0332KA

                                 MATERIAL SAFETY DATA SHEET              Revised: 20

August 2001



                           Sara Lee Household and Body Care USA

                         707 Eagleview Boulevard, Exton, PA 19341



              Emergency Telephone Number: Chem-Tel, Inc. 1-800-255-3924

                       Outside the United States call 813-248-0585



                            SECTION I - PRODUCT IDENTIFICATION



   PRODUCT NAME: Endust for Electronics Duster       SKU# 257-000



   CHEMICAL FORMULA/FAMILY: Aerosol dust remover





                                   SECTION II:    INGREDIENTS



   INGREDIENT SUMMARY                      CAS NUMBER      COMPOSITION      OSHA LIMITS



   1,1,-difluoroethane                           75-37-6    95-100%            N.E.









N.E.= Not Established





                            SECTION III - PHYSICAL DATA



   BOILING POINT: -25 degrees C (-13 F)      SPECIFIC GRAVITY: 0.9 at 25 degrees C

   VAPOR PRESSURE: 87 psia at 25 deg.C       VAPOR DENSITY (AIR=1): 2.4

   %VOLATILE: 100%                           EVAPORATION RATE: N.A.



   WATER SOLUBILITY: 0.28% w/w @ 25 deg.C ODOR: Slight ethereal



   APPEARANCE: Colorless gas at normal temperature and pressure.

Endust for Electronics Duster                                 Page Number: 2

257000



                    SECTION IV - FIRE AND EXPLOSION HAZARDS



Flash Point: <-50øC (-58øF)



Flammable Limits in Air (% by volume):

LEL: 3.9%                              UEL: 16.9



Extinguishing Media:

Water spray, water fog, dry chemical, carbon dioxide, or alcohol foam.



Hazardous Decomposition Products:

This material can be decomposed by high temperatures (open flames and

glowing metal surfaces) forming hydrofluoric acid and possibly carbonyl

fluoride.



Special Fire Fighting Procedures:

These procedures are for fires that occur when large quantities of product

are involved. When single containers or small amounts of product are

invovled, the fire fighting procedures will depend on the total situation

and other materials involved in the fire.

Keep containers cool with water spray. If gas exiting containers ignites,

self-contained breathing apparatus is required.



Unusual Fire and Explosion Hazards:

Water may be ineffective to extinguish fire. Aerosol cans may explode from

internal pressure build-up when exposed to extreme heat. Water may be used

to cool containers and prevent explosion.





                         SECTION V - HEALTH HAZARD DATA



EFFECTS OF OVEREXPOSURE:

INHALATION: Inhalation of high concentrations of vapor is harmful and may

cause heart irregularities, unconsciousnes, or death. Overexposure by

inhalation may include nonspecific discomfort, such as nausea, headache, or

weakness; or temporary nervous system depression with anesthetic effects

such as dizziness, headache, confusion, incoordination, and loss of

consciousness. Higher exposures (>20%) may cause temporary lung irritation

effects with cough, discomfort, difficulty breathing, or shortness of

breath; high exposure may also cause temporary alteration of the heart's

electrical activity with irregular pulse, palpitations, or inadequate

circulation, or abnormal kidney function as detected by laboratory tests.

Gross exposure may be fatal. Intentional misuse or deliberate inhalation

may cause death without warning. Vapor reduces oxygen available for

breathing and is heavier than air.

Endust for Electronics Duster                                  Page Number:3

257000





   Individuals with preexisting diseases of the central nervous or

cardiovascular system may have increased susceptibility to the toxicity of

excessive exposure.



Note to physicians: Because of possible disturbances of cardiac rhythm,

catecholamine drugs, such as epinephrine, should be used with special

caution only in situations of emergency life support.



SKIN CONTACT:   Liquid contact can cause frostbite.



INGESTION:   Ingestion is not considered a potential route of exposure.



EMERGENCY FIRST AID PROCEDURES:



Inhalation:

If high concentrations are inhaled, immediately remove to fresh air. Keep

person calm. If not breathing, give artifical respiration. If breathing is

difficult, give oxygen. Call a physician.



Eye or Skin Contact:

EYE: In case of contact, immediately flush eyes with plenty of water for at

least 15 minutes. Call a physician.



SKIN: In case of contact, immediately flush skin with plenty of water for

at least 15 minutes. Treat for frostbite, if necessary, by genetly warming

affected area.



