL, WEAR ARM
PROTECTION AND A FACE SHIELD.
Work Hygienic Practices:AVOID SKIN AND EYE CONTACT. PRACTICE GOOD
PERSONAL HYGIENE. AVOID INHALATION OF FUMES OR VAPORS FROM HOT
RUBBERS, COMPOUNDS, AND VULCANIZATES.
Supplemental Safety and Health
CHEMICAL NAME: ACRYLONITRILE-BUTADIENE RUBBER BLEND. CAS NUMBER: NOT
APPLICABLE / MIXTURE (SEE (INGREDIENTS) SECTION). CAS NAME (RUBBER
ONLY): 2-PROPENENITRILE POLYMER WITH 1,3-BUTADIENE. PRODUCT U SE:
PRODUCT USE: OZONE AND ABRASION RESISTANT NBR BLEND FOR RUBBER
ARTICLES AND RUBBER MODIFIED ARTICLES.
================== Physical/Chemical Properties ==================
Spec Gravity:0.96 - 1.01
Solubility in Water:INSOLUBLE @ 20 C
Appearance and Odor:SOLID BALES, AMBER COLOR, SLIGHT ODOR.
Percent Volatiles by Volume:0.50 MAX, WT
================= Stability and Reactivity Data =================
Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:IGNITION SOURCE; PRODUCT IS COMBUSTIBLE.
PRODUCT IS STABLE AT AMBIENT TEMPERATURE AND PRESSURE.
Hazardous Decomposition Products:COMBUSTION PRODUCTS WILL BE CARBON
MONOXIDE, CARBON DIOXIDE, OXIDES OF NITROGEN, HYDROGEN CHLORIDE,
VINYL CHLORIDE AND PRODUCTS FROM INCOMPLETE COMBUSTION.
=================== Toxicological Information ===================
Toxicological Information:REPRODUCTIVE EFFECTS: NONE REPORTED.
TERATOGENICITY: NONE REPORTED. MUTAGENICITY: NONE REPORTED.
==================== Disposal Considerations ====================
Waste Disposal Methods:REUSE IF POSSIBLE. DISPOSE IN ACCORDANCE WITH
LOCAL, STATE AND FEDERAL REGULATIONS AND APPLICABLE ENVIRONMENTAL
REGULATIONS. MATERIAL AS SUPPLIED IS NOT CHARACTERIZED AS HAZARDOUS
UNDER RCRA.
=================== MSDS Transport Information ===================
Transport Information:DOT: UNITED STATES: DESIGNATION AND LABELING NOT
APPLICABLE AS PRODUCT IS NOT DEFINED OR DESIGNATED AS A HAZARDOUS
MATL BY U.S. DEPT OF TRANSPORTATION UNDER TITLE 49 OF CFR. CANADA:
NOT REGULATED UND ER THE CANADIAN TRANSPORTATION OF DANGEROUS GOODS
REGULATIONS.
===================== Regulatory Information =====================
SARA Title III Information:SECTION 302/304: EXTREMELY HAZARDOUS
SUBSTANCES: NONE. SECTION 311: HAZARDOUS SUBSTANCES: NOT
APPLICABLE. SECTION 313: THIS PRODUCT IS NOT SUBJECT TO REPORTING
REQUIREMENTS (SEE 40 CFR372).
Federal Regulatory Information:OSHA: THIS PRODUCT IS NOT HAZARDOUS
UNDER HAZARD COMMUNICATION STANDARD 29 CFR PART 1910.1200. TSCA:
COMPONENTS OF THIS PRODUCT ARE LISTED UNDER TSCA CHEMICAL SUBSTANCE
INVENTORY. WHMIS: THIS PRODUCT IS NOT CONSIDERED HAZARDOUS UNDER
CANADA'S WORKPLACE HAZARDOUS MATERIAL INFORMATION SYSTEM. CEPA:
COMPONENTS OF THIS PRODUCT ARE INCLUDED IN CANADA'S DSL. EEC: THIS
PRODUCT NOT CONSIDERED HAZARDOUS BY THE EUROPEAN ECONOMIC
COMMUNITY.
======================= Other Information =======================
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.
*** END OF RECORD *** |
|