KLEEN-FLO TUMBLER INDUSTRIES LIMITED MATERIAL SAFETY DATA SHEET PAGE 1
SECTION I-MATERIAL IDENTIFICATION AND USE
Material Name/Identifier: INJECTOR KLEEN Stock No. 695
Manufacturer's Name: Street Address: 75 Advance Blvd.
Kleen-Flo Tumbler Industries Ltd
City: Brampton Province: Ontario
Postal Code: L6T 4N1 Emergency Phone #: (905) 793-4311
Chemical Name: N/A (mixture) Chemical Family: N/A (mixture)
Chemical Formula: N/A (mixture) Trade Names & Synonyms: None
Material Use: Cleaner Molecular Weight: N/A (mixture)
SECTION II-HAZARDOUS INGREDIENTS OF MATERIAL
Hazardous Approximate LD50 LC50
Ingredients C.A.S. Concentration Species & Route Species & Route
64742-88-7 1-5% N/A N/A
Aliphatic Naphtha
Stoddard solvent 8052-41-3 70-90% 8ml/kg rat-oral >1400 ppm (4hr)rat-Inh
N/A balance This material is not known to contain any chemical listed as
Organic detergent/dispersant
carcinogen by the U.S. OSHA, IRAC or the U.S. National
Toxicology Program (NTP) at a concentration > 0.1%.
SECTION III-PHYSICAL DATA FOR MATERIAL
Physical State: Liquid Odour/Appearance: Strong odour /Clear, red liquid
Specific Gravity: 0.80 Odour Threshold(p.p.m.): 100 ppm TWA
Boiling Point: 160潞C Evaporation Rate: N/E
Freezing Point: < 0潞C Solubility in Water: Insoluble
% Volatile(by volume): 70-90% Vapour Pressure(mm)Hg: 7.0
Vapour Density(Air=1): 4.8 Coefficient of Water/Oil Distribut: N/E
pH N/A
SECTION IV-FIRE AND EXPLOSION HAZARD OF MATERIAL
Flammability Yes/No No If yes under which conditions: Combustible liquid
Auto Ignition Temperature: Means of Extinction: Carbon dioxide, Foam, Water Fog, Dry Chemical
Flashpoint and Method: 39潞C Hazardous Combustion Products: N/E
Tag C.C.
Upper Flammable limit Lower Flammable Limit (% by volume):e): 1.0
1.0
(% by volume): 6.0
Explosion Data: Sensitivity to mechanical impact: N/E Sensitivity to Static Discharge: N/E
SECTION V-REACTIVITY DATA
Chemical Stability Yes/No: Yes If NO under which conditions?: N/E
Incompatibility to Other Substances Yes/No: Yes If so which ones? Strong oxidizing materials
Reactivity and under what conditions? Avoid spark, open flames and other sources of ignition
Hazardous Decomposition Products: Carbon monoxide, carbon dioxide and nitrogen produced on combustion
N/E: not established N/A: Not applicable N. A.: not available
Material Name/Identifier: INJECTOR KLEEN Stock No. 695 PAGE 2
SECTION VI-TOXICOLOGICAL PROPERTIES OF PRODUCT
Route of Entry: All routes --SKIN CONTACT --SKIN ABSORPTION --EYE CONTACT --INHALATION --INGESTION
Effects of Acute Exposure: Moderately irritating to skin and eyes, repeated or prolonged contact can cause dermatitis.
Small amounts of liquid aspirated into the respiratory systems during ingestion
systems during ingestion or from vomiting may
n or from vomitng may
cause mild to pulmonary injury and possibly death.
Effects of chronic exposure: None known
LD 50 of Product: N/E LC 50 of Product: N/E
Irritancy of Product: Mild eye irritant Exposure Limits of Product: N/E
Sensitization of Product: N/E Toxicologically Synergistic Materials: N/E
--CARCINOGENICITY --REPRODUCTIVE EFFECTS --TERATOGENICITY --MUTAGENICITY none known
SECTION VII-PREVENTIVE MEASURES
Personal Protective Equipment to be used:
Gloves(specify): Impervious rubber Eye (specify): Chemical safety goggles
Respiratory(specify): Organic canister Clothing: Not required
Respiratory Protection: If used indoors or on a continuous basis, use of cartridge type respirator is recommended
Engineering Controls: Local exhaust ventillation
Leak and Spill Procedure: Eliminate all sources of ignition. Flush with water to an open, well ventillated area. Wear
adequate respiratory protection. Absorb with absorbent materials. Remove to container.
Waste Disposal: Landfilled or re-incinerated
Storage Requirements: Store in a cool, well ventillated area. Avoid sources of ignition and excessive heat.
Handling Procedures and No special steps are needed.
Equipment:
TDG Classification: Consumer commodity
WHMIS Classification: Consumer commodity
SECTION VIII-FIRST AID MEASURES
Eye: Flush eyes with water for at least 15 minutes. If irritation persists, week medical help.
Skin: Wash contaminated skin with mild soap and water.
Inhalation: Remove victim to fresh air and restore breathing if required.
Ingestion: Do NOT induce vomiting. Get medical help immediately.
SECTION IX-PREPARATION DATE OF M.S.D.S.
Additional Info/Comments: Sources Used:
Phone Number: (905) 793-4311 Prepared By: Quality Control Laboratory
Date: March 3, 2003 Kleen-Flo Tumbler Industries Limited
THIS SHEET SUPERSEDES ANY OTHER M.S.D.S. PREVIOUSLY PREPARED
N/A: not available N/E: not established
|