3M MATERIAL SAFETY DATA SHEET SCOTCHGARD (TM) SPOT REMOVER & UPHOLSTERY CLEANER 06/06/2003
Material Safety Data Sheet
Copyright, 2003, 3M Company. All rights reserved. Copying and/or downloading of this information for the purpose of properly
utilizing 3M products is allowed provided that: (1) the information is copied in full with no changes unless prior written agreement is
obtained from 3M, and (2) neither the copy nor the original is resold or otherwise distributed with the intention of earning a profit
thereon.
SECTION 1: PRODUCT AND COMPANY IDENTIFICATION
PRODUCT NAME: SCOTCHGARD (TM) SPOT REMOVER & UPHOLSTERY CLEANER
MANUFACTURER: 3M
DIVISION: Commercial Care Division
ADDRESS: 3M Center
St. Paul, MN 55144-1000
EMERGENCY PHONE: 1-800-364-3577 or (651) 737-6501 (24 hours)
Issue Date: 06/06/2003
Supercedes Date: 03/17/2000
Document Group: 10-2821-6
Product Use:
Specific Use: CARPET SPOT REMOVER AND UPHOLSTERY CLEANER
SECTION 2: INGREDIENTS
Ingredient C.A.S. No. % by Wt
WATER 7732-18-5 60 - 100
ISOBUTANE 75-28-5 3- 7
2-BUTOXYETHANOL 111-76-2 1- 5
SODIUM OLEYLMETHYLTAURIDE 137-20-2 0.1 - 1.5
STYRENE MALEIC ANHYDRIDE RESIN 26762-29-8 0.1 - 1.5
SECTION 3: HAZARDS IDENTIFICATION
3.1 EMERGENCY OVERVIEW
Specific Physical Form: Aerosol
Odor, Color, Grade: Clear, mild odor.
General Physical Form: Gas Aerosol
Immediate health, physical, and environmental hazards: Aerosol container contains flammable gas under pressure. Closed
containers exposed to heat from fire may build pressure and explode. Vapors may travel long distances along the ground or floor to an
ignition source and flash back. May cause target organ effects.
3.2 POTENTIAL HEALTH EFFECTS
Eye Contact:
Mild Eye Irritation: Signs/symptoms may include redness, pain, and tearing.
Skin Contact:
Mild Skin Irritation: Signs/symptoms may include localized redness, swelling, and itching.
Page 1 of 6
3M MATERIAL SAFETY DATA SHEET SCOTCHGARD (TM) SPOT REMOVER & UPHOLSTERY CLEANER 06/06/2003
May be absorbed through skin and cause target organ effects.
Inhalation:
Single exposure, above recommended guidelines, may cause:
Upper Respiratory Tract Irritation: Signs/symptoms may include cough, sneezing, nasal discharge, headache, hoarseness,
and nose and throat pain.
May be absorbed following inhalation and cause target organ effects.
Ingestion:
Gastrointestinal Irritation: Signs/symptoms may include abdominal pain, nausea, diarrhea and vomiting.
Target Organ Effects:
Central Nervous System (CNS) Depression: Signs/symptoms may include headache, dizziness, drowsiness, incoordination, nausea,
slowed reaction time, slurred speech, giddiness, and unconsciousness.
SECTION 4: FIRST AID MEASURES
4.1 FIRST AID PROCEDURES
The following first aid recommendations are based on an assumption that appropriate personal and industrial hygiene practices are
followed.
Eye Contact: Flush eyes with large amounts of water. Get medical attention.
Skin Contact: Immediately flush skin with large amounts of water. If signs/symptoms develop, get medical attention.
Inhalation: If signs/symptoms develop, remove person to fresh air. If signs/symptoms persist, get medical attention.
If Swallowed: Do not induce vomiting unless instructed to do so by medical personnel. Give victim two glasses of water. Never give
anything by mouth to an unconscious person. Get medical attention.
SECTION 5: FIRE FIGHTING MEASURES
5.1 FLAMMABLE PROPERTIES
No Data Available
Autoignition temperature
Nil [Details: NON-FLAMMABLE ACCORDING TO
Flash Point
FLAME PROJECTION TEST]
No Data Available
Flammable Limits - LEL
No Data Available
Flammable Limits - UEL
Class IA Flammable Liquid
OSHA Flammability Classification:
5.2 EXTINGUISHING MEDIA
Use fire extinguishers with class B extinguishing agents (e.g., dry chemical, carbon dioxide).
5.3 PROTECTION OF FIRE FIGHTERS
Special Fire Fighting Procedures: Water may not effectively extinguish fire; however, it should be used to keep fire-exposed
containers and surfaces cool and prevent explosive rupture. Wear full protective clothing, including helmet, self-contained, positive
pressure or pressure demand breathing apparatus, bunker coat and pants, bands around arms, waist and legs, face mask, and protective
covering for exposed areas of the head.
