Monday, August 15, 2005
Page 1 of 3
MSDS - Material Safety Data Sheet
Product Name: BUG REMOVER WITH WAX
MSDS No.: BUG40
I. Basic Information:
Manufacturer: RADIATOR SPECIALTY COMPANY
0
Address: 600 RADIATOR ROAD
City, ST Zip: INDIAN TRAIL, NC 28079
1 0
Emergency Contact: Rocky Mountain Poision Control Center
Emergency Telephone Number: 303-623-5716
Contact: Robert Geer
Information Telephone Number: 704-688-3430
1
0
Last Update: 08/15/2005
0
X Liquid Gas Solid
Chemical State:
A
Pure Mixture
X
Chemical Type:
II. Ingredients:
Trade Secret
EHS IARC SARA
313 OSHA ACGIH Other
% Range NTP SUB Z PEL TLV Limits
CAS No. Chemical Name
111762 2-Butoxyethanol 3.0 - 7.0 25 ppm 25 ppm
X
1310732 Caustic soda 0.1 - 1.0 2 mg/m3 2 mg/m3 2 mg/m3
mixture Silicone Fluid 3.0 - 7.0
III. Hazardous Identification:
Hazard Category:
X Acute Chronic Fire Pressure Reactive
Hazardous Identification Information:
CAUTION: Eye and Skin Irritant
IV. First Aid Measures:
Route(s) of Entry:
Absorption, Eye, Inhalation, and Ingestion.
Health Hazards (Acute and Chronic):
See signs and symptoms below
Signs and Symptoms:
Eye Contact: Direct spray into eyes may be irritating.
Skin Contact: Prolonged contact may cause irritation due to defatting of skin.
Inhalation: High concentration of vapors may irritate nose and throat and cause headaches and nausea.
Ingestion: Can cause irritation, gastric disturbances, and nausea..
Medical Conditions Generally Aggravated by Exposure:
None Known
Emergency and First Aid Procedures:
Monday, August 15, 2005
Page 2 of 3
MSDS - Material Safety Data Sheet
Product Name: BUG REMOVER WITH WAX
MSDS No.: BUG40
Eye Contact: Flush eyes with water for 15 minutes while lifting upper and lower eyelid. Get prompt medical attention. .
Skin Contact: Wash with soap and water. If irritation persists, get prompt medical attention.
Inhalation: Move to fresh air. If breathing becomes difficult get prompt medical attention.
Ingestion: Drink water or milk. Call Poison Control Center, physician, or hospital emergency room immediately.
Other Health Warnings:
None Known
V. Fire Fighting Measures:
Flash Point: None Lower Explosive Limit: N/D Upper Explosive Limit: N/D
F.P. Method: TCC
Fire Extinguishing Media: Water Fog, Foam, Carbon Dioxide, Dry Chemical
Special Fire Fighting Procedures:
Wear self-contained , positive pressure breathing apparatus and protective clothes.
Unusual Fire and Explosion:
None Known
VI. Accidental Release Measures:
Steps to be Taken in Case Material is Released or Spilled:
Use appropiate protective equipment. Contain spill and then absorb spill with inert material or rags and scoop into a chemical
waste container. Neutralize remaining traces of material and flush with water followed by liberal covering with sodium bicarbonate.
All clean-up material should be removed and placed in approved containers for disposal. Rinse water may be disposed of down a
sanitary sewer system if authorized by the local municipality.
VII. Handling and Storage:
Precautions to be Taken:
Do not take internally. Do not expose to heat or store at temperatures above 120 F. Store above 55掳F.
Other Precautions:
After handling product, always wash hand thoroughly with soap and water before eating and drinking.
VIII. Exposure Controls/Personal Protection:
Ventilation Requirements:
See Section 2 for applicable exposure limits. Use with adequate ventilation. If TLV is exceeded, wear NIOSH approved respirator.
Personal Protective Equipment:
For prolonged exposure wear protective safety glasses, gloves, and apron.
Monday, August 15, 2005
Page 3 of 3
MSDS - Material Safety Data Sheet
Product Name: BUG REMOVER WITH WAX
MSDS No.: BUG40
IX. Physical and Chemical Properties:
Boiling Point: 212 F Melting Point: N/A
Evaporation Rate (Butyl Acetate = 1): < 1 Vapor Pressure (mm Hg.): N/D
Specific Gravity (H20 = 1): 1.00500 Vapor Density (AIR = 1): N/D
Solubility In Water: Soluble Appearance and Odor: Clear solution with mild odor.
Other Information: pH: 11.0 - 11.5
VOC Content: > 5%
X. Stability and Reactivity:
Stability:
Stable
Incompatibility (Materials to Avoid):
Avoid contact with strong oxidizing agents
Decomposition/By Products:
Carbon Monoxide, Carbon Dioxide
Hazardous Polymerization:
Will not occur
XI. Toxicological Information:
N/D
XII. Ecological Information:
N/D
XIII. Disposal Considerations:
DISPOSAL: This container may be recycled in a recycling centers when empty. Before offering for recycling, empty the can or
bottle by using the product according to the label. If recycling is not available, wrap the container and discard in the trash. Dispose
of unused product in accordance with all local, state government and federal laws and regulations
XIV. Transport Information:
DOT Shipping Name: Not DOT Regulated.
DOT Hazard Class: Not DOT Regulated
XV. Regulatory Information:
See Section 2 for SARA Reportable Chemicals.
USA TSCA: All components of this material are either exempt or listed on the US TSCA Inventory.
XVI. Other Information:
Avoid prolonged contact with eyes and skin. KEEP AWAY FROM CHILDREN AND ANIMALS!
N/E: Not Established
N/D: Not Determined
N/A: Not Applicable
N/AV: Not Available
Monday, August 15, 2005
Page 1 of 1
MSDS - Material Safety Data Sheet
Product Name: BUG REMOVER WITH WAX
MSDS No.: BUG40
While Radiator Specialty Company believes this data is accurate as of the revision date, we make no warranty with respect to the
data and we expressly disclaim all liability for reliance thereon. The data is offered soley for information, investigation, and
verification. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or
disposal of this product which may not be covered by this MSDS. The user is repsonsible for full compliance.
|