24 Madison Road, Fairfield, New Jersey 07004, USA
Tel: 800-771-JEEN (5336), Tel: 973-439-1401, Fax: 973-439-1402,
email: info@jeen.com , Website: www.jeen.com
MATERIAL SAFETY DATA SHEET
Section 1 鈥? Company and Product Identification
Issued by: JEEN International Corporation Chemtrec Emergency Tel.# 800-424-9300
24 Madison Road *Chemtrec International Tel.# 703-527-3887
Fairfield, New Jersey 07004 *Collect Calls Accepted
Tel#: 973-439-1401
Issuance Date: November 30, 2001
Product Trade Name: JEESILC 6056 Revision Date: July 23, 2003
Chemical Name: Polydimethylsiloxane, Water, Dimethyl siloxane,hydroxy-terminated,Polyethylene Oxide Lauryl Ether.
INCI: Dimethicone (and) Dimethiconol (and) Laureth 4 (and ) Laureth-23
Chemical Family: Silicone Emulsion
CAS Number: 63148-62-9, 7732-18-5, 70131-67-8, 9002-92-0
Description: Water dispersible emulsion of DC2-1068 Gum
Health (NFPA): 2 Flammability (NFPA): 1 Reactivity (NFPA): 0
Section 2 鈥? Hazardous Ingredients
This material contains no ingredients which are known to JEEN International Corp. to be hazardous unless listed below.
CAS Number Ingredients Wt% Exposure Limits
9002-92-0 POE Lauryl Ether 5-10% None Established
Comments: The above components are hazardous as defined in 29 CFR 1910.1200.
Section 3 鈥? Physical Data
Boiling Point, 掳F: 212 Volatile, % by Weight: 34
Solubility in Water (%): Dispersible Appearance @ 25掳C: Liquid
Specific Gravity @ 25掳C: 0.985 Odor: Very little odor.
Vapor Pressure, mm Hg 25 掳C: 24 Flash Point, COC, 掳F: None
Vapor Density, (Air=1): Moist Air
Section 4 鈥? Fire and Explosion Hazard Data
Flash Point: PMCC 300 掳F Flammable Limits in Air, % by Volume: Unknown
Lower: Undetermined Upper: Undetermined
Extinguishing Media: Use Carbon Dioxide or Dry chemical on small fires. Use foam (alcohol, polymer or
ordinary) and water spray for large fires.
Special Fire Fighting Procedures: Self-contained breathing apparatus and protective clothing should be worn in
fighting fires involving chemicals.
Unusual Fire and Explosion Hazards: Static electricity is not expected to build up, and product is not sensitive to static.
Section 5 鈥? Health Hazard Data
Threshold Limit Value: See Hazardous Ingredients Section.
Effects of overexposure: Contact with skin or eyes may cause temporary irritation. Inhalation for short exposures of less
than 8 hours should not cause injury. Oral contact from the fingers to the mouth should not injure.
Swallowing large amounts may cause digestive discomfort.
Emergency and First
Aid Procedures: Flush eyes with copious amounts of water for a minimum of 15 minutes. Wash contacted skin areas
with soap and water. If irritation develops, consult a physician. Soaked clothing should be
changed.
Section 6 鈥? Reactivity Data
Stability: Stable [X] Unstable [ ]
Incompatibilities (Materials to Avoid): Strong oxidizing material can cause a reaction.
Hazardous Decomposition Products: Silicon dioxide, carbon oxides trace amounts of formaldehyde may form when
heated above 300掳F.
Hazardous Polymerization: May occur [ ] Will not occur [X]
Conditions to Avoid: See above statements.
Page No. 1 of 3 鈥? MSDS 鈥? JEESILC 6056
24 Madison Road, Fairfield, New Jersey 07004, USA
Tel: 800-771-JEEN (5336), Tel: 973-439-1401, Fax: 973-439-1402,
email: info@jeen.com , Website: www.jeen.com
MATERIAL SAFETY DATA SHEET
Page No. 2 of 3 鈥? MSDS 鈥? JEESILC 6056
Section 7 鈥? Spill, Leak and Disposal Procedures
Action to take for spills: (Use appropriate Safety Equipment) Use absorbent material to collect and contain for disposal.
Contain large spills and pump into a suitable tank. Wash area with suitable detergent and thoroughly rinse.
Disposal Method: All Local, State and Federal Regulations concerning health and pollution should be reviewed to determine
approved disposal procedures.
Section 8 鈥? Special Handling Information
Ventilation:
1. Local Exhaust: None should be needed.
2. Mechanical (general): Recommended.
3. Respiratory Protection (type): Canister for organic vapors (i.e. type GMA from Mine Safety Appliance Co.).
4. Protective Clothing: Clean, body-covering clothing.
5. Eye Protection: Safety glasses
6. Other Protective Equipment: Eye Fountain and Safety Shower in work area.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE:
Keep container closed and stored away from heat, sparks and open flame.
Section 9 - Transport Information
Proper Shipping Name: None
Hazard Technical Name: NA
Hazard Class: NA
UN/NA Number: 0000
Packing Group: NA
EPA SARA Title III Chemical Listings:
Section 302 Extremely Hazardous Substances: None
Section 304 CERCLA Hazardous Substances: None
Section 312 Hazard Class: Acute: YES Chronic: YES Fire: NO Pressure: NO
Reactive: NO
Supplemental State Compliance Information
CAS# COMPONENT
NEW JERSEY: 63148-62-9 Polydimethylsiloxane
7732-18-5 Water
70131-67-8 Dimethyl siloxane, hydroxy-terminated
9002-92-0 Polyethylene oxide lauryl ether
PENNSYLVANIA: 63148-62-9 Polydimethylsiloxane
7732-18-6 Water
70131-67-8 Dimethyl siloxane, hydroxy-terminated
9002-92-0 Polyethylene oxide lauryl ether
Trace Formaldehyde
CALIFORNIA: 63148-62-9 Polydimethylsiloxane
7732-18-7 Water
70131-67-8 Dimethyl siloxane, hydroxy-terminated
9002-93-0 Polyethylene oxide lauryl ether
Trace Formaldehyde
24 Madison Road, Fairfield, New Jersey 07004, USA
Tel: 800-771-JEEN (5336), Tel: 973-439-1401, Fax: 973-439-1402,
email: info@jeen.com , Website: www.jeen.com
Page No. 3 of 3 鈥? MSDS 鈥? JEESILC 6056
Section 9 - Transport Information Continued鈥?..
Supplemental State Compliance Information Continued鈥︹??.
MASSACHUSETTS: 63148-62-9 Polydimethylsiloxane
7732-18-8 Water
70131-67-8 Dimethyl siloxane, hydroxy-terminated
9002-94-0 Polyethylene oxide lauryl ether
Trace Formaldehyde
Section 313 Toxic Chemicals: None present or none present in regulated quantities.
Contents of this MSDS comply with OSHA Hazard Communication Standard 29CFR 1910.1200
TSCA Status: One or more of the components in this product may not be listed on the Toxic Substances Control Act inventory of
chemical substances. Therefore, this product may only be used for purposes not subject to TSCA.
These data are offered in good faith as typical values and not as a Product Specifications. No warranty, either expressed or implied, is hereby made. The recommended
industrial hygiene and safe handling procedures are believed to be generally applicable; however, each user should review these recommendations in the specific context of
intended use and determine whether they are appropriate.
|