Unusual Fire and Explosion Hazards: Aerosol container contains flammable material under pressure. Closed containers exposed
to heat from fire may build pressure and explode. Vapors may travel long distances along the ground or floor to an ignition source
and flash back.
Note: See STABILITY AND REACTIVITY (SECTION 10) for hazardous combustion and thermal decomposition
Page 2 of 6
3M MATERIAL SAFETY DATA SHEET SCOTCHGARD (TM) SPOT REMOVER & UPHOLSTERY CLEANER 06/06/2003
information.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Accidental Release Measures: Observe precautions from other sections. Call 3M- HELPS line (1-800-364-3577) for more
information on handling and managing the spill. Ventilate the area with fresh air. If possible, seal leaking container. Place leaking
containers in a well-ventilated area, preferably an operating exhaust hood, or if necessary outdoors on an impermeable surface until
appropriate packaging for the leaking container or its contents is available. Clean up residue with water.
In the event of a release of this material, the user should determine if the release qualifies as reportable according to
local, state, and federal regulations.
SECTION 7: HANDLING AND STORAGE
7.1 HANDLING
Aerosol container contains flammable gas under pressure. Do not spray near flames or sources of ignition. Keep away from heat,
sparks, open flame, pilot lights and other sources of ignition. Avoid eye contact with vapors, mists, or spray. Avoid skin contact.
Avoid breathing of vapors, mists or spray. Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with
soap and water. Do not pierce or burn container, even after use. Avoid contact with oxidizing agents. Keep out of the reach of
children.
7.2 STORAGE
Store away from heat. Store out of direct sunlight. Store away from acids. Store away from oxidizing agents. Do not store
containers on their sides. Store below 120 F.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 ENGINEERING CONTROLS
Do not use in a confined area or areas with little or no air movement. Use general dilution ventilation and/or local exhaust ventilation
to control airborne exposures to below Occupational Exposure Limits and/or control mist, vapor, or spray. If ventilation is not
adequate, use respiratory protection equipment.
8.2 PERSONAL PROTECTIVE EQUIPMENT (PPE)
8.2.1 Eye/Face Protection
Avoid eye contact with vapors, mists, or spray. The following eye protection(s) are recommended: Safety Glasses with side shields.
8.2.2 Skin Protection
Avoid prolonged or repeated skin contact.
8.2.3 Respiratory Protection
Avoid breathing of vapors, mists or spray.
8.2.4 Prevention of Swallowing
Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with soap and water.
8.3 EXPOSURE GUIDELINES
Ingredient Authority Type Limit Additional Information
2-BUTOXYETHANOL ACGIH TWA 20 ppm Table A3
2-BUTOXYETHANOL OSHA TWA, 25 ppm Skin Notation*
Vacated
2-BUTOXYETHANOL OSHA TWA 50 ppm Skin Notation*; Table Z-1
* Substance(s) refer to the potential contribution to the overall exposure by the cutaneous route including mucous
membrane and eye, either by airborne or, more particularly, by direct contact with the substance. Vehicles can alter
Page 3 of 6
3M MATERIAL SAFETY DATA SHEET SCOTCHGARD (TM) SPOT REMOVER & UPHOLSTERY CLEANER 06/06/2003
skin absorption.
VAC Vacated PEL:Vacated Permissible Exposure Limits [PEL] are enforced as the OSHA PEL in some states. Check with your local
regulatory agency.
SOURCE OF EXPOSURE LIMIT DATA:
ACGIH: American Conference of Governmental Industrial Hygienists
CMRG: Chemical Manufacturer Recommended Guideline
OSHA: Occupational Safety and Health Administration
AIHA: American Industrial Hygiene Association Workplace Environmental Exposure Level (WEEL)
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Aerosol
Specific Physical Form:
Clear, mild odor.
Odor, Color, Grade:
Gas Aerosol
General Physical Form:
No Data Available
Autoignition temperature
Nil [Details: NON-FLAMMABLE ACCORDING TO FLAME
Flash Point
PROJECTION TEST]
No Data Available
Flammable Limits - LEL
No Data Available
Flammable Limits - UEL
Approximately 212 潞F
Boiling point
Approximately 1 g/ml
Density
No Data Available
Vapor Density
No Data Available
Vapor Pressure
1 [Ref Std: WATER=1]
Specific Gravity
8.5 - 9.5
pH
Not Applicable
Melting point
Complete
Solubility in Water
No Data Available
Evaporation rate
4 - 12 % [Test Method: calculated per CARB title 2]
Volatile Organic Compounds
60 - 100 %
Percent volatile
100 - 1050 g/l [Test Method: calculated per CARB title 2]
VOC Less H2O & Exempt Solvents
No Data Available
Viscosity
SECTION 10: STABILITY AND REACTIVITY
Stability: Stable.