Ingestion: Ingestion is not considered a potential route of exposure.





                            SECTION VI - REACTIVITY DATA



Hazardous Polymerization:    Will not occur.



Stability:   This product is stable under normal household use conditions.



Incompatibility: Incompatible with alkali or alkaline earth metals:

powdered aluminum,

zinc, berylium, and similar powdered metals.





                      SECTION VII - SPILL OR LEAK PROCEDURE



Steps to be Taken in Case Material is Released or Spilled:

Note: Review fire fighting measures and handling procedures before

proceeding with cleanup. Use appropriate personal protective equipment

during cleanup.



If a spill can cause a concentration in excess of 1,000 ppm, remove ignition

sources and prevent further leakage. Evacuate area. Ventilate area,

expecially low places where heavy vapors might collect. Wear self-contained

breathing apparatus.









Endust for Electronics Duster                                   Page Number:4

257000





If this product is spilled and not recovered, or is recovered as a waste for

treatment or disposal, the CERCLA reportable quantity is 100 lbs. (The

waste is ignitable.)



Waste Disposal Method:

Incinerate or remove to a permitted waste facility.   Comply with federal,

state, and local regulations.



The material may be a RCRA hazardous waste upon disposal due to the

ignitability characteristic.



RCRA Hazardous Waste ID Number: D001



                   SECTION VIII - PROTECTIVE EQUIPMENT TO USE



Respiratory Protection:

None required during normal household use.

If workplace exposure limits are exceeded, a suitable NIOSH or OSHA

respirator is recommended; self-contained breathing apparatus is required if

large releases occur during industrial use or storage.



Ventilation:

Normal ventilation for standard manufacturing procedures is generally

adequate. Local exhaust should be used when large amounts are released.

Mechanical exhaust should be used in low or enclosed places.



Protective Gloves:

No protection required for normal household use when spray is not directed

at skin surfaces.

Impervious gloves should be worn when handling the liquid or if direct spray

is expected to contact the skin.



Eye Protection:

Wear safety glasses or goggles when possibility of direct eye contact

exists.



Other Protective Equipment: None.





                        SECTION IX - SPECIAL PRECAUTIONS



Precautions to be Taken in Handling and Storage:

This product is classified as a Level 1 aerosol in accordance with the

National Fire Protection Association Manufacturing and Storage of Aerosol

Products Code.



Endust for Electronics Duster                                       Page Number: 5

257000



Wash hands thoroughly after use.



Store in a cool dry area with ventilation suitable for storing materials

shown in Section II. Keep away from heat, sparks and flame. Keep away from

direct sunlight or any source of ignition. Do not store at temperatures.

above 120ø F.



Other Precautions:

These are the standard hazard statements for non-flammable aerosol consumer

products:

CAUTION! Do not puncture or incinerate container. Do not expose to heat or

store at temperatures above 49øC (120ø F). Keep out of reach of children.



Because of the expected use pattern and previous formulations, these

statements are also important:

Intentional misuse by deliberatly concentrating and inhaling contents may be

fatal. Use in a well-ventilated area. This product is not defined as

flammable by regulations of the Consumer Product Safety Commission, but the

product can be ignited under certain circumstances. Do not use near open

flame, sparking material, or any incandescent material.



NFPA Aerosol Storage Level Code:     1



                      SECTION X - STATE RIGHT TO KNOW INFORMATION



PENNSYLVANIA:     This product contains the following Pennsylvania

                  Right-to Know hazardous substances at concentrations

                  of 1% or greater and special hazardous substances at

                  concentrations of 0.01% or greater: None





               Identity of non-hazardous substances not listed above or

               in Section II is considered to be a trade secret.





                       SECTION XI - SARA TITLE III INFORMATION



SECTION 302:     This product contains the following ingredient(s) regulated

                 under SARA Title III Section 302 Extremely Hazardous

                 Substances List: None



SECTION313:     This product contains the following ingredient(s) regulated

                under SARA Title III Section 313: None



THE INFORMATION AND RECOMMENDATIONS CONTAINED HEREIN ARE BASED UPON DATA

BELIEVED TO BE CORRECT. HOWEVER, NO GUARANTEE OR WARRANTY OF ANY KIND

EXPRESSED OR IMPLIED IS MADE WITH RESPECT TO THE INFORMATION CONTAINED

HEREIN.