24 Madison Road, Fairfield, New Jersey 07004, USA
Tel: 800-771-JEEN (5336), Tel: 973-439-1401, Fax: 973-439-1402,
email: info@jeen.com , Website: www.jeen.com
MATERIAL SAFETY DATA SHEET
SECTION I - MATERIAL AND MANUFACTURER IDENTIFICATION
Manufacturer's Name: JEEN International Corp. Chemtrec Emergency Telephone No.: 800-424-9300
24 Madison Road *Chemtrec International Telephone No.: 703-527-3887
Fairfield, NJ 07004 *(Collect Calls Accepted)
Telephone # 973- 439-1401
Chemical Name: LAURAMIDE DEA (and) LINOLEAMIDE DEA
Trade Name: JEEMIDE LMAV
Chemical Family: FATTY ALKANOLAMIDE
CAS#: 120-40-1; 27883-12-1
HMIS HAZARD RATINGS: Health (2) Fire (0) Reactivity (0)
4= EXTREME; 3= HIGH; 2= MODERATE; 1= SLIGHT; 0= INSIGNIFICANT
SECTION II - HAZARDOUS INGREDIENTS
SKIN LD50 ORAL
INGREDIENTS CAS# % ACGIH/TLV MG/KG MG/KG
DIETHANOLAMINE 111-42-2 8.4 3 PPM 12000 710-1820
NE= NOT ESTABLISHED; NL= NOT LISTED; C= IDENTIFIED AS A CARCINOGEN BY OSHA, IARC, OR NTP
SECTION III - PHYSICAL DATA
365oF
BOILING POINT:
MELTING POINT: NA
VAPOR PRESSURE (mm.Hg): NV
VAPOR DENSITY (AIR=1): NV
SPECIFIC GRAVITY (H2O): 0.98 @ 25C
PERCENT VOLATILE BY WEIGHT: NV
EVAPORATION RATE: NV
SOLUBILITY IN WATER: DISPERSIBLE
APPEARANCE/ODOR: AMBER LIQUID; MILD FATTY ODOR
NA= NOT APPLICABLE; NV= NOT VOLATILE; ND= NOT DETERMINED
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
GREATER THAN 200oF (PENSKY MARTENS CC)
FLASH POINT:
LOWER EXPLOSIVE LIMIT: ND
UPPER EXPLOSIVE LIMIT ND
EXTINGUISHING MEDIA: DRY CHEMICAL, CARBON DIOXIDE, BC/ABC EXTINGUISHERS
SPECIAL FIREFIGHTING PROCEDURES: NONE
UNUSUAL FIRE AND EXPLOSION HAZARDS: NONE
SECTION V - HEALTH HAZARD DATA
PERMISSIBLE EXPOSURE LEVEL: SEE SECTION II FOR HAZARDOUS INGEDIENTS PRESENT IN THIS PRODUCT AND
THEIR CORRESPONDING TLV'S.
EFFECTS OF OVEREXPOSURE:
EYES: CONTACT CAN CAUSE SEVERE IRRITATION, REDNESS, BLURRED VISION,
SEVERE OR PERMANENT DAMAGE.
SKIN: PROLONGED CONTACT CAN CAUSE SEVERE IRRITATION. MIST MAY IRRITATE
MUCOUS MEMBRANES.
TOXICITY DATA:
ORAL TOXICITY LD(50): ND
EYE IRRITATION: ND
DERMAL IRRITATION: ND
FIRST AID PROCEDURES:
EYES CONTACT: FLUSH IMMEDIATELY WITH COPIOUS AMOUNTS OF WATER. CONTINUE FLUSHING FOR AT
LEAST 15 MINUTES. CONSULT A PHYSICIAN.
SKIN IRRITATION: IMMEDIATELY FLUSH WITH COPIOUS AMOUNTS OF SOAP AND WATER FOR 5 MINUTES. IF
IRRITATION PERSISTS, CONTACT PHYSICIAN. LAUNDER CONTAMINATED CLOTHING BEFORE
RE-USE.
INGESTION: CONTACT A PHYSICIAN IMMEDIATELY.
INHALATION: REMOVE TO FRESH AIR. IF NECESSARY, GIVE OXYGEN. ARTIFICIAL RESPIRATION. CONTACT
PHYSICIAN.
Page No. 1 of 2 - MSDS - JEEMIDE LMAV
24 Madison Road, Fairfield, New Jersey 07004, USA
Tel: 800-771-JEEN (5336), Tel: 973-439-1401, Fax: 973-439-1402,
email: info@jeen.com , Website: www.jeen.com
Page No. 2 of 2 - MSDS - JEEMIDE LMAV
SECTION VI - REACTIVITY DATA
CHEMICAL STABILITY: STABLE
CONDITIONS TO AVOID: EXTREMELY HIGH TEMPERATURES
ICOMPATIBILE MATERIALS: STRONG OXIDIZING AGENTS
HAZARDOUS DECOMPOSITION PRODUCTS: NITROUS OXIDES AND AMMONIACAL VAPORS
HAZARDOUS POLYMERIZATION: WILL NOT OCCUR
SECTION VII - SPILL OR LEAK PROCEDURES
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
FOR LARGE SPILLS: SOAK UP WITH SAND OR SWEEPING COMPOUND AND DISPOSE AS SOLID WASTE.
FOR SMALL SPILLS: FLUSH TO INDUSTRIAL SEWER.
WASTE DISPOSAL METHOD:
IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS.
SECTION VIII- CONTROL MEASURES
RESPIRATORY PROTECTION: NOT REQUIRED.
EYE PROTECTION: CHEMICAL GOGGLES.
PROTECTIVE GLOVES: IMPERVIOUS.
VENTILATION: NOT REQUIRED - MISTING OPERATIONS MAY REQUIRE ADEQUATE VENTILATION.
OTHER PROTECTIVE EQUIPMENT: WEAR PROTECTIVE CLOTHING TO PREVENT SKIN CONTACT.
SECTION IX - SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: KEEP CONTAINER CLOSED WHEN NOT IN USE.
OTHER PRECAUTIONS: SPILLED MATERIAL IS QUITE SLIPPERY.
SECTION IX - SPECIAL PRECAUTIONS
DOT PROPER SHIPPING NAME: LIQUID SOAP
DOT CLASSIFICATION: NONE
UN/NA NUMBER: NONE
LABEL: NONE
SECTION X - REGULATORY INFORMATION
TSCA: LISTED IN TSCA INVENTORY SARA TITLE III: DIETHANOLAMINE
CALIFORNIA PROP. 65: NONE DETECTABLE
CTFA DESIGNATION: LAURAMIDE DEA & LINOLEAMIDE DEA
All suggestions and data in this bulletin are based on information we believe to be reliable. They are offered in good faith. However, no guarantee is
made or implied as conditions and methods of use of our products are beyond our control. We recommend that the prospective user determine the
suitability of our materials and suggestions on an experimental basis before adopting them on a commercial scale. Statements as to the use of our
products are not to be construed as recommendations for their use in the infringement of any patents.
|