Materials and Conditions to Avoid: Heat; Sparks and/or flames; Strong oxidizing agents; Strong acids
Hazardous Polymerization: Hazardous polymerization will not occur.
Hazardous Decomposition or By-Products
Substance Condition
Carbon monoxide During Combustion
Carbon dioxide During Combustion
SECTION 11: TOXICOLOGICAL INFORMATION
Please contact the address listed on the first page of the MSDS for Toxicological Information on this material and/or its
components.
SECTION 12: ECOLOGICAL INFORMATION
Page 4 of 6
3M MATERIAL SAFETY DATA SHEET SCOTCHGARD (TM) SPOT REMOVER & UPHOLSTERY CLEANER 06/06/2003
ECOTOXICOLOGICAL INFORMATION
Not determined.
CHEMICAL FATE INFORMATION
Not determined.
SECTION 13: DISPOSAL CONSIDERATIONS
Waste Disposal Method: Incinerate in an industrial or commercial facility. As a disposal alternative, dispose of waste product in a
facility permitted to accept chemical waste. Facility must be capable of handling aerosol cans. Dispose of empty product containers
in a sanitary landfill.
EPA Hazardous Waste Number (RCRA): Not regulated
Since regulations vary, consult applicable regulations or authorities before disposal.
SECTION 14:TRANSPORT INFORMATION
ID Number UPC ID Number UPC
61-5000-0319-1 00-48011-08114-4 61-5000-6133-0 00-48011-14003-7
70-0711-6295-5 00-48011-14003-7
Please contact the emergency numbers listed on the first page of the MSDS for Transportation Information for this
material.
SECTION 15: REGULATORY INFORMATION
US FEDERAL REGULATIONS
311/312 Hazard Categories:
Fire Hazard - Yes Pressure Hazard - Yes Reactivity Hazard - No Immediate Hazard - Yes Delayed Hazard - No
Section 313 Toxic Chemicals subject to the reporting requirements of that section and 40 CFR part 372 (EPCRA):
Ingredient C.A.S. No % by Wt
2-BUTOXYETHANOL (GLYCOL ETHERS) 111-76-2 1- 5
CHEMICAL INVENTORIES
The components of this product are in compliance with the chemical notification requirements of TSCA.
This MSDS has been prepared to meet the U.S. OSHA Hazard Communication Standard, 29 CFR 1910.1200.
SECTION 16: OTHER INFORMATION
NFPA Hazard Classification
Health: 1 Flammability: 4 Reactivity: 0 Special Hazards: None
Aerosol Storage Code: 1
National Fire Protection Association (NFPA) hazard ratings are designed for use by emergency response personnel to address the hazards that are
presented by short-term, acute exposure to a material under conditions of fire, spill, or similar emergencies. Hazard ratings are primarily based on the
inherent physical and toxic properties of the material but also include the toxic properties of combustion or decomposition products that are known to
be generated in significant quantities.
HMIS Hazard Classification
Health: 1 Flammability: 4 Reactivity: 0 Protection: X - See PPE section.
Page 5 of 6
3M MATERIAL SAFETY DATA SHEET SCOTCHGARD (TM) SPOT REMOVER & UPHOLSTERY CLEANER 06/06/2003
Hazardous Material Identification System (HMIS(r)) hazard ratings are designed to inform employees of chemical hazards in the workplace. These
ratings are based on the inherent properties of the material under expected conditions of normal use and are not intended for use in emergency
situations. HMIS(r) ratings are to be used with a fully implemented HMIS(r) program. HMIS(r) is a registered mark of the National Paint and
Coatings Association (NPCA).
DISCLAIMER: The information in this Material Safety Data Sheet (MSDS) is believed to be correct as of the date issued. 3M
MAKES NO WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR COURSE OF PERFORMANCE OR USAGE OF
TRADE. User is responsible for determining whether the 3M product is fit for a particular purpose and suitable for user's method of
use or application. Given the variety of factors that can affect the use and application of a 3M product, some of which are uniquely
within the user's knowledge and control, it is essential that the user evaluate the 3M product to determine whether it is fit for a
particular purpose and suitable for user's method of use or application.
3M provides information in electronic form as a service to its customers. Due to the remote possibility that electronic transfer may
have resulted in errors, omissions or alterations in this information, 3M makes no representations as to its completeness or accuracy.
In addition, information obtained from a database may not be as current as the information in the MSDS available directly from 3M.
3M MSDSs are available at www.3M.com
Page 6 of 6
|